ALBERT

Description: Author Posting. © American Geophysical Union, 2009. This article is posted here by permission of American Geophysical Union for personal use, not for redistribution. The definitive version was published in Journal of Geophysical Research 114 (2009): B02212, doi:10.1029/2008JB006132.

Description: We used ultrasonic pulse transmission to measure compressional, P, and shear, S, wave speeds in laboratory-formed polycrystalline ice Ih, sI methane hydrate, and sII methane-ethane hydrate. From the wave speed's linear dependence on temperature and pressure and from the sample's calculated density, we derived expressions for bulk, shear, and compressional wave moduli and Poisson's ratio from −20 to −5°C and 22.4 to 32.8 MPa for ice Ih, −20 to 15°C and 30.5 to 97.7 MPa for sI methane hydrate, and −20 to 10°C and 30.5 to 91.6 MPa for sII methane-ethane hydrate. All three materials had comparable P and S wave speeds and decreasing shear wave speeds with increasing applied pressure. Each material also showed evidence of rapid intergranular bonding, with a corresponding increase in wave speed, in response to pauses in sample deformation. There were also key differences. Resistance to uniaxial compaction, indicated by the pressure required to compact initially porous samples, was significantly lower for ice Ih than for either hydrate. The ice Ih shear modulus decreased with increasing pressure, in contrast to the increase measured in both hydrates.

Description: This work was supported by NSF grant OCE-97-10506, DOE grants DE-FG0386ER 13601 and DE-FG07-96ER 14723, DOE/LLNL contract W-7405-ENG-48, GRI grant 5094-210-3235- 1, NEDO, as well as by the U.S. Geological Survey’s Coastal and Marine Geology and Eastern Region Gas Hydrate Programs.

Description: Author Posting. © American Geophysical Union, 2009. This article is posted here by permission of American Geophysical Union for personal use, not for redistribution. The definitive version was published in Journal of Geophysical Research 114 (2009): B04299, doi:10.1029/2009JB006451.

Description: This paper is not subject to U.S. copyright. The definitive version was published in Geophysical Journal International 169 (2007), 767–774, doi:10.1111/j.1365-246X.2007.03382.x.

Description: Thermal conductivity, thermal diffusivity and specific heat of sI methane hydrate were measured as functions of temperature and pressure using a needle probe technique. The temperature dependence was measured between −20°C and 17°C at 31.5 MPa. The pressure dependence was measured between 31.5 and 102 MPa at 14.4°C. Only weak temperature and pressure dependencies were observed. Methane hydrate thermal conductivity differs from that of water by less than 10 per cent, too little to provide a sensitive measure of hydrate content in water-saturated systems. Thermal diffusivity of methane hydrate is more than twice that of water, however, and its specific heat is about half that of water. Thus, when drilling into or through hydrate-rich sediment, heat from the borehole can raise the formation temperature more than 20 per cent faster than if the formation's pore space contains only water. Thermal properties of methane hydrate should be considered in safety and economic assessments of hydrate-bearing sediment.

Description: Gas Hydrate Project of the U.S. Geological Survey’s Coastal and Marine Geology Program, in addition to Department of Energy contract DE-AI21–92MC29214

Description: After 83 yr, the great normal-faulting earthquake of 1933 March 2, which took place off the Japan Trench and produced a devastating tsunami on the Sanriku coast and damaging waves in Hawaii, remains the largest recorded normal-faulting earthquake. This study uses advanced methods to investigate this event using far-field seismological and tsunami data and complements a sister study by Uchida et al. which used exclusively arrival times at Japanese stations. Our relocation of the main shock (39.22°N, 144.45°E, with a poorly constrained depth of less than 40 km) places it in the outer trench slope, below a seafloor depth of ~6500 m, in a region of horst-and-graben structure, with fault scarps approximately parallel to the axis of the Japan Trench. Relocated aftershocks show a band of genuine shallow aftershocks parallel to the Japan Trench under the outer trench slope and a region of post-mainshock events landward of the trench axis that occur over roughly the same latitude range and are thought to be the result of stress transfer to the interplate thrust boundary following the normal-faulting rupture. Based on a combination of P -wave first motions and inversion of surface wave spectral amplitudes, we propose a normal-faulting focal mechanism ( = 200°, = 61° and = 271°) and a seismic moment M 0 = (7 ± 1) x 10 28 dyn cm ( M w = 8.5). A wide variety of data, including the distribution of isoseismals, the large magnitudes (up to 8.9) proposed by early investigators before the standardization of magnitude scales, estimates of energy-to-moment ratios and the tentative identification of a T wave at Pasadena (and possibly Riverside), clearly indicate that this seismic source was exceptionally rich in high-frequency wave energy, suggesting a large apparent stress and a sharp rise time, and consistent with the behaviour of many smaller shallow normal-faulting earthquakes. Hydrodynamic simulations based on a range of possible sources consistent with the above findings, including a compound rupture on two opposite-facing normal-faulting segments, are in satisfactory agreement with tsunami observations in Hawaii, where run-up reached 3 m, causing significant damage. This study emphasizes the need to include off-trench normal-faulting earthquake sources in global assessments of tsunami hazards emanating from the subduction of old and cold plates, whose total length of trenches exceed 20 000 km, even though only a handful of great such events are known with confidence in the instrumental record.

