ISSN:
0021-8995
Schlagwort(e):
Chemistry
;
Polymer and Materials Science
Quelle:
Wiley InterScience Backfile Collection 1832-2000
Thema:
Chemie und Pharmazie
,
Maschinenbau
,
Physik
Notizen:
An experimental study of the development of phase morphology, rheological properties, and processing behavior of mechanical blends of a polystyrene (PS) and a high density polyethylene (PE) is presented. Phase morphologies were determined by scanning electron microscopy for (i) products prepared in a screw extruder/static mixer system, (ii) samples removed from a cone-plate viscometer, (iii) extrudates, and (iv) melt spun fibers. Disperse phase dimensions were measured. The values varied from 1-5 μm in the products from static mixers. The dimensions of the dispersed phase in the blend products from the cone plate and capillary die were of the same order. The melt-spun fibers exhibited disperse phase dimensions as low as 0.35 μm. Polystyrene was extracted from the blend fibers producing small diameter, PE fibrils, or minifibers. Both the initial melts and the blends were rheologically characterized. The shear viscosity and principal normal stress difference N1 exhibit maxima and minima when plotted as a function of composition. The characteristics of extrudates and melt spinning behavior of the blends were investigated. The shrinkage of extrudates of PE is much greater than PS. Additional small amounts of PE to PS greatly increase its shrinkage. Addition of PE to PS initially increases extrudate swell, though the swell shows maxima and minima when considered as a function of composition. The positions of the maxima and minima correspond to those of N1. The onset of draw resonance has been investigated in isothermal melt spinning. Wide angle X-ray diffraction studies have been carried out on blend fibers and the orientation of the crystalline polyethylene regions has been determined as a function of process conditions. This orientation decreases rapidly with the addition of polystyrene when the melt-spun filaments are compared at the same spinline stress or drawdown ratio.
Zusätzliches Material:
23 Ill.
Materialart:
Digitale Medien
URL:
http://dx.doi.org/10.1002/app.1984.070290619
Permalink
