ALBERT

Description: Volcanic emissions are considered one of the major natural sources of several trace metals (e.g. As, Cd, Cu, Pb, and Zn) to the atmosphere [Nriagu, 1989], and the geochemical cycles of these elements have to be considered strongly influenced by volcanic input. However, the accurate estimation of the global volcanic emissions of volatile trace metals into the atmosphere is still affected by a high level of uncertainty. The latter depends on the large variability in the emission of the different volcanoes, and on their changing stage of activity. Moreover, only few of the potential sources in the world have been directly measured [Hinkley et al. 1999]. Atmospheric deposition processes (wet and dry) are the pathways through which volcanic emissions return to the ground (soils, plants, aquifers), resulting in both harmful and beneficial effects [Baxter et al. 1982; Aiuppa et al. 2000; Brusca et al. 2001; Delmelle, 2003; Bellomo et al. 2007; Martin et al. 2009; Floor et al. 2011; Calabrese et al. 2011]. In the first part of this study we present the results of a literature review on trace metals emissions from active volcanoes around the world. In the second part, we present new data on the fluxes of the trace metals from Etna (Italy) and four active volcanoes in the world: Turrialba (Costarica), Nyiragongo (DRC), Mutnovsky and Gorely (Kamchatka). We found 27 publications (the first dating back to the 70’s), 13 of which relate to the Etna and the other include some of the world’s most active volcanoes: Mt. St. Helens, Erebus, Merapi, White Island, Kilauea, Popocatepetl, Galeras, Indonesian arc, Satasuma and Masaya. The review shows that currently there are very few data available, and that the most studied volcano is Mt. Etna. Using these data, we defined a range of fluxes for As, Ba, Bi, Cd, Cu, Fe, Mn, Pb, Se, V and Zn (Figure 1). To obtain new data we sampled particulate filters at the five above mentioned volcanoes. Filters were mineralized (acid digestion) and analyzed by ICP-MS. Sulphur to trace element ratios were related to sulphur fluxes to indirectly estimate trace elements fluxes. Etna confirms to be one of the greatest point sources in the world. The Nyiragongo results to be also a significant source of metals to the atmosphere, especially considering its persistent state of degassing from the lava lake. Also Turrialba and Gorely have high emission rates of trace metals considering the global range. Only Mutnovsky Volcano show values which are sometimes lower than the range obtained from the review, consistent with the fact that it is mainly a fumarolic field. This work highlights the need to expand the current dataset including many other active volcanoes for a better constraint of global trace metal fluxes from active volcanoes.

Description: Published

Description: Nicolosi (Catania)

Description: 1.2. TTC - Sorveglianza geochimica delle aree vulcaniche attive

Description: open

Description: Volcanic emissions represent one of the most relevant natural sources of trace elements to the troposphere, both during and between eruptions. Due to their potential toxicity they may have important environmental impacts from the local to the global scale. Mount Etna, the largest European volcano and one of the most active volcano in the world, covers an area of about 1250 km2 and reaches an altitude of about 3340 m. It has been persistently active during historical time, with frequent paroxysmal episodes separated by passive degassing periods. Atmospheric precipitation was collected approximately every two weeks, from April 2006 to December 2007, using a network of five rain gauges, located at various altitudes on the upper flanks around the summit craters of Etna Volcano. The collected samples were analysed for major (Ca, Mg, K, Na, F, SO4, Cl, NO3) and a large suite of trace elements (Ag, Al, As, Au, B, Ba, Be, Bi, Cd, Co, Cr, Cs, Cu, Fe, Hg, La, Li, Mn, Mo, Ni, Pb, Rb, Si, Sb, Sc, Se, Sr, Th, Ti, Tl, U, V, Zn) by using different techniques (IC, SPEC, ICP-MS and CV-AFS). The monitoring of atmospheric deposition gave the opportunity to occasionally sample volcanic fresh ashes emitted by the volcano during the paroxysmal events. This was possible because the network of five rain gauges were equipped with a filter-system to block the coarse material. In this way, more than twenty events of ashfall were collected. Unfortunately, only half of these samples were suitable for a complete chemical analysis, because of the small amount of sample. In order to obtain elemental chemical composition of ashes, powdered samples were analysed by a combination of methods, including X-ray Fluorescence Spectroscopy (XRF), total digestion followed by Inductively Coupled Plasma Emission Mass Spectrometry (ICP-MS), Instrumental Neutron Activation Analysis (INAA), and infrared detection (IR). The chemistry of rainwater reveals that most of the investigated elements have higher concentrations close to the emission vent of the volcano, confirming the prevailing volcanic contribution. Rainwater composition clearly reflects the volcanic plume input. Ash-normalised rainwater composition indicates a contrasting behaviour between volatile elements, which are highly-enriched in rainwater, and refractory elements, which have low rainwater/ash concentration ratios. The degree of interaction between collected ash and rainwater was variable, depending on several factors: (i) the length of the period in which tephra was present in the sampler (the ash fall may have occurred any day from the first to the last day of the rain collecting period); (ii) the amount of rainwater fallen on the collectors after the ash-fall event, and its acidity; (iii) the granulometry of the ash samples that was widely variable (from few centimetres to micrometric particles) increasing the interaction with decreasing dimensions of the grains; (iv) the distance of collector with respect to the craters. In order to investigate the role of volcanic ash on the evolution of the rainwater chemistry, absolute concentrations of rain and ash were plotted in binary plot diagrams (Figure 1). Each diagram corresponds to a single event, and pH and TDS of the solution collected is reported. The diagonal bars in the diagrams represent the rain/ash ratios (1:1 and 1:10000). The results confirm that sulphate and halide salt aerosols are adsorbed onto ash particles, and their rate of dissolution in rainwater depends on solubility. Moreover, rapid chemical weathering of the silicate glass by volcanic acid (SO2, HCl and HF) can also explain the enrichment of several refractory elements (Na, K, Ca, Mg, Si, Al, Fe, Ti, Sc). Our observations highlight how explosive activity can increase enormously the deposition rate of several chemical elements, up to several km away from the emission vents.

Description: Published

Description: Nicolosi (Catania)

Description: 1.2. TTC - Sorveglianza geochimica delle aree vulcaniche attive

Description: open