ALBERT

Notes: Coexisting Ca-poor and Ca-rich pyroxenes in granulites at Cape Riche, in the Precambrian Albany-Fraser Province, Western Australia, are dominantly chemically homogeneous within individual samples, suggesting a major episode of equilibration. However, occasional grains in a few samples contain exsolved domains interpreted as relics of an earlier, higher-T assemblage. Pyroxene pairs in ten, presumably isothermal, samples from a restricted area are used to (i) assess the suitability of several versions of the two-pyroxene thermometer for application to metamorphic rocks, and (ii) determine the thermal history of the Cape Riche pyroxenes.The various versions of the two-pyroxene thermometer applied to the well-equilibrated homogeneous pyroxene grains show poor to good precision and yield mean temperatures varying widely from 683° to 893°C, in the following order of increasing T: Lindsley (1983; opx version), 683°± 11°C; Kretz (1982; KD version), 705°± 19°C; Ross & Huebner (1975), 709°± 30°C; Kretz (1982; solvus version), 735°± 24°C; Fonarev & Graphchikov (1982; opx version), 〈750°C; Lindsley (1983; cpx version), 784°± 40°C; Fonarev & Graphchikov (1982; cpx version), ~820°± 30°C; Wood & Banno (1973), 849°± 16°C; Powell (1978), 854°± 23°C; Wells (1977), 893°± 10°C. Independent T estimates, based on mafic assemblages and garnet-biotite thermometry, suggest that the major episode of metamorphism occurred at 700-800°C (P ~ 5 kbar). Therefore the Wells, Powell, Wood & Banno and Fonarev & Graphchikov (cpx) temperatures are almost certainly too high. In the absence of a more precise independent T estimate it is difficult to assess the relative merits of the results obtained from the remaining versions of the two-pyroxene thermometer, none of which can be unequivocally demonstrated to be seriously in error, though the Lindsley (opx) T is probably too low. Other significant shortcomings evident in the results include the relatively poor precision obtained from the three methods based on purely graphical representation of the augite limb of the solvus (i.e., the Ross & Huebner, Fonarev & Graphchikov (cpx) and Lindsley (cpx) versions), and the apparent dependence of derived T on Mg/Fe2+ ratio for the Powell, Wood & Banno and Lindsley (cpx) methods.For the bulk compositions of exsolved domains, the different versions of the two-pyroxene thermometer yield mean temperatures 23° to 82°C (overall mean, 65°C) higher than for homogeneous grains in the same samples. These exsolved domains are interpreted as relics of a higher-T (peak?) metamorphic assemblage, rather than an igneous precursor.

Notes: Seismic reflection methods are being developed at the University of Manitoba to aid in determining fine crustal structure in the Precambrian of Manitoba and northwestern Ontario. Present-day environmental concern as well as mineshaft conditions necessitate the detonation of several smaller charges repeated, say, I times and followed by ‘vertical’ stacking. To obtain the familiar √I improvement in signal-to-noise (S:N) amplitude ratio applying the straight-sum (SS) method, one assumes, among other things, that both S:N ratio and signal variance are the same on all traces. Dropping these assumptions, as we must for our data, it becomes necessary to apply weighting coefficients to optimize the S:N ratio of the stacked trace. We still assume the signal shapes to be the same for repeated shots, so for the jth trace on the record of the ith shot we model the time series as: tij=ai (sj+nij); where ai is a scaling factor. The proper weights wi are then shown to be proportional to σsi/σ2ni where σ2 is variance, or to γi/ai where γi is S:N power ratio.Applying the weighted-stack (WS) method gives S:N amplitude ratios which are, on average, 55% of the optimal ratios expected from WS theory compared with only 24% for the SS method. The 45% shortfall in WS performance is ascribed mainly to trace-alignment (or time-delay) errors. Varying noise levels on individual traces, slight dissimilarity of signal shape, and correlated noise may also contribute to a lesser extent (in decreasing order of significance). This WS method appears to strike a good practical balance between S:N improvement and processing efficiency.

Notes: It is widely believed that large size creates problems for industrial relations and, conversely, that small size is beneficial. There has been little research relating size and workers' attitudes—this article reports the findings from a study in 24 factories in British manufacturing industry.

Notes: In this article the author assesses the difficulties facing democracy in the British Retail Co-operative Movement, with special reference to the role of employees on boards of directors.

Notes: Broccoli is well recognized as a source of glucosinolates and their isothiocyanate breakdown products. Glucoraphanin is one of the most abundant glucosinolates present in broccoli and its cognate isothiocyanate is sulphoraphane, a potent inducer of mammalian detoxication (phase 2) enzyme activity and anti-cancer agent. This study was designed to measure: glucosinolate levels in broccoli florets from an array of genotypes grown in several environments; the elevation of a key phase 2 enzyme, quinone reductase, in mammalian cells exposed to floret extracts; and total broccoli head content. There were significant environmental and genotype-by-environment effects on levels of glucoraphanin and quinone reductase induction potential of broccoli heads; however, the effect of genotype was greater than that of environmental factors. The relative rankings among genotypes for glucoraphanin and quinone reductase induction potential changed, when expressed on a per head basis, rather than on a concentration basis. Correlations of trait means in one environment vs. means from a second were stronger for glucoraphanin and quinone reductase induction potential on a per head basis than on a fresh weight concentration basis. Results of this study indicate that development of a broccoli phenotype with a dense head and a high concentration of glucoraphanin to deliver maximum chemoprotective potential (high enzyme induction potential/glucoraphanin content) is a feasible goal.

Notes: Biological damage to plants is commonly found from the Devonian but occurs most commonly from the Cretaceous. Damage inflicted on plants whilst they were alive may trigger a pathological response involving the growth of abnormal tissues. Much of the damage is caused by arthropods, particularly insects. Whilst some damage is non-taxon specific, such as simple feeding traces, other damage, such as leaf mines, galls or bark boring, may reveal the co-evolution of host specific taxa and the timing of such interactions. Damaged plants, particularly from the Cretaceous and Tertiary are described and illustrated. The geological history of the evolution of insect-related plant damage is briefly reviewed. Increased variety in the pathological response of plants is seen from the Cretaceous with the evolution of the angiosperms and diversification of numerous insect groups.