ALBERT

Description: Recent advances in room-temperature, near-IR and visible diode laser sources for tele-communication, high-speed computer networks, and optical data storage applications are enabling a new generation of gas-dynamic and combustion-flow sensors based on laser absorption spectroscopy. In addition to conventional species concentration and density measurements, spectroscopic techniques for temperature, velocity, pressure and mass flux have been demonstrated in laboratory, industrial and technical flows. Combined with fibreoptic distribution networks and ultrasensitive detection strategies, compact and portable sensors are now appearing for a variety of applications. In many cases, the superior spectroscopic quality of the new laser sources compared with earlier cryogenic, mid-IR devices is allowing increased sensitivity of trace species measurements, high-precision spectroscopy of major gas constituents, and stable, autonomous measurement systems. The purpose of this article is to review recent progress in this field and suggest likely directions for future research and development. The various laser-source technologies are briefly reviewed as they relate to sensor applications. Basic theory for laser absorption measurements of gas-dynamic properties is reviewed and special detection strategies for the weak near-IR and visible absorption spectra are described. Typical sensor configurations are described and compared for various application scenarios, ranging from laboratory research to automated field and airborne packages. Recent applications of gas-dynamic sensors for air flows and fluxes of trace atmospheric species are presented. Applications of gas-dynamic and combustion sensors to research and development of high-speed flows aeropropulsion engines, and combustion emissions monitoring are presented in detail, along with emerging flow control systems based on these new sensors. Finally, technology in nonlinear frequency conversion, UV laser materials, room-temperature mid-IR materials and broadly tunable multisection devices is reviewed to suggest new sensor possibilities.

Description: Knowledge of the global scale distribution of atmospheric ozone and its temporal variability can be achieved using a satellite-based nadir-viewing device making high spectral resolution measurements with high signal-to-noise ratios. This would enable observation in the pressure-broadened wings of strong O3 lines while minimizing the impact of undesirable signal contributions associated with, for example, the terrestrial surface and interfering species. The Fabry-Perot interferometer (FPI) provides high spectral resolution and high throughput capabilities that are essential for this measurement task. The periodic nature of the Fabry-Perot instrument function can be advantageous when observation of periodic spectra is desired. However, for most applications, additional optical elements are necessary to reduce the effect of unwanted passbands. This is frequently accomplished using additional Fabry-Perot etalons in a series configuration in conjunction with a bandpass filter. This paper discusses a Fabry-Perot interferometer conceptual instrument design to achieve tropospheric and total ozone monitoring capability from a satellite-based nadir-viewing geometry. The design involves a double-etalon fixed-gap series configuration FPI along with an ultra-narrow bandpass filter to achieve single-order operation with an overall spectral resolution of approximately .068 cm(exp -1). The impact of inter-etalon reflections has been reduced to acceptable levels by placement of a slightly attenuating medium in between the etalons. A passive device is selected for low power consumption, and continuous day/night coverage, independent of solar zenith angle, is enabled by observing within the strong 9.6 micron ozone infrared band. The IR-FPI detection will be performed through implementation of the new Circle to Line Interferometer Optical (CLIO) system, developed by researchers at the Space Physics Research Laboratory (SPRL) of the University of Michigan, to accomplish focal plane fringe detection; the CLIO system converts the circular interferometric fringes into a linear pattern which then can be detected by conventional linear array detectors. A multiplex signal advantage is achievable as all necessary frequencies can be measured simultaneously using a multichannel configuration. Through proper selection of channel spectral regions, the FPI optimized for tropospheric O3 measurements can simultaneously observe a stratospheric component and thus the total O3 column abundance.

Description: In today's heterogeneous computing environment of proliferating platforms and operating systems, the Internet, through the World Wide Web (WWW), is becoming the preferred interface to much of the world's archive of digital data.

Description: Using results from a time-dependent photochemical model to calculate the diurnal variation of NO and NO(sub 2), we have corrected Atmospheric Trace Molecule Spectroscopy (ATMOS) solar-occultation retrievals of the NO and NO(sub 2) abundances at 90 solar zenith angle. Neglecting to adjust for the rapid variation of these gases across the terminator results in potential errors in retrieved profiles of approx. 20 percent for NO(sub 2) and greater than 100 percent for NO at altitudes below 25 KM.

Description: Using results from a time-dependent photochemical model to calculate the diurnal variation of NO and NO2, we have corrected Atmospheric Trace MOlecule Spectroscopy (ATMOS) solar-occultation retrievals of the NO and NO2 abundances at 90' solar zenith angle. Neglecting to adjust for the rapid variation of these gases across the terminator results in potential errors in retrieved profiles of approximately 20% for NO2 and greater than 100% for NC at altitudes below 25 km. Sensitivity analysis indicates that knowledge of the local 03 and temperature profiles, rather than zonal mean or climatological conditions of these quantities, is required to obtain reliable retrievals of NO and NO2 in the lower stratosphere. Extremely inaccurate 03 or temperature values at 20 km can result in 50% errors in retrieved NO or NO2. Mixing ratios of NO in the mid-latitude, lower stratosphere measured by ATMOS during the November 1994 ATLAS-3 mission compare favorably with in situ ER-2 observations, providing strong corroboration of the reliability of the adjusted space-borne measurements.

Description: The ATMOS Fourier transform spectrometer was flown for a fourth time on the Space Shuttle as part of the ATLAS-3 instrument payload in November 1994. More than 190 sunrise and sunset occultation events provided measurements of more than 30 atmospheric trace gases at latitudes 3 - 49 deg N and 65 - 72 deg S, including observations both inside and outside the Antarctic polar vortex. The instrument configuration, data retrieval methodology, and mission background are described to place in context analyses of ATMOS data presented in this issue.

Description: The hydrocarbon photochemistry in the upper atmosphere of Jupiter is investigated using a one-dimensional, photochemical-diffusive, and diurnally averaged model. The important chemical cycles and pathways among the major species are outlined and a standard model for the North Equatorial Belt region is examined in detail. It is found that several traditionally dominant chemical pathways among the C and C2 species are replaced in importance by cycles involving C-C4 species. The pressure and altitude profiles of mixing ratios for several observable hydrocarbon species are compared with available ultraviolet- and infrared-derived abundances. The results of sensitivity studies on the standard model with respect to variations in eddy diffusion profile, solar flux, atomic hydrogen influx, latitude, temperature, and important chemical reaction rates are presented. Measured and calculated airglow emissions of He at 584 angstroms and H at 1216 angstroms are also used to provide some constraints on the range of model parameters. The relevance of the model results to the upcoming Galileo mission is briefly discussed. The model is subject to considerable improvement; there is a great need for laboratory measurements of basic reaction rates and photodissociation quantum yields, even for such simple species as methylacetylene and allene. Until such laboratory measurements exist there will be considerable uncertainty in the understanding of the C3 and higher hydrocarbons in the atmospheres of the jovian planets.