ALBERT — All Library Books, journals and Electronic Records Telegrafenberg

1

Unbekannt

Preliminary Wind-Tunnel Investigation of the Performance of Republic F-105 Wing-Root Inlet Configurations at Various Angles of Attack and a Mach Number of 2.01 (1957)

Kouyoumjian, W. L.

In: CASI

zur Merkliste hinzufügen auf der Merkliste

Details

Publikationsdatum: 2019-05-31

Beschreibung: A 1/13-scale model of the forebody of the Republic F-105 with twin-duct wing-root inlets was tested in the Langley 4- by 4-foot supersonic pressure tunnel through a range of angle of attack from -4 deg to 15 deg at a Mach number of 2.01 and a Reynolds number of approximately 3.4 x 10(exp 6) per foot. The tests were made with four configurations which incorporated varying amounts of sweep and stagger of the inlet leading edges, modifications to the areas of the boundary-layer diverter floor plate, and modifications to the area of the boundary-layer diverter bleed slots. The highest overall pressure recovery at an angle of attack of 0 deg (average total-pressure recovery, 0.84 mass-flow ratio, 0.98) was achieved with configuration having an inlet leading-edge sweep angle of 58 deg with no leading-edge stagger. Stagger was found to improve the angle-of- attack performance, but at a sacrifice in inlet efficiency for an angle of attack of 0 deg. The boundary-layer diverter floor height, of the order of one boundary-layer thickness, was satisfactory for bypassing the fuselage boundary layer. The boundary-layer diverter-plate bleed slots were effective in increasing the total-pressure recovery of the inlet. The total-pressure-recovery contour plots, taken at the compressor-face station, indicate the existence of high-velocity "cores" throughout the inlet operating range.

Schlagwort(e): Aerodynamics

Materialart: NACA-RM-SL56L12

Format: application/pdf

Permalink

	Standort	Signatur	Erwartet	Verfügbarkeit

Andere fanden auch interessant ...

NASA TECHNICAL REPORTS

S·F·X

Überblick

2

Unbekannt

Systematic Two-Dimensional Cascade Tests of NACA 65-Series Compressor Blades at Low Speeds (1951)

Herrig, L. Joseph ; Erwin, John R. ; Emery, James C.

In: CASI

zur Merkliste hinzufügen auf der Merkliste

Details

Publikationsdatum: 2019-06-28

Beschreibung: The performance of NACA 65-series compressor blade section in cascade has been investigated systematically in a low-speed cascade tunnel. Porous test-section side walls and for high-pressure-rise conditions, porous flexible end walls were employed to establish conditions closely simulating two-dimensional flow. Blade sections of design lift coefficients from 0 to 2.7 were tested over the usable angle-of-attack range for various combinations of inlet-flow angle. A sufficient number of combinations were tested to permit interpolation and extrapolation of the data to all conditions within the usual range of application. The results of this investigation indicate a continuous variation of blade-section performance as the major cascade parameters, blade camber, inlet angle, and solidity were varied over the test range. Summary curves of the results have been prepared to enable compressor designers to select the proper blade camber and angle of attack when the compressor velocity diagram and desired solidity have been determined.

Schlagwort(e): Aerodynamics

Materialart: NACA-TR-1368 , NACA-RM-L51G31

Format: application/pdf

Permalink

	Standort	Signatur	Erwartet	Verfügbarkeit

Andere fanden auch interessant ...

NASA TECHNICAL REPORTS

S·F·X

Überblick

3

Unbekannt

Aerodynamic Characteristics of a Flying-Boat Hull Having a Length-Beam Ratio of 15, TED No. NACA 2206 (1951)

Riebe, John M. ; Naeseth, Rodger L.

