ALBERT

Description: This document contains a description of a comprehensive database that is to be used for certification testing of airborne forward-look windshear detection systems. The database was developed by NASA Langley Research Center, at the request of the Federal Aviation Administration (FAA), to support the industry initiative to certify and produce forward-look windshear detection equipment. The database contains high resolution, three dimensional fields for meteorological variables that may be sensed by forward-looking systems. The database is made up of seven case studies which have been generated by the Terminal Area Simulation System, a state-of-the-art numerical system for the realistic modeling of windshear phenomena. The selected cases represent a wide spectrum of windshear events. General descriptions and figures from each of the case studies are included, as well as equations for F-factor, radar-reflectivity factor, and rainfall rate. The document also describes scenarios and paths through the data sets, jointly developed by NASA and the FAA, to meet FAA certification testing objectives. Instructions for reading and verifying the data from tape are included.

Description: This paper compares the observed behavior of the (F2) layer of the ionosphere at Millstone Hill and Hobart with calculations from the field line interhemispheric plasma (FLIP) model for solar maximum, solstice conditions in 1990. During the study period the daily F(sub 10.7) index varied by more than a factor of 2 (123 to 280), but the 81-day mean F(sub 10.7) (F(sub 10.7 A)) was almost constant near 190. Calculations were performed with and without the effects of vibrationally excited N2 (N(sup *)(sub 2) which affects the loss rate of atomic oxygen ions. In the case without N(sup *)(sub 2) there is generally good agreement between the model and measurement for the daytime, peak density of the F region (NmF2). Both the model and the measurement show a strong seasonal anomaly with the winter noon densities a factor of 3 to 4 greater than the summer noon densities at Millstone Hill and a factor of 2 greater at Hobart. The seasonal anomaly in the model is caused by changes in the neutral composition as given by the mass spectrometer and incoherent scatter (MSIS) 86 neutral density model. There is generally little or no increase in the observed noon NmF2 as a function of daily F(sub 10.7) except at Millstone Hill in winter. In contrast to the generally good agreement between model and data at noon, the model badly underestimates the density at night at Millstone Hill at all seasons. At Hobart the model reproduces the nighttime density variations well in both winter and summer. The international reference ionosphere (IRI) model generally provides a good representation of the average behavior of noon NmF2 and hmF2 but because the data show a lot of day-to-day variability, there are often large differences. The FLIP model is able to reproduce this variability when hmF2 is specified. The IRI model peak densities are better than the FLIP densities at night, but the IRI model does not represent the Millstone Hill summer data very well at night in 1990.

Description: Formulas are presented that parameterize the heating rate and coefficient of turbulent heat conduction produced by saturated internal gravity waves (IGW) in the upper atmosphere. Estimates of these values are made using observational data. The parameterization of IGW influences are introduced into a one-dimensional model of global mean thermal and composition balances of the upper atmosphere. Computations are performed for different values of IGW energy fluxes entering into the upper atmosphere from below. It is shown that realistic vertical profiles of the global mean temperature can be obtained using different values of IGW energy flux into the upper atmosphere. Increasing the IGW intensity leads not only to an increase of the heating rate due to wave enery dissipation, but also to an increase of the heating rate due to wave energy dissipation, but also to an increase in the coefficient of turbulent heat conduction and cooling rate produced by turbulence generated by the wave. So, near an altitude of 100 km the main part of solar heating is compensated by infrared cooling on one hand, and the main part of wave dissipation heating is compensated by turbulent cooling on the other hand. These quasi-balances generally hold for different values of IGW intensity.

Description: The usefulness of the radiances measured by operational satellites in deriving radiation budgets is demonstrated by comparing the model calculations with the Earth Radiation Budget Experiment (ERBE) fluxes. The radiation budgets in the atmosphere and at the surface in the western tropical Pacific are computed by coupling radiative transfer models to satellite retrievals of cloud and the earth surface parameters for April 1985 and April 1987. The model-computed fluxes at the top of the atmosphere agree well with the ERBE fluxes in both the solar and IR spectral regions. The difference is greater than 10 W/sq m in the outgoing longwave flux and greater than 15 W/sq m in the net downward shortwave flux. The agreement indicates that long-term earth radiation budgets in the tropical Pacific can be computed using the radiances measured by operational satellites.

Description: Two independent datasets for the solar radiation at the surface derived from satellites are compared. The data derived from the Earth Radiation Budget Experiment (ERBE) is for the net solar radiation at the surface whereas the International Satellite Cloud Climatology Project (ISCCP) data is for the downward flux only and was corrected with a space- and time-varying albedo. The ISCCP net flux is at all times higher than the ERBE flux. The difference can be divided into an offset that decreases with latitude and another component that correlates with high tropical cloud cover. With this latter exception the two datasets provide spatial patterns of solar flux that are very similar. A tropical Pacific Ocean model is forced with these two datasets and observed climatological winds. The upward heat flux is parameterized taking into account separately the longwave radiative, latent, and sensible heat fluxes. Best fit values for the uncertain parameters are found using an optimization procedure that seeks to minimize the difference between model and observed SST by varying the parameters within a reasonable range of uncertainty. The SST field the model produces with the best fit parameters is the best the model can do. If the differences between the model and data are larger than can be accounted for by remaining uncertainties in the heat flux parameterization and forcing data then the ocean model must be held to be at fault. Using this method of analysis, a fundamental model fault is identified. Inadequate treatment of mixed layer/entrainment processes in upwelling regions of the eastern tropical Pacific leads to a large and seasonally varying error in the model SST. Elsewhere the model SST is insufficiently different from observed to be able to identify model errors.

