ISSN:
1572-8838
Keywords:
aluminium
;
cermet
;
electrode
;
electrolysis
;
inert
;
NiFe2O4
Source:
Springer Online Journal Archives 1860-2000
Topics:
Chemistry and Pharmacology
,
Electrical Engineering, Measurement and Control Technology
Notes:
Abstract Dense, sintered samples of nickel ferrite/nickel oxide–copper cermets were produced and characterized. Three compositions were chosen, each with different NiO content. A new method of powder preparation involving no use of water as dispersant resulted in a well-dispersed ceramic phase with smaller metal grains than previously reported. The individual phases in the cermets were analysed quantitatively using energy-dispersive X-ray microanalysis, and significant differences between the materials were found. The electrical conductivity of the materials was measured, showing interesting properties not previously described. Reaction sintering was tried and found to lead to a microstructure different from that obtained with pre-calcined powder. The nickel contamination level in the electrolyte did not reach steady state after 4h of electrolysis. Iron and copper did seem to reach steady state after some irregular behaviour early in the tests. The total contamination level of anode constituents in the deposited metal was as low as 0.116wt%. These encouraging results seemed to be partly related to the cell configuration giving very slow mass transfer from the electrolyte into the metal.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1023/A:1003460220418
Permalink