ALBERT

Description: Aerosols interact with radiation and clouds. Substantial progress made over the past 40 years in observing, understanding, and modeling these processes helped quantify the imbalance in the Earth's radiation budget caused by anthropogenic aerosols, called aerosol radiative forcing, but uncertainties remain large. This review provides a new range of aerosol radiative forcing over the industrial era based on multiple, traceable, and arguable lines of evidence, including modeling approaches, theoretical considerations, and observations. Improved understanding of aerosol absorption and the causes of trends in surface radiative fluxes constrain the forcing from aerosol-radiation interactions. A robust theoretical foundation and convincing evidence constrain the forcing caused by aerosol-driven increases in liquid cloud droplet number concentration. However, the influence of anthropogenic aerosols on cloud liquid water content and cloud fraction is less clear, and the influence on mixed-phase and ice clouds remains poorly constrained. Observed changes in surface temperature and radiative fluxes provide additional constraints. These multiple lines of evidence lead to a 68% confidence interval for the total aerosol effective radiative forcing of -1.6 to -0.6 W m−2, or -2.0 to -0.4 W m−2 with a 90% likelihood. Those intervals are of similar width to the last Intergovernmental Panel on Climate Change assessment but shifted toward more negative values. The uncertainty will narrow in the future by continuing to critically combine multiple lines of evidence, especially those addressing industrial-era changes in aerosol sources and aerosol effects on liquid cloud amount and on ice clouds. Key Points: - An assessment of multiple lines of evidence supported by a conceptual model provides ranges for aerosol radiative forcing of climate change - Aerosol effective radiative forcing is assessed to be between -1.6 and -0.6 W m−2 at the 16–84% confidence level - Although key uncertainties remain, new ways of using observations provide stronger constraints for models

Description: Key Points: - Fluid flow is focused along Nootka Fault traces resulting in shallow bright spots - Two seafloor mounds are the result of basaltic intrusions in the Nootka Fault zone - Gas hydrates occur at the Nootka Slope and are imaged seismically as bottom- simulating reflectors suggesting a regional heat-flow of ~80 mW/m2 along the slope Abstract Geophysical and geochemical data indicate there is abundant fluid expulsion in the Nootka fault zone (NFZ) between the Juan de Fuca and Explorer plates and the Nootka continental slope. Here we combine observations from 〉 20 years of investigations to demonstrate the nature of fluid‐flow along the NFZ, which is the seismically most active region off Vancouver Island. Seismicity reaching down to the upper mantle is linked to near‐seafloor manifestation of fluid flow through a network of faults. Along the two main fault traces, seismic reflection data imaged bright spots 100 – 300 m below seafloor that lie above changes in basement topography. The bright spots are conformable to sediment layering, show opposite‐to‐seafloor reflection polarity, and are associated with frequency‐reduction and velocity push‐down indicating the presence of gas in the sediments. Two seafloor mounds ~15 km seaward of the Nootka slope are underlain by deep, non‐conformable high amplitude reflective zones. Measurements in the water column above one mound revealed a plume of warm water, and bottom‐video observations imaged hydrothermal vent system biota. Pore fluids from a core at this mound contain predominately microbial methane (C1) with a high proportion of ethane (C2) yielding C1/C2 ratios 〈 500 indicating a possible slight contribution from a deep source. We infer the reflective zones beneath the two mounds are basaltic intrusions that create hydrothermal circulation within the overlying sediments. Across the Nootka continental slope, gas hydrate related bottom‐simulating reflectors are widespread and occur at depths indicating heat‐flow values of 80 – 90 mW/m2.

Description: The Atlantic Meridional Overturning Circulation (AMOC) is a key mechanism of heat, freshwater, and carbon redistribution in the climate system. The precept that the AMOC has changed abruptly in the past, notably during and at the end of the last ice age, and that it is “very likely” to weaken in the coming century due to anthropogenic climate change is a key motivation for sustained observations of the AMOC. This paper reviews the methodology and technology used to observe the AMOC and assesses these ideas and systems for accuracy, shortcomings, potential improvements, and sustainability. We review hydrographic techniques and look at how these traditional techniques can meet modern requirements. Transport mooring arrays (TMAs) provide the “gold standard” for sustained AMOC observing, utilizing dynamic height, current meter, and other instrumentation and techniques to produce continuous observations of the AMOC. We consider the principle of these systems and how they can be sustained and improved into the future. Techniques utilizing indirect measurements, such as satellite altimetry, coupled with in situ measurements, such as the Argo float array, are also discussed. Existing technologies that perhaps have not been fully exploited for estimating AMOC are reviewed and considered for this purpose. Technology is constantly evolving, and we look to the future of technology and how it can be deployed for sustained and expanded AMOC measurements. Finally, all of these methodologies and technologies are considered with a view to a sustained and sustainable future for AMOC observation.

