ALBERT

Description: The detailed analysis of the three-dimensional structure of a dryline observed over the Oklahoma panhandle during the International H2O Project (IHOP_2002) on 11 June 2002 is presented. High-resolution observations obtained from the National Center for Atmospheric Research Electra Doppler Radar (ELDORA), S-band dual-polarization Doppler radar (S-Pol), water vapor differential absorption lidar (DIAL) Lidar pour l'Etude des Interactions Aérosols Nuages Dynamique Rayonnement et du Cycle de l'Eau (LEANDRE II; translated as Lidar for the Study of Aerosol–Cloud–Dynamics–Radiation Interactions and of the Water Cycle) as well as Learjet dropsondes are used to reveal the evolution of the dryline structure during late afternoon hours when the dryline was retreating to the northwest. The dryline reflectivity shows significant variability in the along-line direction. Dry air was observed to overrun the moist air in vertical cross sections similar to a density current. The updrafts associated with the dryline were 2–3 m s−1 and were able to initiate boundary-layer-based clouds along the dryline. The formation of this dryline was caused by high equivalent potential temperature air pushing northwestward toward a stationary front in the warm sector. Middle-level clouds with radar reflectivity greater than 18 dBZe near the dryline were detected by ELDORA. A roll boundary, which was associated with larger convergence and moisture content, was evident in the S-Pol data. It is found that the instability parameters most favorable for convection initiation were actually associated with the roll boundary, not the dryline. A storm was initiated near the roll boundary probably as a result of the combination of the favorable instability parameters and stronger upward forcing. It is noted that both the 11 June 2002 dryline and the roll boundary presented in this paper would not be identified if the special datasets from IHOP_2002 were not available. Although all model runs [fifth-generation Pennsylvania State University–NCAR Mesoscale Model (MM5), Meso Eta, and Rapid Update Cycle (RUC)] suggested deep convection over the Oklahoma panhandle and several cloud lines were observed near the dryline, the dryline itself did not initiate any storms. The reasons why the dryline failed to produce any storm inside the IHOP_2002 intensive observation region are discussed. Both synoptic-scale and mesoscale conditions that were detrimental to convection initiation in this case are investigated in great detail.

Description: The International H2O Project (IHOP_2002) included four complementary research components: quantitative precipitation forecasting, convection initiation, atmospheric boundary layer processes, and instrumentation. This special issue introductory paper will review the current state of knowledge on surface-forced convection initiation and then describe some of the outstanding issues in convection initiation that partially motivated IHOP_2002. Subsequent papers in this special issue will illustrate the value of combining varied and complementary datasets to study convection initiation in order to address the outstanding issues discussed in this paper and new questions that arose from IHOP_2002 observations. The review will focus on convection initiation by boundaries that are prevalent in the U.S. southern Great Plains. Boundary layer circulations, which are sometimes precursors to deep convective development, are clearly observed by radar as reflectivity fine lines and/or convergence in Doppler velocity. The corresponding thermodynamic distribution, particularly the moisture field, is not as readily measured. During IHOP_2002, a variety of sensors capable of measuring atmospheric water vapor were brought together in an effort to sample the three-dimensional time-varying moisture field and determine its impact on forecasting convection initiation. The strategy included examining convection initiation with targeted observations aimed at sampling regions forecast to be ripe for initiation, primarily along frontal zones, drylines, and their mergers. A key aspect of these investigations was the combination of varied moisture measurements with the detailed observations of the wind field, as presented in many of the subsequent papers in this issue. For example, the high-resolution measurements are being used to better understand the role of misocyclones on convection initiation. The analyses are starting to elucidate the value of new datasets, including satellite products and radar refractivity retrievals. Data assimilation studies using some of the state-of-the-art datasets from IHOP_2002 are already proving to be quite promising.

Description: The International H2O Project (IHOP_2002) was designed to sample the three-dimensional time-varying moisture field to better understand convective processes. Numerous research and operational water vapor measuring systems and retrievals, via in situ and remote sensing techniques, were operated in the U.S. Southern Great Plains from 13 May to 25 June 2002. This was done in combination with more traditional observations of wind and temperature. Convection initiation (CI) sampling strategies were designed to optimally employ the array of ground-based and airborne sensors to observe the processes leading to the development of deep, moist convection. This case study examines several clear-air features and their impact on CI on 12 June 2002. The supercells that developed produced damaging winds and hail. The clear-air, preconvective features included (i) a mesoscale low pressure region, (ii) a dryline, (iii) an old outflow boundary, (iv) the intersection of (ii) and (iii), (v) internal gravity waves, and (vi) horizontal convective rolls. A unique combination of instruments was positioned to sample the preconvective environment on 12 June 2002. The Lidar pour l’Etude des Interactions Aérosols Nuages Dynamique Rayonnement et du Cycle de l’Eau (LEANDRE II) water vapor differential absorption lidar (DIAL), the airborne Electra Doppler Radar (ELDORA), and the Navy Research Laboratory (NRL) P3 aircraft in situ measurements provided information on the moisture and vertical velocity distribution within the boundary layer. Radiosondes, dropsondes, wind profilers, and an Atmospheric Emitted Radiance Interferometer (AERI) provided temperature, moisture, and wind profiling information. Although other ground-based sensors (i.e., S-band dual-polarization Doppler radar, Mobile Integrated Profiling System) were 50–150 km west of the CI area, they were useful for illustrating the boundary layer kinematics and reflectivity fields. Results suggest that the mesolow and mesoscale boundaries, respectively, acted to enhance the low-level moisture advection and convergence in the CI region. While internal gravity waves were present and appeared to modulate water vapor along the old outflow boundary, they did not play an obvious role in CI in this case. Horizontal convective rolls were observed beneath the new storms that initiated and may have helped to focus the CI in this case.