ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    Journal of Polymer Science 58 (1962), S. 1089-1106 
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The specific heats of isotactic and atactic polypropylene have been measured over the ranges -14 to +211°C. and -55 to +204°C., respectively. In both cases, the samples were annealed at about 140°C. and the measurements repeated, but a slight thermal degradation prevented the results from the second heating from having additional significance. Isotactic polypropylene shows no glass transition in the range studied; the only transition observed is the melting transition. From the enthalpy - temperature curve for a measured fraction of crystallinity of 0.60, the heat of fusion of completely crystalline isotactic polypropylene was calculated to be 35 cal./g. This value is intermediate between previously published values of 15 and 62 cal./g. and in fair agreement with the value of 44 cal./g. calculated from pressure - melting point data. Atactic polypropylene shows a marked glass transition at -12°C. and two small first-order transitions at 70°C. and at 155°C. The value for the Δcp per mole of chain atoms at the glass transition of 2.4 is in reasonable agreement with the theoretical value of 2.97 derived by Wunderlich from the Hirai-Eyring theory of liquids. The small transition at 155°C. is attributed to an isotactic or syndiotactic content, either as impurity or as isotactic or syndiotactic segments in the atactic chains. The transition at 70°C. is tentatively attributed to the melting of heterotactic sequences. Infrared measurements indicate that the atactic polypropylene contained a few per cent of isotactic material while from the heat of melting about 1% was estimated.
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The emulsion polymerization of styrene initiated by γ-rays was studied using competitive particle growth and conventional techniques. With γ-rays, the rate of free-radical generation is independent of temperature, and the absorption of energy is uniform throughout the system. From the competitive growth experiments, the particle growth rates were similar to those of persulfate ion-initiated systems and quite different from those of benzoyl peroxide-initiated systems. From the conventional experiments, the number of particles increased approximately as the square of the emulsifier concentration for both γ-ray and persulfate ion-initiated polymerizations. With γ-rays, the number of particles decreased with increasing temperature; the opposite was observed for persulfate. This may be explained by the relative rates of free-radical generation of each system; for γ-rays this rate is independent of temperature, while for persulfate, the activation energy for initiator decomposition is greater than that for polymerization propagation. For the γ-ray system, the calculated values of kp increased with increasing particle size; the activation energy was 7.2 (σ = 0.59) kcal./mole. The calculated values of kt at 50°C. were 104-105 l./mole/sec.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...