ALBERT

Description: Proposed dual column gas chromatographic mass spectrometer for analyzing Jupiter atmosphere

Description: The performance of the microbial response to space environment experiment is considered excellent by all investigators. For most microbial systems, only preliminary survival data are available at this time. None of the available data indicate space flight-mediated changes in cell viability or recovery. One quite important observation has been made at this early date, however. The eggs produced after mice had been infected with N. dubius larvae demonstrated a significant decrease in hatchability when compared to identical ground controls. Except for the fact that the Apollo 16 flight larvae had been on board the command module, treatment of the flown larvae and ground control larvae was the same; neither had been exposed to UV irradiation. The significance and implications of this finding are currently being studied.

Description: Cultures of B. thuringiensis returned from space flight appeared to be normal to slightly affected adversely in their ability to produce three toxins that affect insects. In addition, it can be stated that B. thuringiensis spores are very resistant to ultraviolet irradiation at the individual wavelengths and energy levels previously described. Full sunlight, however, does have a detrimental effect on the viability of B. thuringiensis spores.

Description: The design and fabrication of a completely portable, self-contained gas chromatograph is described. This instrument utilizes a closed-loop hydrogen carrier gas flow as maintained by a hydrogen generator-separator. It employs an auxiliary hydrogen generator to keep a positive flow of hydrogen through the detector. The detector is an ionization cross section detector. The only maintenance required is the addition of water (5-15 cc/day) to the auxiliary hydrogen generator. Lower limit of detection for the present system is of the order of 1-10 ppm ethane.

Description: Computer software as engineering tools are typically run in three modes: Batch, Demand, and Interactive. The first two are the most popular in the SINDA world. The third one is not so popular, due probably to the users inaccessibility to the command procedure files for running SINDA '85, or lack of familiarity with the SINDA '85 execution processes (pre-processor, processor, compilation, linking, execution and all of the file assignment, creation, deletions and de-assignments). Interactive is the mode that makes thermal analysis with SINDA '85 a real-time design tool. This paper explains a command procedure sufficient (the minimum modifications required in an existing demand command procedure) to run SINDA '85 on the VAX in an interactive mode. To exercise the procedure a sample problem is presented exemplifying the mode, plus additional programming capabilities available in SINDA '85. Following the same guidelines the process can be extended to other SINDA '85 residence computer platforms.

Description: As a calibrated imaging spectrometer flying at a 20 km altitude, AVIRIS may contribute to the Landsat and the Advanced Land Remote Sensing System efforts. These contributions come in the areas of: (1) on-orbit calibration, (2) specification of new spectral bands, (3) validation of algorithms, and (4) investigation of an imaging spectrometer of the Advanced Land Remote Sensing System.

Description: The modeling features used in a steady-state heat transfer problem using SINDA/FLUINT are described. The problem modeled is a 125 feet long, 3 inch diameter pipe, filled with liquid oxygen flow driven by a given pressure gradient. The pipe is fully insulated in five sections. Three sections of 1 inch thick spray-on foam and two sections of vacuum jacket. The model evaluates friction, turns losses and convection heat transfer between the fluid and the pipe wall. There is conduction through the foam insulation with temperature dependent thermal conductivity. The vacuum space is modeled with radiation and gas molecular conduction, if present, in the annular gap. Heat is transferred between the outer surface and surrounding ambient by natural convection and radiation; and, by axial conduction along the pipe and through the vacuum jacket spacers and welded seal flanges. The model makes extensive use of SINDA/FLUINT basic capabilities such as the GEN option for nodes and conductors (to generate groups of nodes or conductors), the SIV option (to generate single, temperature varying conductors), the SIM option (for multiple, temperature varying conductors) and the M HX macros for fluids (to generate strings of lumps, paths, and ties representing a diabatic duct). It calls subroutine CONTRN (returns the relative location in the G-array of a network conductor, given an actual conductor number) enabling an extensive manipulation of conductor (calculates an assignment of their values) with DO loops. Models like this illustrate to the new and even to the old SINDA/FLUINT user, features of the program that are not so obvious or known, and that are extremely handy when trying to take advantage of both, the automation of the DATA headers and make surgical modifications to specific parameters of the thermal or fluid elements in the OPERATIONS portion of the model.

Description: The response of germfree mice to subcutaneous and intraperitoneal injection of aqueous suspensions of lunar fine material (LFM) was evaluated. Both uninjected mice and mice injected with dry heat sterilized LFM were included as controls. After injection, the majority of mice were subjected to serial sacrifice to assess the time course of the tissue response. A smaller group of animals were held for lifespan studies. The observations suggest that LFM is relatively insoluble in tissue and that, while acting as a low grade irritant, it has little tendency to evoke reactive fibrosis.