ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

X
feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • AERODYNAMICS  (730)
  • 1975-1979  (469)
  • 1970-1974  (261)
  • 1935-1939
  • 1
    facet.materialart.
    Unknown
    An investigation of several numerical procedures for time-asymptotic compressible Navier-Stokes solutions (1975)
    In:  CASI
    Details
    Publication Date: 2016-06-07
    Description: The status of an investigation of four numerical techniques for the time-dependent compressible Navier-Stokes equations is presented. Results for free shear layer calculations in the Reynolds number range from 1000 to 81000 indicate that a sequential alternating-direction implicit (ADI) finite-difference procedure requires longer computing times to reach steady state than a low-storage hopscotch finite-difference procedure. A finite-element method with cubic approximating functions was found to require excessive computer storage and computation times. A fourth method, an alternating-direction cubic spline technique which is still being tested, is also described.
    Keywords: AERODYNAMICS
    Type: Aerodynamic Analyses Requiring Advanced Computers, Pt. 1; p 437-468
    Format: application/pdf
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    NASA TECHNICAL REPORTS
  • 2
    facet.materialart.
    Unknown
    Laser velocimetry applied to transonic and supersonic aerodynamics (1976)
    In:  CASI
    Details
    Publication Date: 2017-10-02
    Description: As a further demonstration of the capabilities of laser velocity in compressible aerodynamics, measurements obtained in a Mach 2.9 separated turbulent boundary layer and in the transonic flow past a two-dimensional airfoil section are presented and compared to data realized by conventional techniques. In the separated-flow study, the comparisons were made against pitot-static pressure data. Agreement in mean velocities was realized where the pressure measurements could be considered reliable; however, in regions of instantaneous reverse velocities, the laser results were found to be consistent with the physics of the flow whereas the pressure data were not. The laser data obtained in regions of extremely high turbulence suggest that velocity biasing does not occur if the particle occurrence rate is low relative to the turbulent fluctuation rate. Streamwise turbulence intensities are also presented. In the transonic airfoil study, velocity measurements obtained immediately outside the upper surface boundary layer of a 6-inch chord MACA 64A010 airfoil are compared to edge velocities inferred from surface pressure measurements. For free-stream Mach numbers of 0.6 and 0.8, the agreement in results was very good. Dual scatter optical arrangements in conjunction with a single particle, counter-type signal processor were employed in these investigations. Half-micron-diameter polystyrene spheres and naturally occurring condensed oil vapor acted as light scatterers in the two respective flows. Bragg-cell frequency shifting was utilized in the separated flow study.
    Keywords: AERODYNAMICS
    Type: AGARD Appl. of Non-Intrusive Instr. in Fluid Flow Res.; 12 p
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    NASA TECHNICAL REPORTS
  • 3
    facet.materialart.
    Unknown
    Feasibility study of an Integrated Program for Aerospace vehicle Design (IPAD). Volume 4: IPAD system design (1973)
    In:  CASI
    Details
    Publication Date: 2019-06-27
    Description: The computing system design of IPAD is described and the requirements which form the basis for the system design are discussed. The system is presented in terms of a functional design description and technical design specifications. The functional design specifications give the detailed description of the system design using top-down structured programming methodology. Human behavioral characteristics, which specify the system design at the user interface, security considerations, and standards for system design, implementation, and maintenance are also part of the technical design specifications. Detailed specifications of the two most common computing system types in use by the major aerospace companies which could support the IPAD system design are presented. The report of a study to investigate migration of IPAD software between the two candidate 3rd generation host computing systems and from these systems to a 4th generation system is included.
    Keywords: AERODYNAMICS
    Type: NASA-CR-132394 , D6-60181-4
    Format: application/pdf
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    NASA TECHNICAL REPORTS
  • 4
    facet.materialart.
    Unknown
    Feasibility study of an Integrated Program for Aerospace vehicle Design (IPAD). Volume 1A: Summary (1973)
    In:  CASI
    Details
    Publication Date: 2019-06-27
    Description: IPAD was defined as a total system oriented to the product design process. This total system was designed to recognize the product design process, individuals and their design process tasks, and the computer-based IPAD System to aid product design. Principal elements of the IPAD System include the host computer and its interactive system software, new executive and data management software, and an open-ended IPAD library of technical programs to match the intended product design process. The basic goal of the IPAD total system is to increase the productivity of the product design organization. Increases in individual productivity were feasible through automation and computer support of routine information handling. Such proven automation can directly decrease cost and flowtime in the product design process.
    Keywords: AERODYNAMICS
    Type: NASA-CR-132390 , D6-60181-1A
    Format: application/pdf
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    NASA TECHNICAL REPORTS
  • 5
    facet.materialart.
    Unknown
    Development and evaluation of a new method for predicting aircraft buffet response (1975)
    In:  Other Sources
    Details
    Publication Date: 2019-07-13
    Description: The buffet prediction method uses rigid wind tunnel model fluctuating pressure data to form a buffet forcing function. The response is then calculated with a mathematical dynamic model of the airplane developed for gust response analysis. By including the extremes of phasing and contribution of symmetric and antisymmetric airplane responses, the upper and lower bounds are established for buffet response. F-111A flight test data show good agreement with predicted bounds for a variety of flight conditions.
