ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • Articles  (14)
  • Chemical Engineering  (13)
  • Analytical Chemistry and Spectroscopy  (1)
  • Astrophysics
  • Geophysics
  • 1975-1979  (9)
  • 1965-1969  (5)
  • 1
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 11 (1965), S. 617-624 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: Previous laboratory studies have demonstrated that the injection of small quantities of reverse-wetting agents during water displacement can increase oil recovery from unconsolidated porous media. Hexylamine is a suitable reverse-wetting agent. It has been found that the effectiveness of this treatment increases with the quantity of amine injected (slug volume and/or amine concentration in the slug), and that treatments sufficient to stimulate oil production at high water flow rates did not do so at low flow rates. It has been established that the stimulation of oil production by this technique is accomplished by transient adhesion-tension alterations, resulting in the spontaneous accumulation of oil into large continuous masses which are subsequently mobilized.The present investigation has attempted to investigate the effect of other variables thought to be important in this system in order to clarify the mechanism by which increased oil recovery is effected. Specifically, the mechanism by which large oil masses are formed and propagated was studied.Displacement studies conducted in a glass-grid micromodel, under cinemicrographic observation, revealed that large oil masses form as a consequence of restoration of water wettability (amine desorption) but only if the local oil saturation exceeds the irreducible minimum value (under water-wet conditions). Mobilization of these oil masses was observed under the influence of a favorable wettability gradient.Displacement studies were also performed in unconsolidated silica sand beds, under conditions of varying oil-water viscosity ratio, hydraulic permeability, flow rate, and time at which the amine was injected. In the range of the variables investigated, the additional oil recovered (by treatment) increased as the viscosity ratio increased oil recovery. Water-oil displacement efficiencies enhanced by amine treatment were found to correlate satisfactorily with a parameter representing the ratio of the hydraulic forces to the capillary forces within the medium.
    Additional Material: 11 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 14 (1968), S. 151-158 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: This paper reports on an experimental study of the direct contact heat transfer between oil and water in turbulent pipe flow under nonboiling conditions. Data were taken by a new technique, namely, monitoring on a very fast response recorder the output of a small thermocouple placed in the two-phase flow. The variables studied were the liquid velocity, the pipe diameter, the water volume fraction, and, to a lesser degree, the interfacial tension and the oil viscosity. A successful semiempirical method of correlating the data is also presented.
    Additional Material: 11 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 11 (1965), S. 1139-1142 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Additional Material: 9 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 14 (1968), S. 245-250 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: A limited number of tests were made of promoters, their method of application, corrosion resistance, etc.The best promoter found to date is tetrakis octadecyl thio silane (C18H37S)4Si which differs only in parafinic chain length from (C12H25S)4Si which was found to be one of the best promoters for drop-by-drop condensation by Blackman and Dewar (1, 2), Hampson (2, 3), and Osment (4, 5). These compounds are nontoxic.The C18 compound appears to be superior to the C12 compound in that it is less volatile, lower melting (∼34°C), and appears to impart superior oxidation resistance to copper when adsorbed on clean oxide-free metal.Copper tubes can be rapidly cleaned in place by sulfur dioxide or hydrochloric acid in steam, or, if previously promoted by a thio silane, by treatment first with chlorine gas in steam.The thio silanes may be rapidly applied as a 1% solution in octanoic acid injected into the sea-water feed. The acid acts as cleaner and poor promoter, allowing the good promoter molecules to contact the metal tube.The amounts of the best promoters required are in the parts per billion range.
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 15 (1975), S. 213-218 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: The general properties of a novel process for producing high modulus polyolefins are discussed. The technique is an extrusion drawing involving a crystal-crystal transformation. The principal tests have been made on polyethylene and the guidelines have been established for extending the technique to other polyolefins. The characterization of such materials is extensively discussed, particularly in the light of the concept of continuous crystals.
    Additional Material: 1 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 17 (1977), S. 535-543 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Dynamic viscosity and elastic modulus for a low molecular weight styrene-butadiene-styrene (SBS) block copolymer ate measured as a function of temperature (80-170°C) and frequency using the eccentric rotating disc geometry. These linear properties are superimposed to yield master curves each of which exhibits two branches below different (critical) reduced frequencies. At lower temperatures, the non-Newtonian behavior characteristic of SBS block copolymers is observed. In contrast, Newtonian response occurs at higher temperatures. As a consequence, plots of the viscoelastic properties vs temperature exhibit discontinuities below the critical frequencies, reflecting a narrow transition at about 142°C. Above this temperature, it is inferred, consistent with the equality of dynamic and steady state viscosities, that the polystyrene (S) blocks, existent in dispersed domains at low temperatures, exceed a critical degree of compatibility with the continuous polybutadiene phase. The activation energies indicate that the S blocks affect the temperature dependence of the dynamic properties in proportion to their presence in an interphase which is assumed to continuously grow in size as temperature is raised to the transition temperature. Below the critical reduced frequencies, it is inferred that S domain disruption may increasingly occur in conjunction with the observed property enhancement due to these domains, relative to the miscible blocks, as reduced frequency is lowered. However, above these frequencies, the presence of frequency-temperature superposition implies that the S domains and the miscible blocks are equivalent in their effects on properties. At still higher reduced frequencies, the domains present at the low temperatures studied are assumed to remain intact, but plateau behavior similar to the response characteristic of homopolymers is observed.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 18 (1978), S. 921-922 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 7 (1967), S. 45-51 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Additional Material: 14 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 16 (1976), S. 200-203 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: A study has been made on the effects of molecular weight on the physical and mechanical properties of cold-extruded high density polyethylene. Prior data indicate that such ultra-drawn strands contain a significant fraction of extended-chain crystals. Four samples, spanning the molecular weight range of 59,000 to 147,000, were cold-extruded under the same conditions and were examined with respect to their melting point, degree of crystallinity, linear expansion coefficient, Young' modulus, strain to break, and tensile strength. The degree of crystallinity, linear expansion coefficient, and modulus did not change significantly with molecular weight. The melting point, strain to break, and tensile strength do increase with increasing molecular weight. This leads to the conclusion that the amount of extended-chain crystals is invariant with molecular weight. Higher molecular weight polymers are seen as providing a greater number of the chains, thus giving the fiber a higher tensile strength.
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 19 (1979), S. 441-449 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Ultra-thin films of high density polyethylene of high orientation have been produced by the recently developed technique of solid state coextrusion. The films were prepared under moderate conditions, without lubricant in continuous lengths by extruding through conical dies of extrusion draw ratio up to 36. This is a draw ratio higher than achievable by conventional solid state extrusion at comparable processing conditions through slit dies. The ultra-thin films of high orientation were transparent and exhibited dead bend. The physical and mechanical properties were evaluated and compared with the properties of the same high density polyethylene extruded through a slit die. The increase in the melt point, crystallinity, tensile modulus, and birefringence indicates that the method is very efficient for the production of ultra-thin and highly oriented films. An experimental technique is also presented for preparing billets of controlled and uniform initial morphology and free of voids.
    Additional Material: 12 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...