ALBERT

Description: We have investigated more than 450 coronal mass ejections (CME's) observed between 1979-1985 (by SOLWIND) having speed more than 500 km/s. To carry out the study we have used the method of time and spatial correlations. From the study we have found the following: (1) About 50% CMEs are related with coronal holes; (2) About 15% CMEs are related with solar flares; (3) About 25% CMEs are associated with eruptive prominence; and (4) About 10% CMEs are not related with any solar phenomena. The relationship of CMEs and solar radio bursts are also studied. In the light of above, we are of the view that there may be two types of CMEs. The origin of one of them may be related with coronal holes and that for other may be solar flares and prominences.

Description: Noniterative algorithm for generalized inverse of arbitrary rectangular matrix computation

Description: The main instrumentation platform consisted of eddy correlation sensors mounted on a scaffold tower at a height of 4.2 m above the peat surface. The sensors were attached to a boom assembly which could be rotated into the prevailing winds. The boom assembly was mounted on a movable sled which, when extended, allowed sensors to be up to 2 m away from the scaffolding structure to minimize flow distortion. When retracted, the sensors could easily be installed, serviced or rotated. An electronic level with linear actuators allowed the sensors to be remotely levelled once the sled was extended. Two instrument arrays were installed. A primary (fast-response) array consisted of a three-dimensional sonic anemometer, a methane sensor (tunable diode laser spectrometer), a carbon dioxide/water vapor sensor, a fine wire thermocouple and a backup one-dimensional sonic anemometer. The secondary array consisted of a one-dimensional sonic anemometer, a fine wire thermocouple and a Krypton hygrometer. Descriptions of these sensors may be found in other reports (e.g., Verma; Suyker and Verma). Slow-response sensors provided supporting measurements including mean air temperature and humidity, mean horizontal windspeed and direction, incoming and reflected solar radiation, net radiation, incoming and reflected photosynthetically active radiation (PAR), soil heat flux, peat temperature, water-table elevation and precipitation. A data acquisition system (consisting of an IBM compatible microcomputer, amplifiers and a 16 bit analog-to-digital converter), housed in a small trailer, was used to record the fast response signals. These signals were low-pass filtered (using 8-pole Butterworth active filters with a 12.5 Hz cutoff frequency) and sampled at 25 Hz. Slow-response signals were sampled every 5 s using a network of CR21X (Campbell Scientific, Inc., Logan Utah) data loggers installed in the fen. All signals were averaged over 30-minute periods (runs).

Description: Secondary electron flux and energy calculations in upper atmosphere

Description: Proton and electron balloon measurements of splash and re-entrant cosmic ray albedo

Description: Differential energy spectrum of primary cosmic ray electrons measured on IMP 3 during minimum solar modulation for galactic radiation

Description: Secondary electron energy spectra and flux calculations for upper layers of atmosphere

Description: The light absorption coefficient, Beta(a) of the stratospheric aerosol is an important quantity that determines its radiative effects. When combined with the aerosol scattering coefficient, Beta(a) it becomes possible to evaluate the aerosol single scatter albedo, omega = Beta(s)/(Beta(s) + Beta(a)) which is essential for modeling the overall radiative effects of the stratospheric aerosol. Pollack1 determined that omega = 0.98 is a critical value that separates stratospheric cooling from warming.

Description: Interest in the distribution of black carbon (soot) aerosol (BCA) in the atmosphere is based on the following: (1) Because BCA has the highest absorption cross section of any compound know, it can absorb solar radiation to cause atmospheric warming; (2) Because BCA is a strong adsorber of gases, it can catalyze heterogeneous chemical reactions to modify the chemical composition of the atmosphere; (3) If aircraft emission is the major source of BCA, it can serve as an atmospheric tracer of aircraft exhaust. We collect BCA particles as small as 0.02 micrometers by wires mounted on both the DC-8 and ER-2 aircraft. After return to the laboratory, the wires are examined with a field emission scanning electron microscope to identify BCA particles by their characteristics morphology, Typically, BCA exists in the atmosphere as small particles of complex morphology. The particle sizes at the source are measured in tens of Angstrom units; after a short residence time in the atmosphere, individual particles coalesce to loosely packed agglomerates of typical dimensions 0.01 to 0.1 micrometer. We approximate the size of each BCA aggregate by that of a sphere of equivalent volume. This is done by computing the volume of a sphere whose diameter is the mean between averaged minimum and maximum dimensions of the BCA particle. While this procedure probably underestimates the actual surface area, it permits us to compare BCA size distributions among themselves and with other types of aerosols.

Description: Balloon sounding data of primary cosmic ray electron component evaluated for long term time variations