    Keywords: AERODYNAMICS
    Type: AIAA PAPER 75-69 , American Institute of Aeronautics and Astronautics, Aerospace Sciences Meeting; Jan 20, 1975 - Jan 22, 1975; Pasadena, CA
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    NASA TECHNICAL REPORTS
  • 6
    facet.materialart.
    Unknown
    Experiments on transonic and supersonic turbulent boundary-layer separation (1977)
    In:  Other Sources
    Details
    Publication Date: 2019-07-13
    Description: Results of experimental investigations into turbulent boundary-layer behavior under the influence of pressure gradients and with separation are presented for transonic and supersonic flow fields. In the transonic case, an axisymmetric model was implemented consisting of an annular circular arc bump affixed to a circular cylinder aligned with the flow direction. For the supersonic separation study, an oblique shock wave impinging on the wind tunnel wall boundary layer was employed to cause separation. The mean streamwise and normal velocity components as well as the respective turbulence intensities were obtained with a two-color frequency shifted laser velocimeter.
    Keywords: AERODYNAMICS
    Type: AIAA PAPER 77-47 , Aerospace Sciences Meeting; Jan 24, 1977 - Jan 26, 1977; Los Angeles, CA
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    NASA TECHNICAL REPORTS
  • 7
    facet.materialart.
    Unknown
    Flap noise generation and control (1972)
    In:  CASI
    Details
    Publication Date: 2006-03-27
    Description: The characteristics of aerodynamic noise generated by the interaction of an airstream with a flap surface are discussed. The location and behavior of various noise sources were investigated to determine optimal quieting techniques. A schematic diagram of the jet-flap concepts being considered for integrated-powered-lift systems for short takeoff aircraft is shown. Each of the concepts has in common high velocity turbulent air flowing over relatively rigid surfaces with resultant production of interaction noise. The nature, location, and control of noise sources which involve the interactions of air flows with airfoil surfaces are examined.
    Keywords: AERODYNAMICS
    Type: STOL Technol.; p 413-426
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    NASA TECHNICAL REPORTS
  • 8
    facet.materialart.
    Unknown
    Acoustic characteristics of large-scale STOL models at forward speed (1972)
    In:  CASI
    Details
    Publication Date: 2006-03-27
    Description: Wind-tunnel investigations of the acoustic characteristics of the externally blown jet flap (EBF) and augmentor wing STOL concepts are discussed. The large-scale EBF model was equipped with a triple-slotted flap blown by four JT15D turbofan engines with circular, coannular exhaust nozzles. The large-scale augmentor wing model was equipped with an unlined augmentor blown by a slot primary nozzle. The effects of airspeed and angle of attack on the acoustics of the EBF were small. Flap deflection had a greater effect on the acoustics of the augmentor wing than did airspeed. The total sound power was also significantly higher for landing indicating that turning in the augmentor generated acoustic energy. Airspeed produced a small aft shift in acoustic directivity with no significant change in the peak perceived noise levels or sound power levels. Small-scale research of the acoustics for the augmentor wing has shown that by blowing an acoustically treated augmentor with a lobed primary nozzle, the 95-PNdb noise level goal can be achieved or surpassed.
    Keywords: AERODYNAMICS
    Type: STOL Technol.; p 443-454
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    NASA TECHNICAL REPORTS
  • 9
    facet.materialart.
    Unknown
    Simulator evaluation of the flying qualities of externally blown flap and augmentor wing transport configurations (1972)
    In:  CASI
    Details
    Publication Date: 2006-03-27
    Description: Concurrent simulations of powered-lift STOL transport aircraft having either an externally blown flap configuration or an augmentor wing configuration were conducted. The following types of simulators of varying sophistication were used: (1) a simple fixed-base simulation with a simple visual display, (2) a more complex fixed-base simulation using a realistic transport cockpit and a high-quality visual display, and (3) a six-degree-of-freedom motion simulator that had a realistic transport cockpit and a sophisticated visual display. The unaugmented flying qualities determined from these simulations were rated as unacceptable for both the externally blown flap and augmentor wing configurations. The longitudinal, lateral-directional, and single-engine-failure characteristics were rated satisfactory with extensive augmentation, including pitch and roll command systems, flight-path (or speed) augmentation, turn coordination, and effective yaw damping. However, the flare and landing characteristics from any approach glide-path angle in excess of 4 deg were rated as unsatisfactory but acceptable.
    Keywords: AERODYNAMICS
    Type: STOL Technol.; p 157-800
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    NASA TECHNICAL REPORTS
  • 10
    facet.materialart.
    Unknown
    Aerodynamic characteristics of a swept augmentor wing (1972)
    In:  CASI
    Details
    Publication Date: 2006-03-27
    Description: A brief outline of augmentor wing research sponsored by Ames Research Center is presented and is followed by a discussion of large-scale wind-tunnel test results for a swept augmentor wing configuration. The results showed that the augmentor wing could be applied to high-speed swept wing designs with little adverse effect on either the basic performance of the augmentor or the longitudinal characteristics, including maximum lift and stall. Three lateral control devices were shown to be effective and ground effect was measured for several complete aircraft configurations.
    Keywords: AERODYNAMICS
    Type: STOL Technol.; p 71-86
    Format: text
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
    NASA TECHNICAL REPORTS
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...