ALBERT

Notes: Abstract The North Shore Volcanic Group in northern Minnesota is part of the Middle Proterozoic Keweenawan sequence, one of the largest plateau lava provinces in the world. The primary geochemistry of the basalts suggests that volcanism occurred in an intracontinental rift environment. The subaerial lava flows, mainly amygdaloidal olivine tholeiites and tholeiites, have undergone low-grade metamorphism from zeolite to lower greenschist facies. On the basis of alteration phases replacing the primary magmatic minerals, infilling amygdales and veins, and replacing secondary minerals, the following zones have been distinguished: (1) thomsonite-scolecite-smectite, (2) heulandite-stilbite-smectite, (3) laumontitechlorite-albite, (4) laumontite-chlorite-albite ± prehnite ± pumpellyite and (5) epidote-chlorite-albite ± actinolite zone.In addition to the overall zonation based on mineral parageneses, zonations in the composition of the Ab content of the newly formed albite replacing primary Ca-rich plagioclase and of the newly formed mafic phyllosilicates are observed within the sequence and within single flows. Mafic phyllosilicates in the upper part of the sequence (mainly smectites and mixed-layer smectite/chlorites) display high Si and Ca + Na + K contents, whereas in the lower part of the sequence the amounts of Si and Ca + Na + K are markedly lower (mainly chlorites and mixed-layer chlorite/smectites). Similar zonations are observed within the individual flows. The albite content of the newly formed plagioclase is highest, and the Si and Ca + Na + K content of the phyllosilicates lowest in the amygdaloidal flow top while the opposite is true for the massive flow interior.The above features suggest that the overall pattern is one of burial-type metamorphism associated with extension in the rift setting. In detail, the mineral assemblages are controlled not only by the stratigraphic position but also by the flow morphology controlling permeability whose effect on the assemblages is most pronounced in the stratigraphically upper parts. This suggests that at the first stages of alteration (lowest grade) the patterns of fluid flow were important effects in controlling the assemblages. At greater burial depth, assemblages are more homogeneous, perhaps representative of a more even and pervasive flow pattern.Using the observed assemblages at face value to define grade and/or facies, different conditions would be assigned within the different morphological flow portions. Thus at low-grade metamorphic conditions it is essential to integrate assemblages from different morphological flow portions in order to define satisfactorily the overall metamorphic conditions.

Notes: Abstract. Assuming that other sources of error can be neglected, the reliability of a land suitability classification depends on the homogeneity of physiographically delineated map units with regard to land qualities. The map unit homogeneity of a small area in France was estimated using 64 observation points, arranged according to a nested sampling scheme, followed by nested analysis of variance.The analysis shows that in this area map units are too heterogeneous to accept the suitability classification as being completely reliable. However, alternative procedures using methods of optimal interpolation to map gradual change within the physiographic units are too expensive at a mapping scale of 1:25000 or smaller. It is not possible to produce completely accurate suitability maps at smaller scales. However, incorporating nested sampling and analysis of variance as standard procedures in land evaluation surveys costs little effort and yields at least an estimate of map accuracy and reliability of the suitability classification.

Notes: This paper reports on a study designed to improve the information on income flows and income distribution in the Netherlands national accounts by building a bridge between the national accounts and income tax statistics. The methods used are described in some detail, and the significance of the results obtained is discussed. The figures show rather substantial fluctuations in the share of proprietors relative to that of wage earners. This result is not unexpected, since the share of proprietors is much more sensitive to the level of economic activity, but it does limit the usefulness of the figures for short-run economic policy determination. In the longer run, however, they do show what the development of the average incomes of the various social groups has been, and to what extent government action has contributed to that development.

Notes: In the western coal-mining area of Ruhrkohle AG, reflection seismic prospecting for the Carboniferous coal measures is severely impaired by structures with halokinetic features. These structures make the interface between Mesozoic and Paleozoic layers, i.e., the top of Zechstein in general, very rugged. Unfortunately the velocity contrast at this interface is very high in that area, the ratio of velocities being 1.5 to 2.0. Therefore, migration and stacking become a problem.Three types of migration are presented:〈list xml:id="l1" style="custom"〉1(f, x)-time-migration with vertical time-to-depth conversion as a second step.2Kirchhoff migration down to a level determined approximately by the highest points of the top of Paleozoics, i.e., 0.35 s, and Kirchhoff-downward continuation for all times exceeding 0.35 s. Intermediate static corrections for these latter times with subsequent (f, k)-time-migration and final vertical time-to-depth conversion.3Direct depth migration in the (f, x)-domain using three interval velocities.In all cases an intermediate picking of the velocity interfaces is necessary. In case 2 this occurs at an earlier stage of the process than in case 1, and in case 3 at a still earlier stage.The results of the second and third migration procedures are superior to those of the first. Possibilities for misinterpretation of faults are reduced considerably when the second or third migration procedure is applied.

Notes: For horizontal layering and plane horizontal impulsive wavefronts it is theoretically possible to get rid of multiple reflections by a feedback procedure which can easily be derived using raypath philosophy. To reduce the increase of noise inherent in the method the precise theoretical formulae are altered in such a manner that a practical application becomes possible. For this purpose the autocorrelation will be used.Application of the new process to a CRP section where the shot geophone distances in the field had not been long enough to attenuate multiple reflections effectively gave favourable results.

Notes: It is well known that interval velocities can be determined from common-reflection-point moveout times. However, the mathematics becomes complicated in the general case of n homogeneous layers with curved interfaces dipping in three dimensions.In this paper the problem is solved by mathematical induction using the second power terms only of the Taylor series which represents the moveout time as a function of the coordinate differences between shot and geophone points. Moreover, the zero-offset reflection times of the nth interface in a certain area surrounding the point of interest have to be known. The n—I upper interfaces and interval velocities are known too on account of the mathematical induction method applied. Thus, the zero-offset reflection raypath of the nth interface can be supposed to be known down to the intersection with the (n—1)th interface.The method applied consists mainly in transforming the second power terms of the moveout time from one interface to the next one. This is accomplished by matrix algebra.Some special cases are discussed as e.g. uniform strike and small curvatures.

Notes: Despite the use of CDP and digital methods the Zechstein base is still the deepest horizon in the vast salt-dome basin of Central Europe for which continuous information can be obtained by reflection seismics. Thus in North-western Germany, in addition to reflection seismics, the refraction seismic method has been increasingly used for a reliable survey of deeper horizons.The first part of the paper deals with the investigation of the various possibilities and limitations of refraction seismics with regard to the investigation of Pre-Zechstein layers in a basin with a tectonically very complicated overburden. The recording techniques specially developed for continuous profiling of the desired refraction seismic arrivals and the data processing methods are described.The main problems of interpretation are then discussed, in particular with regard to depth representation. The advantages and disadvantages of the various methods, e.g. Gardner's, Hales' and Wyrobek's, and of the wave-front method, are compared. On account of the tectonically complicated overburden Thornburgh's wave-front method proved to be the most useful.In a further section the various possibilities for velocity determinations are mentioned, e.g. Wyrobek's determination of the overburden velocity, for which the wave-front method automatically furnishes the necessary corrections to a deep datum.Finally, some examples are given for the results obtained, including some incidental information on the deeper crust.