ALBERT

Description: We use traveltime data of local earthquakes and controlled sources observed by a large, temporary, amphibious seismic network to reveal the anatomy of the southcentral Chilean subduction zone (37–39°S) between the trench and the magmatic arc. At this location the giant 1960 earthquake (M = 9.5) nucleated and ruptured almost 1000 km of the subduction megathrust. For the three-dimensional tomographic inversion we used 17,148 P wave and 10,049 S wave arrival time readings from 439 local earthquakes and 94 shots. The resolution of the tomographic images was explored by analyzing the model resolution matrix and conducting extensive numerical tests. The downgoing lithosphere is delineated by high seismic P wave velocities. High v p/v s ratio in the subducting slab reflects hydrated oceanic crust and serpentinized uppermost oceanic mantle. The subducting oceanic crust can be traced down to a depth of 80 km, as indicated by a low velocity channel. The continental crust extends to approximately a 50-km depth near the intersection with the subducting plate. This suggests a wide contact zone between continental and oceanic crust of about 150 km, potentially supporting the development of large asperities. Eastward the crustal thickness decreases again to a minimum of about a 30-km depth. Relatively low v p/v s at the base of the forearc does not support a large-scale serpentinization of the mantle wedge. Offshore, low v p and high v p/v s reflect young, fluid-saturated sediments of forearc basins and the accretionary prism.

Description: Providing quantitative microzonation results that can be taken into account in urban land-use plans is a challenging task that requires collaborative efforts between the seismological and engineering communities. In this study, starting from the results obtained by extensive geophysical and seismological investigations, we propose and apply an approach to the Gubbio basin (Italy) that can be easily implemented for cases of moderate-to-low ground motion and that takes into account not only simple 1D, but also more complicated 3D effects. With this method, the sites inside the basin are classified by their fundamental resonance frequencies, estimated from the horizontal-to-vertical spectral ratio applied to noise recordings (HVNSR). The correspondence between estimates of the fundamental frequency from this method and those derived from earthquake recordings was verified at several calibration sites. The amplification factors used to correct the response spectra are computed by the ratio between the response spectra at sites within the basin and the response spectra at a hard-rock site using data from two seismic transects. Empirical amplification functions are then assigned to the fundamental frequencies after applying an interpolation technique. The suitability of the estimated site-specific correction factors for response spectra was verified by computing synthetic response spectra for stations within the basin, starting from the synthetic recording at a nearby rock station, and comparing them with observed ones.

Description: A temporal seismic network recorded local seismicity along a 130 km long segment of the transpressional dextral strike-slip Liquiñe-Ofqui fault zone (LOFZ) in southern Chile. Seventy five shallow crustal events with magnitudes up to M(tief)w 3.8 and depths shallower than 25 km were observed in an 11-month period mainly occurring in different clusters. Those clusters are spatially related to the LOFZ, to the volcanoes Chaitén, Michinmahuida and Corcovado, and to active faulting on secondary faults. Further activity along the LOFZ is indicated by individual events located in direct vicinity of the surface expression of the LOFZ. Focal mechanisms were calculated using deviatoric moment tensor inversion of body wave amplitude spectra which mostly yield strike-slip mechanisms indicating a NE–SW direction of the P-axis for the LOFZ at this latitude. The seismic activity reveals the present-day activity of the fault zone. The recent M(tief)w 6.2 event near Puerto Aysén, Southern Chile at 45.4°S on April 21, 2007 shows that the LOFZ is also capable of producing large magnitude earthquakes and therefore imposing significant seismic hazard to this region.

Description: We propose a new rapid procedure for determining the energy magnitude Me for shallow events from broadband teleseismic P-wave signals within the distance range 20°–98°. To accomplish this task, we compute spectral amplitude decay functions for different periods using numerical simulations based on the reference Earth model AK135Q. By means of these functions, we correct the spectra of the teleseismic recordings for the propagation path effects, and calculate the radiated seismic energy ES, and hence Me. We use cumulative P-wave windows for simulating a real- or near real-time procedure and test it for 61 shallow earthquakes. The results show that our approach is able to provide a rapid and reliable Me determination within 7–15 minutes after the earthquake origin time, and is therefore suitable for implementation in rapid response systems.

Description: Using three different short-period electromagnetic sensors with resonance frequencies of 1 Hz (Mark L4C-3D), 2 Hz (Mark L-22D), and 4.5 Hz (I/O SM-6), coupled with three digital acquisition system, the portable data acquisition system (PDAS) Teledyne Geotech, the refraction technology (REFTEK) 72A, and the Earth Data Logger PR6-24 (EDL), the effect of the seismic instruments on the horizontal-to-vertical spectral ratio (H/V) using seismic noise for frequencies less than 1 Hz has been evaluated. For all possible sensors–acquisition system pairs, the background seismic signal and instrumental self-noise power spectral densities have been calculated and compared. The results obtained when coupling the short-period sensors with different acquisition systems show that the performance of the considered instruments at frequencies 〈1 Hz strongly depends upon the sensor–acquisition system combination and the gain used, with the best performance obtained for sensors with the lowest resonance frequency. For all acquisition systems, it was possible to retrieve correctly the H/V peak down to 0.1–0.2 Hz by using a high gain and a 1-Hz sensor. In contrast, biased H/V spectral ratios were retrieved when low-gain values were considered. Particular care is required when using 4.5-Hz sensors, because they may not even allow the fundamental resonance frequency peak to be reproduced.

