ALBERT

Description: The Mead Stream section (South Island, New Zealand) consists of a 650-m-thick series of continuous, well-exposed strata deposited on a South Pacific continental slope from the Late Cretaceous to the middle Eocene. We examined the uppermost Paleocene–middle Eocene part of the section, which consists of ~360 m of limestone and marl, for detailed magnetic polarity stratigraphy and calcareous nannofossil and foraminifera biostratigraphy. Magneto-biostratigraphic data indicate that the section straddles magnetic polarity chrons from C24r to C18n, calcareous nannofossil zones from NP9a to NP17 (CNP11–CNE15, following a recently revised Paleogene zonation), and from the Waipawan to the Bortonian New Zealand stages (i.e., from the base of the Ypresian to the Bartonian international stages). The Mead Stream section thus encompasses 17 m.y. (56–39 Ma) of southwest Pacific Ocean history. The ages of calcareous nannofossil biohorizons are consistent with low- to midlatitude data from the literature, indicating that during the early–middle Eocene, the low- to midlatitude calcareous nannofossil domain extended at least to ~50°S–55°S in the South Pacific. Correlation of the magnetic polarity stratigraphy from the Mead Stream section with the geomagnetic polarity time scale allows us to derive sediment accumulation rates (SAR), which range between 8 and 44 m/m.y. Comparing the SAR with paleotemperature proxy records, we found that two intervals of increased SAR occurred during the early Eocene climatic optimum (52–50 Ma) and during the transient warming event peaking with the middle Eocene climatic optimum (40.5 Ma). This correlation indicates that, at Mead Stream, the climate evolution of the early–middle Eocene is recorded in a sedimentation pattern whereby, on a million-year time scale, warmer climate promoted continental weathering, transportation, and accumulation of terrigenous sediments.

Description: The porosity and permeability of sandstone and carbonate reservoirs (known as reservoir quality) are essential inputs for successful oil and gas resource exploration and exploitation. This chapter introduces basic concepts, analytical and modelling techniques and some of the key controversies to be discussed in 20 research papers that were initially presented at a Geological Society conference in 2014 titled ‘Reservoir Quality of Clastic and Carbonate Rocks: Analysis, Modelling and Prediction’. Reservoir quality in both sandstones and carbonates is studied using a wide range of techniques: log analysis and petrophysical core analysis, core description, routine petrographic tools and, ideally, less routine techniques such as stable isotope analysis, fluid inclusion analysis and other geochemical approaches. Sandstone and carbonate reservoirs both benefit from the study of modern analogues to constrain the primary character of sediment before they become a hydrocarbon reservoir. Prediction of sandstone and carbonate reservoir properties also benefits from running constrained experiments to simulate diagenetic processes during burial, compaction and heating. There are many common controls on sandstone and carbonate reservoir quality, including environment of deposition, rate of deposition and rate and magnitude of sea-level change, and many eogenetic processes. Compactional and mesogenetic processes tend to affect sandstone and carbonate somewhat differently but are both influenced by rate of burial, and the thermal and pressure history of a basin. Key differences in sandstone and carbonate reservoir quality include the specific influence of stratigraphic age on seawater composition (calcite v. aragonite oceans), the greater role of compaction in sandstones and the greater reactivity and geochemical openness of carbonate systems. Some of the key controversies in sandstone and carbonate reservoir quality focus on the role of petroleum emplacement on diagenesis and porosity loss, the role of effective stress in chemical compaction (pressure solution) and the degree of geochemical openness of reservoirs during diagenesis and cementation. This collection of papers contains case study-based examples of sandstone and carbonate reservoir quality prediction as well as modern analogue, outcrop analogue, modelling and advanced analytical approaches.

Description: There are numerous examples of fault-controlled, so-called hydrothermal dolomite (HTD), many of which host economic mineral deposits or hydrocarbons, but there remains a lack of consensus as to how they form. In particular, multiple phases of diagenetic overprinting can obscure geochemical fingerprints. Study of a Cenozoic succession with a relatively simple burial history here provides new insights into the development of differentially dolomitized beds. The Hammam Faraun fault (HFF) block within the Suez Rift, Egypt, hosts both massive and stratabound dolostone bodies. Non-fabric-selective massive dolostone is limited to the damage zone of the fault, while fabric-selective stratabound dolostone bodies penetrate nearly 2 km into the footwall. Oligo-Miocene seawater is interpreted to have been drawn down discrete faults into a deep aquifer and convected upwards along the HFF. Escape of fluids from the incipient HFF into the lower Thebes Formation led to differential, stratabound dolomitization. Once the HFF breached the surface, fluid circulation focused along the fault plane to form younger, massive dolostone bodies. This study provides a snapshot of dolomitization during the earliest phases of extension, unobscured by subsequent recrystallization and geochemical modification. Contrary to many models, stratabound dolomitization preceded non-stratabound dolomitization. Fluids were hydrothermal, but with little evidence for rapid cooling and brecciation common to many HTD bodies. These results suggest that many of the features used to interpret and predict the geometry of HTD in the subsurface form during later phases of structural deformation, perhaps overprinting less structurally complex dolomite bodies.

Description: Eocene onset of subduction in the western Pacific was accompanied by a global reorganization of tectonic plates and a change in Pacific plate motion relative to hotspots during the period 52–43 Ma. We present seismic-reflection and rock sample data from the Tasman Sea that demonstrate that there was a period of widespread Eocene continental and oceanic compressional plate failure after 53–48 Ma that lasted until at least 37–34 Ma. We call this the Tectonic Event of the Cenozoic in the Tasman Area (TECTA). Its compressional nature is different from coeval tensile stresses and back-arc opening after 50 Ma in the Izu-Bonin-Mariana region. Our observations imply that spatial and temporal patterns of stress evolution during western Pacific Eocene subduction initiation were more varied than previously recognized. The evolving Eocene geometry of plates and boundaries played an important role in determining regional differences in stress state.

Description: This paper reports the discovery of extensive middle Eocene bryozoan reef complexes along the paleoshelf edge of the Great Australian Bight (GAB). The complexes form the earliest carbonate deposit in the GAB, which is the largest Cenozoic cool-water carbonate province on Earth. The bryozoan reef mounds, previously misidentified as volcanic bodies, were deposited parallel to the shelf margin for more than 500 km along strike. Individual reef mound complexes are 60–150 km long, as wide as 15 km, and as thick as 200 m, and dwarf all previously described examples. Superimposed on the distal margin of an underlying Paleocene to mid-Eocene siliciclastic delta complex, the reef mounds provide a critical insight into changing paleoenvironments of the Australo-Antarctic Gulf ca. 43 Ma, coinciding with global and continent-wide climatic and tectonic events. The rapid growth and demise of reef mound–building bryozoans raises new questions regarding the interplay of Southern Ocean opening, ocean currents, and biosphere interactions.