In: CASI

zur Merkliste hinzufügen auf der Merkliste

Details

Publikationsdatum: 2019-07-11

Beschreibung: An investigation was made in the Langley 300 MPH 7- by 10-foot tunnel to determine the aerodynamic characteristics of a flying-boat hull of a length-beam ratio of 15 in the presence of a wing. The investigation was an extension of previous tests made on hulls of length-beam ratios of 6, 9, and 12; these hulls were designed to have approximately the same hydrodynamic performance with respect to spray and resistance characteristics. Comparison with the previous investigation at lower length-beam ratios indicated a reduction in minimum drag coefficients of 0.0006 (10 peroent)with fixed transition when the length-beam ratio was extended from 12 to 15. As with the hulls of lower length-beam ratio, the drag reduction with a length-beam ratio of 15 occurred throughout the range of angle of attack tested and the angle of attack for minimum drag was in the range from 2deg to 3deg. Increasing the length-beam ratio from 12 to 15 reduced the hull longitudinal instability by an mount corresponding to an aerodynamic-center shift of about 1/2 percent of the mean aerodynamic chord of the hypothetical flying boat. At an angle of attack of 2deg, the value of the variation of yawing-moment coefficient with angle of yaw for a length-beam ratio of 15 was 0.00144, which was 0.00007 larger than the value for a length-beam ratio of 12.

Schlagwort(e): Aerodynamics

Materialart: NACA-RM-L6J24

Format: application/pdf

Permalink

	Standort	Signatur	Erwartet	Verfügbarkeit

Andere fanden auch interessant ...

NASA TECHNICAL REPORTS

S·F·X

Überblick

4

Unbekannt

Effects of Inlet Modification and Rocket-Rack Extension on the Longitudinal Trim and Low-Lift Drag of the Douglas F5D-1 Airplane as Obtained with a 0.125-Scale Rocket-Boosted Model Between Mach Numbers of 0.81 and 1.64: TED No. NACA AD 399 (1957)

Dickens, Waldo L. ; Hastings, Earl C., Jr.

In: CASI

zur Merkliste hinzufügen auf der Merkliste

Details

Publikationsdatum: 2019-07-10

Beschreibung: A flight investigation was conducted to determine the effects of inlet modification and rocket-rack extension on the longitudinal trim and low-lift drag of the Douglas F5D-1 airplane. The investigation was conducted with a 0.125-scale rocket-boosted model between Mach Numbers of 0.81 and 1.64. This paper presents the changes in trim angle of attack, trim lift coefficient, and low-lift drag caused by the modified inlets alone over a small part of the test Mach number range and by a combination of the modified inlets and extended rocket racks throughout the remainder of the test.

Schlagwort(e): Aerodynamics

Materialart: NACA-RM-SL57D30

Format: application/pdf

Permalink

	Standort	Signatur	Erwartet	Verfügbarkeit

Andere fanden auch interessant ...

NASA TECHNICAL REPORTS

S·F·X

Überblick

5

Unbekannt

Investigation of Drag and Static Longitudinal and Lateral Stability and Control Characteristics of 1/20-Scale Model of McDonnell F4H-1 Airplane at Mach Numbers of 1.57, 1.87, 2.16, and 2.53. Phase II Model (1957)

Turner, Kenneth L. ; Carmel, Melvin M.

In: CASI

zur Merkliste hinzufügen auf der Merkliste

Details

Publikationsdatum: 2019-07-12

Beschreibung: Tests were performed in the Langley Unitary Plan wind tunnel to determine the drag and static longitudinal and lateral stability and control characteristics of a 1/20-scale model of the McDonnell F4H-1 airplane at Mach numbers of 1 57, 1 87, 2.16, and 2.53. This is the second phase in a series of tests performed on this model. The Reynolds numbers for these tests, based on the mean aerodynamic chord of the wing, are 1.446 x 10 (exp 6), 1.269 x 10 (exp 6), 1.116 x 10 (exp 6), and 0.714 x 10 (exp 6) at Mach numbers of 1.57, 1.87, 2.16, and 2.53, respectively. The model had a 12 deg. wing tip dihedral, a larger vertical tail, and a modified duct.

Schlagwort(e): Aerodynamics

Materialart: NACA-RM-SL7A14

Format: application/pdf

Permalink

	Standort	Signatur	Erwartet	Verfügbarkeit

Andere fanden auch interessant ...

NASA TECHNICAL REPORTS

S·F·X

Überblick