Description: It is fundamentally important for many animal ecologists to quantify the costs of animal activities, although it is not straightforward to do so. The recording of triaxial acceleration by animal-attached devices has been proposed as a way forward for this, with the specific suggestion that dynamic body acceleration (DBA) be used as a proxy for movement-based power. Dynamic body acceleration has now been validated frequently, both in the laboratory and in the field, although the literature still shows that some aspects of DBA theory and practice are misunderstood. Here, we examine the theory behind DBA and employ modelling approaches to assess factors that affect the link between DBA and energy expenditure, from the deployment of the tag, through to the calibration of DBA with energy use in laboratory and field settings. Using data from a range of species and movement modes, we illustrate that vectorial and additive DBA metrics are proportional to each other. Either can be used as a proxy for energy and summed to estimate total energy expended over a given period, or divided by time to give a proxy for movement-related metabolic power. Nonetheless, we highlight how the ability of DBA to predict metabolic rate declines as the contribution of non-movement-related factors, such as heat production, increases. Overall, DBA seems to be a substantive proxy for movement-based power but consideration of other movement-related metrics, such as the static body acceleration and the rate of change of body pitch and roll, may enable researchers to refine movement-based metabolic costs, particularly in animals where movement is not characterized by marked changes in body acceleration.

Description: Key Points:  AUV mapping along the north rift identifies hummocky mounds with pillows, channelized, and inflated flows formed during the 2015 eruption.  Impulsive sounds formed by lava/seawater interaction track mound growth over a 28 day period with an average extrusion rate of 22-45 m3s-1.  The sounds record the history of flow advancement and inflation from multiple eruptive centers, and is used to infer volcanic activity style. Quantifying eruption dynamics in submarine environments is challenging. During the 2015 eruption of Axial Seamount, the formation of hummocky mounds along the north rift was accompanied by tens‐of‐thousands of impulsive acoustic signals generated by the interaction of lava and seawater. A catalog of these sounds was integrated with detailed seafloor mapping to better understand eruptive processes in time and space. Mounds grew over a period of 28 days with average extrusion rates of 22 to 45 m3s‐1. The most distant mounds, ~ 9.5 to 15.5 km down rift from the caldera, grew primarily over the first few days of the eruption. The focus of eruptive activity then retreated ~5 km toward the caldera where it was sustained. Mounds are constructed as a series of superimposed lobes formed through alternating periods of flow inflation, generating up to 30‐m‐thick hummocks, and periods of flow advancement, with 〈0.02 ms‐1 average speeds typically observed.

Description: The duration and magnitude of the North Atlantic spring bloom impacts both higher trophic levels and oceanic carbon sequestration. Nutrient exhaustion offers a general explanation for bloom termination, but detail on which nutrients and their relative influence on phytoplankton productivity, community structure, and physiology is lacking. Here, we address this using nutrient addition bioassay experiments conducted across the midlatitude North Atlantic in June 2017 (late spring). In four out of six experiments, phytoplankton accumulated over 48–72 h following individual additions of either iron (Fe) or nitrogen (N). In the remaining two experiments, Fe and N were serially limiting, that is, their combined addition sequentially enhanced phytoplankton accumulation. Silicic acid (Si) added in combination with N + Fe led to further chlorophyll a (Chl a) enhancement at two sites. Conversely, addition of zinc, manganese, cobalt, vitamin B12, or phosphate in combination with N + Fe did not. At two sites, the simultaneous supply of all six nutrients, in combination with N + Fe, also led to no further Chl a enhancement, but did result in an additional 30–60% particulate carbon accumulation. This particulate carbon accumulation was not matched by a Redfield equivalent of particulate N, characteristic of high C:N organic exudates that enhance cell aggregation and sinking. Our results suggest that growth rates of larger phytoplankton were primarily limited by Fe and/or N, making the availability of these nutrients the main bottom‐up factors contributing to spring bloom termination. In addition, the simultaneous availability of other nutrients could modify bloom characteristics and carbon export efficiency.

Description: Back‐arc basins open in response to subduction processes, which cause extension in the upper plate, usually along trench‐parallel spreading axes. However, global seismic databases reveal that the majority of seismic events in the Lau Basin occur along transcurrent (strike‐slip) rather than extensional faults. To better characterize active deformation in this region we compared Centroid Moment Tensors (CMTs), calculated for large (Mw 〉5), shallow (〈30 km) seismic events to the orientations of seafloor lineaments mapped throughout the Lau Basin. Ship‐based multibeam was combined with vertical gravity gradient data to provide comprehensive coverage to create the lineament map. By comparing the possible focal planes of the CMTs to the orientations of the lineaments, the most likely fault plane solutions were selected, thus classifying the faults and establishing the nature of the highly variable stress regimes in the basin. We resolved the strike, dip and dip direction of 308 faults, and classified 258 additional structures by fault type. The analysis highlights a stress regime that is dominated by a combination of left‐lateral and right‐lateral strike‐slip faults, large‐scale transcurrent motion along rigid crustal‐scale fault zones, and non‐rigid diffuse deformation along pre‐existing seafloor structures, with extension mainly limited to the tips of propagating rifts and spreading centers. By resolving many of the uncertain motions on the mapped lineaments of the Lau Basin, the CMT analysis addresses a number of questions concerning basin‐scale stress regimes and microplate development, complementing GPS measurements and providing a more complete picture of the complexities of back‐arc basin development.