Description: Combined P and S receiver functions from seismograms of teleseismic events recorded at 65 temporary and permanent stations in the Aegean region are used to map the geometry of the subducted African and the overriding Aegean plates. We image the Moho of the subducting African plate at depths ranging from 40 km beneath southern Crete and the western Peloponnesus to 160 km beneath the volcanic arc and 220 km beneath northern Greece. However, the dip of the Moho of the subducting African plate is shallower beneath the Peloponnesus than beneath Crete and Rhodes and flattens out beneath the northern Aegean. Observed P-to-S conversions at stations located in the forearc indicate a reversed velocity contrast at the Moho boundary of the Aegean plate, whereas this boundary is observed as a normal velocity contrast by the S-to-P conversions. Our modeling suggests that the presence of a large amount of serpentinite (more than 30%) in the forearc mantle wedge, which generally occurs in the subduction zones, may be the reason for the reverse sign of the P-to-S conversion coefficient. Moho depths for the Aegean plate show that the southern part of the Aegean (crustal thickness of 20–22 km) has been strongly influenced by extension, while the northern Aegean Sea, which at present undergoes the highest crustal deformation, shows a relatively thicker crust (25–28 km). This may imply a recent initiation of the present kinematics in the Aegean. Western Greece (crustal thickness of 32–40 km) is unaffected by the recent extension but underwent crustal thickening during the Hellenides Mountains building event. The depths of the Aegean Moho beneath the margin of the Peloponnesus and Crete (25–28 and 25–33 km, respectively) show that these areas are also likely to be affected by the Aegean extension, even though the Cyclades (crustal thickness of 26–30 km) were not significantly involved in this episode. The Aegean lithosphere-asthenosphere boundary (LAB) mapped with S receiver functions is about 150 km deep beneath mainland Greece, whereas the LAB of the subducted African plate dips from 100 km beneath Crete and the southern Aegean Sea to about 225 km under the volcanic arc. This implies a thickness of 60–65 km for the subducted African lithosphere, suggesting that the Aegean lithosphere was not significantly affected by the extensional process associated with the exhumation of metamorphic core complexes in the Cyclades.

Description: This study focuses on the present-day deformation mechanisms of the south central Chile margin, at the transition zone between two megathrust earthquake segments defined from historical data: the Valdivia and Concepción sectors. New GPS data and finite-element models with complex geometries constrained by geophysical data are presented to gain insight into forearc kinematics and to address the role of upper plate faults on contemporary deformation. GPS vectors are heterogeneously distributed in two domains that follow these two earthquake segments. We find that models which simulate only interseismic locking on the plate interface fail to reproduce surface deformation in the entire study area. In the Concepción domain, models that include a crustal-scale fault in the upper plate better reproduce the GPS observations. In the Valdivia domain, GPS data show regional-scale vertical axis rotations, which could reflect postseismic deformation processes at the edge of the Mw 9.5 earthquake that ruptured in 1960 and/or activity of another crustal fault related to motion of a forearc sliver. Our study suggests that upper plate faults in addition to earthquake cycle transients may exert an important control on the surface velocity of subduction zone forearcs.

Description: The volcanic arc of the Hellenic subduction zone with its four volcanic centers is of major relevance when evaluating the seismovolcanic hazard for the Aegean region. We present results from a 22-station temporary seismic network (CYCNET) in the central Hellenic Volcanic Arc (HVA). CYCNET recordings allow to analyze the level and spatio-temporal evolution of microseismic activity in this region for the first time. A total of 2175 events recorded between September 2002 and July 2004 are analyzed using statistical methods, cluster analysis and relative relocation techniques. We identify distinct regions with significantly varying spatio-temporal behavior of microseismicity. A large portion of the seismic activity within the upper crust is associated with the presence of islands representing horst structures that were generated during the major Oligocene extensional phase. In contrast, the central part of the Cyclades metamorphic core complex remains aseismic considering our magnitude threshold of 1.8 except one spot where events occur swarm-like and with highly similar waveforms. The highest activity in the study area was identified along the SW–NE striking Santorini–Amorgos zone. Within this zone the submarine Columbo volcano exhibits strong temporal variations of seismic activity on a high background level. This activity is interpreted to be directly linked to the magma reservoir and therein the migration of magma and fluids towards the surface. NE of Columbo where no volcanic activity has yet been reported we observe a similar seismicity pattern with small-scaled activity spots that might represent local pathways of upward migrating fluids or even developing volcanic activity within this zone of crustal weakness. In contrast, the Santorini and Milos volcanic complexes do not show significant temporal variations and low to moderate background activity, respectively. Relating our results to the distribution of historical earthquakes and the GPS-derived horizontal velocity field we conclude that the Santorini–Amorgos zone is presently in the state of right-lateral transtension reflecting a major structural boundary of the volcanic arc subdividing it into a seismically and volcanically quiet western and an active eastern part.