ALBERT

Description: The floor of Lake Pannon covering the Pannonian Basin in the Late Miocene had considerable relief, including both deep sub-basins, like the Drava Basin, and basement highs, like the Mecsek Mts, in close proximity. The several km thick lacustrine succession in the Drava Basin includes profundal marls, basin-center turbidites, overlain by shales of basin-margin slopes, coarsening-upward deltaic successions and alluvial deposits. Along the margin of the Mecsek Mts locally derived shoreface sands and deltaic deposits from further away have been mapped so far on the surface. Recent field studies at the transition between the two areas revealed a succession that does not fit into either of these environments. A series of sandstone a few meters thick occurs above laminated to bioturbated clayey siltstone. The sandstone show normal grading, plane lamination, flat erosional surfaces, soft-sediment deformations (load and water-escape structures) and sharp-based beds with small reverse faults and folds. These indicate rapid deposition from turbidity currents and their deformation as slumps on an inclined surface. These beds are far too thick and may reveal much larger volumes of mass wasting than is expected on the 20–30 m high delta slopes; however, regional seismic lines also exclude outcropping of deep-basin turbidites. We suggest that slopes with transitional size (less than 100 m high) may have developed on the flank of the Mecsek as a consequence of lake-level rise. Although these slopes were smaller than the usually several hundred meter high clinoforms in the deep basins, they could still provide large enough inertia for gravity flows. This interpretation is supported by the occurrence of sublittoral mollusc assemblages in the vicinity, indicating several tens of meters of water depth. Fossils suggest that sedimentation in this area started about 8 Ma ago.

Description: Bondoró Volcanic Complex (shortly Bondoró) is one of the most complex eruption centre of Bakony-Balaton Highland Volcanic Field, which made up from basaltic pyroclastics sequences, a capping confined lava field (~4 km2) and an additional scoria cone. Here we document and describe the main evolutional phases of the Bondoró on the basis of facies analysis, drill core descriptions and geomorphic studies and provide a general model for this complex monogenetic volcano. Based on the distinguished 13 individual volcanic facies, we infer that the eruption history of Bondoró contained several stages including initial phreatomagmatic eruptions, Strombolian-type scoria cones forming as well as effusive phases. The existing and newly obtained K-Ar radiometric data have confirmed that the entire formation of the Bondoró volcano finished at about 2.3 Ma ago, and the time of its onset cannot be older than 3.8 Ma. Still K-Ar ages on neighbouring formations (e.g. Kab-hegy, Agár-teto) do not exclude a long-lasting eruptive period with multiple eruptions and potential rejuvenation of volcanic activity in the same place indicating stable melt production beneath this location. The prolonged volcanic activity and the complex volcanic facies architecture of Bondoró suggest that this volcano is a polycyclic volcano, composed of at least two monogenetic volcanoes formed more or less in the same place, each erupted through distinct, but short lived eruption episodes. The total estimated eruption volume, the volcanic facies characteristics and geomorphology also suggests that Bondoró is rather a small-volume polycyclic basaltic volcano than a polygenetic one and can be interpreted as a nested monogenetic volcanic complex with multiple eruption episodes. It seems that Bondoró is rather a “rule” than an “exception” in regard of its polycyclic nature not only among the volcanoes of the Bakony-Balaton Highland Volcanic Field but also in the Neogene basaltic volcanoes of the Pannonian Basin.