Description: Key points:  First insights into the crustal structure of the northeastern Lau Basin, along a 290 km transect at 17°20’S.  Crust in southern Fonualei Rift and Spreading Center was created by extension of arc crust and variable amount of magmatism.  Magmatic underplating is present in some parts of the southern Niuafo’ou Microplate The northeastern Lau Basin is one of the fastest opening and magmatically most active back‐arc regions on Earth. Although the current pattern of plate boundaries and motions in this complex mosaic of microplates is reasonably understood, the internal structure and evolution of the back‐arc crust are not. We present new geophysical data from a 290 km long east‐west oriented transect crossing the Niuafo’ou Microplate (back‐arc), the Fonualei Rift and Spreading Centre (FRSC) and the Tofua Volcanic Arc at 17°20’S. Our P‐wave tomography model and density modelling suggests that past crustal accretion inside the southern FRSC was accommodated by a combination of arc crustal extension and magmatic activity. The absence of magnetic reversals inside the FRSC supports this and suggests that focused seafloor spreading has until now not contributed to crustal accretion. The back‐arc crust constituting the southern Niuafo’ou Microplate reveals a heterogeneous structure comprising several crustal blocks. Some regions of the back‐arc show a crustal structure similar to typical oceanic crust, suggesting they originate from seafloor spreading. Other crustal blocks resemble a structure that is similar to volcanic arc crust or a ‘hydrous’ type of oceanic crust that has been created at a spreading center influenced by slab‐derived water at distances 〈 50 km to the arc. Throughout the back‐arc region we observe a high‐velocity (Vp 7.2‐7.5 km s‐1) lower crust, which is an indication for magmatic underplating, which is likely sustained by elevated upper mantle temperatures in this region.

Description: High‐temperature hydrothermal venting has been discovered on all modern mid‐ocean ridges at all spreading rates. Although significant strides have been made in understanding the underlying processes that shape such systems, several first‐order discrepancies between model predictions and observations remain. One key paradox is that numerical experiments consistently show entrainment of cold ambient seawater in shallow high permeability ocean crust causing a temperature drop that is difficult to reconcile with high vent temperatures. We investigate this conundrum using a thermo‐hydro‐chemical model that couples hydrothermal fluid flow with anhydrite‐ and pyrite‐forming reactions in the shallow subseafloor. The models show that precipitation of anhydrite in warming seawater and in cooling hydrothermal fluids during mixing results in the formation of a chimney‐like subseafloor structure around the upwelling, high‐temperature plume. The establishment of such anhydrite‐sealed zones reduces mixing between the hydrothermal fluid and seawater and results in an increase in vent temperature. Pyrite subsequently precipitates close to the seafloor within the anhydrite chimney. Although anhydrite thus formed may be dissolved when colder seawater circulates through the crust away from the spreading axis, the inside pyrite walls would be preserved as veins in present‐day metal deposits, thereby preserving the history of hydrothermal circulation through shallow oceanic crust.

Description: The use of animal-attached data loggers to quantify animal movement has increased in popularity and application in recent years. High-resolution tri-axial acceleration and magnetometry measurements have been fundamental in elucidating fine-scale animal movements, providing information on posture, traveling speed, energy expenditure, and associated behavioral patterns. Heading is a key variable obtained from the tandem use of magnetometers and accelerometers, although few field investigations have explored fine-scale changes in heading to elucidate differences in animal activity (beyond the notable exceptions of dead-reckoning). This paper provides an overview of the value and use of animal heading and a prime derivative, angular velocity about the yaw axis, as an important element for assessing activity extent with potential to allude to behaviors, using “free-ranging” Loggerhead turtles (Caretta caretta) as a model species. We also demonstrate the value of yaw rotation for assessing activity extent, which varies over the time scales considered and show that various scales of body rotation, particularly rate of change of yaw, can help resolve differences between fine-scale behavior-specific movements. For example, oscillating yaw movements about a central point of the body's arc implies bouts of foraging, while unusual circling behavior, indicative of conspecific interactions, could be identified from complete revolutions of the longitudinal axis. We believe this approach should help identification of behaviors and “space-state” approaches to enhance our interpretation of behavior-based movements, particularly in scenarios where acceleration metrics have limited value, such as for slow-moving animals.