ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 91 (2002), S. 5909-5914 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: A quadratic dependence of the band gap energy on the alloy composition x was quantified for CuAl(SxSe1−x)2 films grown by low-pressure metalorganic vapor phase epitaxy, by means of photoreflectance and photoluminescence excitation spectroscopies. The bowing parameter for the A-exciton energy was estimated to be 0.20 eV. Several high-quality films grown on GaAs(001) substrates exhibited excitonic photoluminescence peaks in the blue to ultraviolet spectral ranges. The flow rate of the Al precursor was found to affect the incorporation ratio of S/Se, indicating that the Al–S compound plays a key role in controlling x. All films grown on GaAs(001) showed c(001) orientation. Conversely, the epitaxitial orientation of the films on GaP(001) changed from a(100) to c(001) with an increase in x. The critical value of x was around 0.5. The preferred orientations were explained by the natural selection rule under which the lattice strain in the epilayer is minimized. The residual strain in the 0.5-μm-thick epilayers on GaAs(001) was nearly constant for all x, although the lattice mismatch between the epilayer and the GaAs substrate varied from 0.62% to 5.39% with an increase in x. Consequently the strain was attributed to thermal stress. © 2002 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 72 (2001), S. 3121-3124 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: This article proposes a method to utilize a commercially available high-power pulsed-laser diode (HPLD) in time sharing to induce damage by laser irradiation and to detect the threshold level of the damage. This method features: (1) damage inducement when the HPLD is under the pulsed high-power laser oscillation mode, and (2) surface reflectivity measurement when the HPLD is under the cw light-emitted-diode illumination mode. This technique allows nondestructive measurement of the damage threshold level with high sensitivity, in spite of its extremely simple approach. Accordingly, the technique is appropriate for real-time inspection in a manufacturing process. The practical data for determining the damage threshold are shown. The damage threshold for aluminum (JIS A5052) was estimated to be approximately 62 mJ/mm2. The capability of our proposed method is shown compared with that of more conventional methods. The advantages of our technique are described. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 72 (2001), S. 1796-1799 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: A new Bragg reflection detection instrument for an ultrasonic measurement that is based on self-mixing effects due to an optical feedback for a laser diode is proposed. This instrument allows measurement of the velocity and/or absorption of ultrasound in an ultrahigh frequency (UHF) range, in spite of its extremely simple configuration. The velocity of an ultrasonic wave in water was measured in an UHF range. The velocity was within 5% of the velocity in the previous results. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: The Large Helical Device (LHD) is the largest helical machine with superconducting coils. Key diagnostics issues for LHD are: (a) capability for multidimensional measurements because of the nonaxisymmetric toroidal plasma; (b) measurements of the electric field; (c) cross check of fundamental parameters using different methods; (d) advanced measurements appropriate for steady-state operation; and (e) a satisfactory data acquisition system. The design and research and development of plasma diagnostics were carried out taking these issues into consideration. As a result, the present status of diagnostics is described: diagnostics for LHD operation, fundamental diagnostics for plasma performance, diagnostics for physics subjects, innovative diagnostics and diagnostics for long-pulse operation. The LHD experiment started in March, 1998. Since then, the development of diagnostics has kept pace with the experimental campaigns. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 89 (2001), S. 5406-5413 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Growth orientation, domain structures, and residual strain of Cu(Al,Ga)(S,Se)2 epitaxial films grown by low-pressure metalorganic vapor phase epitaxy on various substrates were systematically investigated. All epilayers grew in such a manner that the lattice mismatch between the epilayer and the substrate became minimum. Domain structure of the epilayer changed depending on the type of substrate. Most residual strain in the epilayer was assigned as being due to the pseudomorphic stress for the epilayers having small lattice mismatch (〈1%) against the substrate and to the thermal stress for large lattice mismatch (〉1%) ones. