ISSN:
0003-3146
Keywords:
Chemistry
;
Polymer and Materials Science
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Chemistry and Pharmacology
,
Physics
Description / Table of Contents:
Aus Mischungen wäßriger Dispersionen von hochabriebfestem öl-Ruß (HAF) und Styrol-Butadien-Kautschuk-Latex (SBR) wurden durch Sprühtrocknung Ruß/Elastomer-Pulver hergestellt. Das Verhältnis von HAF/SBR wurde zu 100/0, 95/5, 75/25, 67/33, 50/50, 33/67 und 0/100 Gewichtsteilen gewählt. Die Pulver wurden in einer Kolben/Zylinder-Apparatur Drücken bis zu 19 kbar unterworfen.Unter dem Einfluß des Druckes bildeten sich kompakte Prüfkörper, deren Dichte bei verschiedenen Drücken bestimmt wurde. Unter bestimmten Bedingungen sind diese Prüfkörper porös; der Grad ihrer Porosität wurde sowohl aus ihrer Dichte berechnet als auch aus der Methanolaufnahme experimentell ermittelt.Bei höheren Rußgehalten werden die Prüfkörper zunehmend poröser, wobei ihre Dichte entsprechend abnimmt. Aus Dichtemessungen an dem 3-Phasen-System HAF/SBR/Poren wurde die Dichte des HAF-Rußes bei 19 kbar zu 1,97 g/cm3 bestimmt.
Notes:
Carbon-black/elastomer powders were prepared by spray-drying mixtures of aqueous dispersions of high abrasion furnace (HAF) black with styrene-butadiene rubber (SBR) latex. The HAF/SBR ratio was varied in the range 100/0, 95/5, 75/25, 67/33, 50/50, 33/67 and 0/100 parts by weight. The powders were subjected to pressures up to 19 kbar in a piston-cylinder apparatus.The density of the powders was measured at different pressures and it was found that an interaction between carbon-black and polymer occurs which results in the formation of coherent samples. They exhibit a pressure dependent degree of porosity the magnitude of which was calculated from their density and compared to the porosity determined experimentally from the methanol uptake of the samples.At higher carbon-black loadings the specimen become increasingly porous with a corresponding decrease in density. Density measurements on the three-phase system (HAF/SBR/pores) permitted to determine the density of the HAF-black at 19 kbar as 1.97 g/cm3.Density and porosity at 0 kbar of the pressed specimen are a function of the pressure at which they were prepared. The density increases with increasing pressure whereas the porosity decreases due to stronger interaction between carbon-black and elastomer.
Additional Material:
10 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/apmc.1974.050350110
Permalink