Description: The aftershock distribution of the 1933 Sanriku-oki outer trench earthquake is estimated by using modern relocation methods and a newly developed velocity structure to examine the spatial extent of the source-fault and the possibility of a triggered interplate seismicity. In this study, we first examined the regional data quality of the 1933 earthquake based on smoked-paper records and then relocated the earthquakes by using the 3-D velocity structure and double-difference method. The improvements of hypocentre locations using these methods were confirmed by the examination of recent earthquakes that are accurately located based on ocean bottom seismometer data. The results show that the 1933 aftershocks occurred under both the outer- and inner-trench-slope regions. In the outer-trench-slope region, aftershocks are distributed in a ~280-km-long area and their depths are shallower than 50 km. Although we could not constrain the fault geometry from the hypocentre distribution, the depth distribution suggests the whole lithosphere is probably not under deviatoric tension at the time of the 1933 earthquake. The occurrence of aftershocks under the inner trench slope was also confirmed by an investigation of waveform frequency difference between outer and inner trench earthquakes as recorded at Mizusawa. The earthquakes under the inner trench slope were shallow (depth less double equals30 km) and the waveforms show a low-frequency character similar to the waveforms of recent, precisely located earthquakes in the same area. They are also located where recent activity of interplate thrust earthquakes is high. These suggest that the 1933 outer-trench-slope main shock triggered interplate earthquakes, which is an unusual case in the order of occurrence in contrast with the more common pairing of a large initial interplate shock with subsequent outer-slope earthquakes. The off-trench earthquakes are distributed about 80 km width in the trench perpendicular direction. This wide width cannot be explained from a single high-angle fault confined at a shallow depth (depth less double equals50 km). The upward motion of the 1933 tsunami waveform records observed at Sanriku coast also cannot be explained from a single high-angle west-dipping normal fault. If we consider additional fault, involvement of high-angle, east-dipping normal faults can better explain the tsunami first motion and triggering of the aftershock in a wide area under the outer trench slope. Therefore multiple off-trench normal faults may have activated during the 1933 earthquake. We also relocated recent (2001–2012) seismicity by the same method. The results show that the present seismicity in the outer-trench-slope region can be divided into several groups along the trench. Comparison of the 1933 rupture dimensions based on our aftershock relocations with the morphologies of fault scarps in the outer trench slope suggest that the rupture was limited to the region where fault scarps are largely trench parallel and cross cut the seafloor spreading fabric. These findings imply that bending geometry and structural segmentation of the incoming plate largely controls the spatial extent of the 1933 seismogenic faulting. In this shallow rupture model for this largest outer trench earthquake, triggered seismicity in the forearc and structural control of faulting represent an important deformation styles for off-trench and shallow megathrust zones.

Description: Using older and in part flawed data, Ruff (1989) suggested that thick sediment entering the subduction zone (SZ) smooths and strengthens the trench-parallel distribution of interplate coupling. This circumstance was conjectured to favor rupture continuation and the generation of high-magnitude (≥Mw8.0) interplate thrust (IPT) earthquakes. Using larger and more accurate compilations of sediment thickness and instrumental (1899 to January 2013) and pre-instrumental era (1700–1898) IPTs (n = 176 and 12, respectively), we tested if a compelling relation existed between where IPT earthquakes ≥Mw7.5 occurred and where thick (≥1.0 km) versus thin (≤1.0 km) sedimentary sections entered the SZ. Based on the new compilations, a statistically supported statement (see Summary and Conclusions) can be made that high-magnitude earthquakes are most prone to nucleate at well-sedimented SZs. For example, despite the 7500 km shorter global length of thick-sediment trenches, they account for ~53% of instrumental era IPTs ≥Mw8.0, ~75% ≥Mw8.5, and 100% ≥Mw9.1. No megathrusts 〉Mw9.0 ruptured at thin-sediment trenches, whereas three occurred at thick-sediment trenches (1960 Chile Mw9.5, 1964 Alaska Mw9.2, and 2004 Sumatra Mw9.2). However, large Mw8.0–9.0 IPTs commonly (n = 23) nucleated at thin-sediment trenches. These earthquakes are associated with the subduction of low-relief ocean floor and where the debris of subduction erosion thickens the plate-separating subduction channel. The combination of low bathymetric relief and subduction erosion is inferred to also produce a smooth trench-parallel distribution of coupling posited to favor the characteristic lengthy rupturing of high-magnitude IPT earthquakes. In these areas subduction of a weak sedimentary sequence further enables rupture continuation.

Description: Eclogitization of the basaltic and gabbroic layer in the oceanic crust involves a volume reduction of 10%–15%. One consequence of the negative volume change is the formation of a paired stress field as a result of strain compatibility across the reaction front. Here we use waveform analysis of a tiny seismic cluster in the lower crust of the downgoing Pacific plate and reveal new evidence in favor of this mechanism: tensional earthquakes lying 1 km above compressional earthquakes, and earthquakes with highly similar waveforms lying on well-defined planes with complementary rupture areas. The tensional stress is interpreted to be caused by the dimensional mismatch between crust transformed to eclogite and underlying untransformed crust, and the earthquakes are probably facilitated by reactivation of fossil faults extant in the subducting plate. These observations provide seismic evidence for the role of volume change–related stresses and, possibly, fluid-related embrittlement as viable processes for nucleating earthquakes in downgoing oceanic lithosphere.