ALBERT

Description: Radiometer design and application at 70-gigacycles

Description: Dumbbell electrostatic ionosphere probe

Description: Ionospheric experiment for the eccentric geophysical observatory

Description: Effect of surface reactions on fatigue failure

Description: Simple circuit for phoswich scintillation counter

Description: Insulating system for receptacles of liquefied gases using wire cloth for forming frost layer

Description: Apparatus for forming wire grids for electric strain gages

Description: The local recovery factor was determined experimentally along the surface of a thin-walled 20 deg included angle cone for Mach numbers near 6.0 at stagnation temperatures between 1200 deg R and 2600 deg R. In addition, a similar cone configuration was tested at Mach numbers near 4.5 at stagnation temperatures of approximately 612 deg R. The local Reynolds number based on flow properties at the edge of the boundary layer ranged between 0.1 x 10(exp 4) and 3.5 x 10(exp 4) for tests at temperatures above 1200 deg R and between 6 x 10(exp 4) and 25 x 10(exp 4) for tests at temperatures near 612 deg R. The results indicated, generally, that the recovery factor can be predicted satisfactorily using the square root of the Prandtl number. No conclusion could be made as to the necessity of evaluating the Prandtl number at a reference temperature given by an empirical equation, as opposed to evaluating the Prandtl number at the wall temperature or static temperature of the gas at the cone surface. For the tests at temperatures above 1200 deg R (indicated herein as the tests conducted in the slip-flow region), two definite trends in the recovery data were observed - one of increasing recovery factor with decreasing stagnation pressure, which was associated with slip-flow effects and one of decreasing recovery factor with increasing temperature. The true cause of the latter trend could not be ascertained, but it was shown that this trend was not appreciably altered by the sources of error of the magnitude considered herein. The real-gas equations of state were used to determine accurately the local stream properties at the outer edge of the boundary layer of the cone. Included in the report, therefore, is a general solution for the conical flow of a real gas using the Beattie-Bridgeman equation of state. The largest effect of temperature was seen to be in the terms which were dependent upon the internal energy of the gas. The pressure and hence the pressure drag terms were unaffected.

Description: This paper is concerned with a discussion of some of the problems of flutter and aeroelasticity that are or may be important at high speeds. Various theoretical procedures for treating high Mach number flutter are reviewed. Application of two of these methods, namely, the Van Dyke method and piston-theory method, is made to a specific example and compared with linear two- and three-dimensional results. It is shown that the effects of thickness and airfoil shape are destabilizing as compared with linear theory at high Mach number. In order to demonstrate the validity of these large predicted effects, experimental flutter results are shown for two rectangular wings at Mach numbers of 6.86 and 3. The results of nonlinear piston-theory calculations were in good agreement with experiment, whereas the results of using two- and three-dimensional linear theory were not. In addition, some results demonstrating the importance of including camber modes in a flutter analysis are shown, as well as a discussion of one case of flutter due to aerodynamic heating.

Description: Heat-transfer rates to two surfaces having widely different catalytic effectiveness are compared at a Mach number of 6 in a low-density stream of partially dissociated nitrogen. The heat-transfer rate to a polished copper cylinder is twice as great as the heat-transfer rate to a silicon-monoxide-coated cylinder when the stream total energy content is 9000 Btu/lb. Various methods for determining the stream energy content, the stream velocity, and the stream Mach number have been developed and compared. It is shown that methods for estimating the stream energy content by means of purely aerodynamic concepts may neglect the sizable fraction of the stream energy contained in molecular dissociation.