ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Publication Date: 2019-06-28
    Description: No abstract available
    Keywords: Aeronautics (General)
    Type: NACA-RM-E7B11b , NACA-MR-E5I20
    Format: application/pdf
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Publication Date: 2019-07-11
    Description: At the request of the Bureau of Aeronautics, Navy Department, investigations of the static-pressure losses and total-head distributions of the Westinghouse X24-C-2 inlet screen were made in the induction aerodynamics laboratory at Langley. The screen was investigated in two configurations, both before and after rounding the leading edges of the vanes. Investigations were conducted through air flows up to about pounds per second. The results of the investigations indicate that maximum lift coefficients of 1.36, 1.71 and 2.11 were measured on the model with flaps neutral and deflected 20 deg. and 55 deg, respectively, at a reynolds number of 8,600,000. When the duct inlet was replaced by a basic airfoil nose the flap neutral maximum lift coefficient was increased from 1.36 to 1.41. The results also showed that at maximum lift with flaps neutral or deflected 55 deg most of the area between the nacelles was stalled while only small areas on other portions of the model were stalled; when the duct inlet was replaced by the basic airfoil nose the stall was delayed to a slightly higher angle of attack but the nature of the stall was relatively unaffected.
    Keywords: Aeronautics (General)
    Type: NACA-RM-L6J29
    Format: application/pdf
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Publication Date: 2019-08-13
    Description: From the general dimensional and mechanical similarity theory it follows that a condition of steady motion of a given shape\bottom with constant speed on the surface of water is determined by four nondimensional parameters. By considering the various systems of independent parameters which are applied in theory and practice and special tests, there is determined their mutual relations and their suitability as planning characteristics. In studying the scale effect on the basis of the Prnndtl formula for the friction coefficient for a turbulent condition the order of magnitude is given of the error in applying the model data to full scale in the case of a single-step bottom For a bottom of complicated shape it is shown how from the test data of the hydrodynamic characteristics for one speed with various loads, or one load with various speeds, there may be obtained by simple computation with good approximation the hydrodynamic characteristics for a different speed or for a different load. (These considerations may be of use in solving certain problems on the stability of planning.) This permits extrapolating the curve of resistance against speed for large speeds inaccessible in the tank tests or for other loads which were not tested. The data obtained by computation are in good agreement with the test results. Problems regarding the optimum trim angle or the optimum width in the case of planning of a flat plate are considered from the point of view of the minimum resistance for a given load on the water and planning speeds. Formulas and graphs are given for the optimum value of the planning coefficient and the corresponding values of the trim angle and width of the flat plate.
    Keywords: Aeronautics (General)
    Type: NACA-TM-1097 , Central Aero-Hydrodynamical Institute; Report-439
    Format: application/pdf
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...