ISSN:
0003-3146
Keywords:
Chemistry
;
Polymer and Materials Science
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Chemistry and Pharmacology
,
Physics
Description / Table of Contents:
The copolymerization of butadiene and ethene in the presence of the catalyst dineopentyloxyvanadiumoxychloride/triisobutylaluminum was investigated. Basic reaction parameters, such as the [A1]/[V] ratio, the composition of monomer mixture and the polymerization temperature result in a significant influence on the progress of reaction, the conversion of monomers and on the molecular weight and polydispersity of copolymers obtained. NMR measurements demonstrate a high degree of alternation.A maximum of conversion and molecular weight was found by variation of the ratio of catalyst components at [A1]/[V] ≍ 7. An increase of ethene content in the monomer mixture also results in a maximum of conversion but, in contrast, in a continuous decrease in molecular weight. The increase of polymerization temperature from -25°C up to +40°C results in different effects on the yield of copolymers and appropriate data of molecular weight. The microstructure of products with a high content of trans-butadiene units exhibits an increase of 1,2-addition of butadiene and the beginning of crosslinking reactions at temperatures above 20°C.
Notes:
Es wurde die Copolymerissation von Butadien und Ethen in Gegenwart des katalysatorsystems Dineopetyloxyvanadiumoxychlorid/Aluminiumtriisobutyl untersucht. Die Variation der grundlegenden Reaktionsparameter [A1]/[V]-Verhältnis, Zusammensetzung der Monomermischug und Polymerisationstemperature ergab einen signifikanten Einfluß auf den Verlauf der Reaction, den Umsatz der Moomeren die, Molmasse und die Polydispersität der erhaltenen Copolymeren. NMR-Untersuchngen belegen einen hohen Alternierungsgrad.Bei der Variation des Verhaltnisses der Katalysatorkomponenten wurde ein Maximum für Umsatz und die Molmasse bei einem Verhältnis [A1]/[V] ≍ 7 ermittelt. Die Erhöhung des Ethengehaltes in der Moomermischung führt ebenfalls zu einer Erhöhung des Umsatzes. Dabei werden die Molmassen jedoch erniedrigt. Die Variation der Polymerisationstemparatur im Bereich von -25°C bis +40°C ergab für den Umsatz und die Molmasse Abhängigkeiten mit Minimum bzw. Maximum. Bei Polymerisationstemperaturen oberhalb +20°C ist ein Anwachsen der 1,2 -Addition des Butadiens und eine zunehmende Vernetzung der Produkte zu verzeichnen.
Additional Material:
7 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/apmc.1992.051960103
Permalink