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 91 (2002), S. 1855-1859 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: The quantum mechanical behavior of an H atom adsorbed on Cu(111) and on Pt(111) is investigated. The potential energy curves (PECs) for the H atom motion on these surfaces are calculated within the density functional theory, and the adiabatic three-dimensional potential energy surfaces (PESs) are constructed based on the obtained PECs. The wave functions and their energies for the H atom motion on the PESs are calculated within the framework of the variation method. The results show that, in the case of Cu(111), the ground state wave function is strongly localized around the fcc hollow site, the first-excited state wave function is strongly localized around the hcp hollow site, and these states almost energetically degenerate. On the other hand, the second-excited state wave function is delocalized and extends from the fcc hollow site to the bridge site and further to the hcp hollow site. Then, there is a significant energy gap between the first- excited and the second-excited state. In the case of Pt(111), the ground and the first-excited state wave functions are delocalized and extend from the hollow site to the bridge site. The second-excited state wave function further extends over the top site. The energy differences between the ground and the first-excited state, and between the first-excited and the second-excited state are very small. Thus, the H atom adsorbed on Pt(111) has a delocalized nature. © 2000 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 88 (2000), S. 6897-6901 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: We calculate the potential energy curves for H adsorption on and absorption in Cu(111), Pt(111), and Pd(111) within the density functional theory. We show stronger dependence of the potential energies on the lateral position of the H atom at the position further from the surface in the case of Pt(111) than one in the case of Pd(111), and no lateral position dependence in the case of Cu(111). Contrary to this, when the H atom comes close to and adsorbs on the surface, the dependence of its adsorption energy (a depth of potential well outside the surface) on the lateral position in the case of Cu(111) is stronger than one in the case of Pd(111), and such dependencies are hardly seen, and the adsorption energies are nearly the same in the case of Pt(111). When the H atom penetrates the first layer of the surface, the activation barrier at a so-called face-centered-cubic hollow site in the case of Pd(111) is the lowest in three surfaces. © 2000 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 87 (2000), S. 3912-3919 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: In measurement of the microwave surface resistance, Rs(T), of a high-Tc film with a host-cavity method, in which the cavity material is usually copper, the systematic error in Rs at low temperature can be significantly reduced through calibration with the data obtained by a niobium host cavity. Using a cavity excited in the TE011 mode at 13.6 GHz, the procedure is illustrated for a c-axis oriented YBa2Cu3O7−δ film fabricated on 36 mm diameter copper disk with yttria-stabilized-zirconia and chromium buffer layers. The temperature dependence in Rs(T) was consistent with that of the penetration depth; both quantities behavior could be fit well by a modified two-fluid model, in which the fraction of the pairing normal carriers obeyed (T/Tc)2 rather than (T/Tc)4 with some 20% of the charge carriers remaining normal. © 2000 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    College Park, Md. : American Institute of Physics (AIP)
    The Journal of Chemical Physics 115 (2001), S. 3785-3791 
    ISSN: 1089-7690
    Source: AIP Digital Archive
    Topics: Physics , Chemistry and Pharmacology
    Notes: The dynamics of polystyrene microgel (PSMG), i.e., a probe particle of highly cross-linked polystyrene latex spheres with radii 20.7 and 284 nm, during the sol–gel transition of poly(γ-benzyl-L-glutamate) (PBLG) dissolved in N,N-dimethylformamide (DMF) solution has been investigated by measurements with the dynamic light scattering technique. All the intensity time correlation functions (ICF) measured from PSMG dispersed in PBLG matrix approximately decayed single exponentially. First, it was confirmed that the diffusion coefficients of PSMG at the sol state of 298.8 K obeyed the stretched exponential relation as a function of concentration of PBLG–DMF solutions. Second, the initial amplitude and the normalized variance of ICF, and the diffusion coefficient of PSMG were altered considerably before and after sol–gel transition with decreasing temperature. The initial amplitude and the normalized variance had a minimum and a maximum at the gelation threshold temperature, respectively. It was also found that PSMG almost free-diffused even at the gel state, as well as the sol state, regardless of low temperature. These facts may strongly support that the resulting PBLG gels induced through microphase separation evidently had a porous and bicontinuous structure at the "swollen gel state," which corresponds to the results observed by a transmission electron microscope. © 2001 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 73 (2002), S. 1828-1831 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: We have succeeded in developing a new high-pressure cell designed for measuring the absolute value of the electrical resistivity in magnetic fields at low temperatures. This pressure cell, based on a technique using modified Bridgman anvils with a Teflon capsule, can generate nearly hydrostatic pressure at least up to 6 GPa. The most important feature of this pressure cell is its compact body which can be easily combined with a dilution refrigerator in a superconducting magnet. One of its applications is for precise magneto-transport measurements under nearly hydrostatic pressure, which is demonstrated by the investigation into the pressure-induced superconducting state of the spin-ladder Sr14−xCaxCu24O41 (x=12) single crystal. © 2002 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...