Description: In this paper a scheme is proposed to use a point raingage to compare contemporaneous measurements of rain rate from a single-field-of-view (FOV) estimate based on a satellite remote sensor such as a microwave radiometer. Even in the ideal case the measurements are different because one is at a point and the other is an area average over the field of view. Also the point gage will be located randomly inside the field of view on different overpasses. A space-time spectral formalism is combined with a simple stochastic rain field to find the mean-square deviations between the two systems. It is found that by combining about 60 visits of the satellite to the ground-truth site, the expected error can be reduced to about 10% of the standard deviation of the fluctuations of the systems alone. This seems to be a useful level of tolerance in terms of isolating and evaluating typical biases that might be contaminating retrieval algorithms.

Description: Much of the new record of broadband earth radiation budget satellite measurements to be obtained during the late 1990s and early twenty-first century will come from the dual-radiometer Clouds and Earth's Radiant Energy System Instrument (CERES-I) flown aboard sun-synchronous polar orbiters. Simulation studies conducted in this work for an early afternoon satellite orbit indicate that spatial root-mean-square (rms) sampling errors of instantaneous CERES-I shortwave flux estimates will range from about 8.5 to 14.0 W/m on a 2.5 deg latitude and longitude grid resolution. Rms errors in longwave flux estimates are only about 20% as large and range from 1.5 to 3.5 W/sq m. These results are based on an optimal cross-track scanner design that includes 50% footprint overlap to eliminate gaps in the top-of-the-atmosphere coverage, and a 'smallest' footprint size to increase the ratio in the number of observations lying within to the number of observations lying on grid area boundaries. Total instantaneous measurement error also depends on the variability of anisotropic reflectance and emission patterns and on retrieval methods used to generate target area fluxes. Three retrieval procedures from both CERES-I scanners (cross-track and rotating azimuth plane) are used. (1) The baseline Earth Radiaton Budget Experiment (ERBE) procedure, which assumes that errors due to the use of mean angular dependence models (ADMs) in the radiance-to-flux inversion process nearly cancel when averaged over grid areas. (2) To estimate N, instantaneous ADMs are estimated from the multiangular, collocated observations of the two scanners. These observed models replace the mean models in computation of satellite flux estimates. (3) The scene flux approach, conducts separate target-area retrievals for each ERBE scene category and combines their results using area weighting by scene type. The ERBE retrieval performs best when the simulated radiance field departs from the ERBE mean models by less than 10%. For larger perturbations, both the scene flux and collocation methods produce less error than the ERBE retrieval. The scene flux technique is preferable, however, because it involves fewer restrictive assumptions.

Description: Vertical heat fluxes associated with mesoscale circulations generated by land-surface wetness discontinuities are often stronger than turbulent fluxes, especially in the upper part of the atmospheric planetary boundary layer. As a result, they contribute significantly to the subgrid-scale fluxes in large-scale atmospheric models. Yet they are not considered in these models. To provide some insights into the possible parameterization of these fluxes in large-scale models, a state-of-the-art mesoscale numerical model was used to investigate the relationships between mesoscale heat fluxes and atmospheric and land-surface characteristics that play a key role in the generation of mesoscale circulations. The distribution of land-surface wetness, the wavenumber and the wavelength of the land-surface discontinuities, and the large-scale wind speed have a significant impact on the mesoscale heat fluxes. Empirical functions were derived to characterize the relationships between mesoscale heat fluxes and the spatial distribution of land-surface wetness. The strongest mesoscale heat fluxes were obtained for a wavelength of forcing corresponding approximately to the local Rossby deformation radius. The mesoscale heat fluxes are weakened by large-scale background winds but remain significant even with moderate winds.

Description: The evolution of the stratopsheric flow during the major stratospheric sudden warming of February 1979 is studied using two primitive equation models of the stratosphere and mesosphere. The United Kingdom Meteorological Office Stratosphere-Mesosphere Model (SMM) uses log pressure as a vertical coordinate. A spectral, entropy coordinate version of the SMM (entropy coordinate model, or ECM) that has recently been developed is also used. Comparison of SMM simulations with forecasts performed using the University of California, Los Angeles general circulation model confirms the previously noted sensitivity of stratospheric forecasts to tropospheric forecasts and emphasizes the importance of adequate vertical resolution in modeling the stratosphere. The ECM simulations provide a schematic description of the three-dimensional evolution of the polar vortex and the motion of air through it. During the warming, the two cyclonic vortices tilt westward and equatorward with height. Strong upward velocities develop in the lower stratosphere on the west (cold) side of a baroclinic zone as it forms over Europe and Asia. Strong downward velocities appear in the upper stratosphere on the east (warm) side, strengthening the temperature gradients. After the peak of the warming, vertical velocities decrease, downward velocities move into the lower stratosphere, and upward velocities move into the upper stratosphere.

Description: Extensive observations indicate a distinct difference between maritime and continental effective drop size, r(sub e), for warm clouds. The latest version of the National Center for Atmospheric Research (NCAR) Community Climate Model (CCM2) is used to explore the sensitivity of differentiating between continental and maritime r(sub e) on the simulated climate. The results of this study indicate that the smaller drop size over continents leads to a reduction of surface-absorbed solar radiation from 20 to 60 W/sq m. This reduction in surface solar flux leads to a cooling of the continents by up to -3.5 K. The reduction in surface solar flux and temperature also leads to a reduction in latent heat flux and precipitation over land. In the January simulation, there is a significant shift in tropical precipitation associated with the Australian monsoon. This shift leads to a response in the extra tropical geopotential height field over the western United States. All of these changes reduce biases in the current version of CCM2.