ALBERT

Notes: Microstructures in slate belt rocks at the Elura Mine, near Cobar, south-eastern Australia, indicate that volume loss by syntectonic dissolution is coupled with mass accretion by reprecipitation of the dissolved material in dilational sites. The mass accretion is sustained primarily by repetitive tensile microfracturing at high pore-fluid pressures. Oriented growth in the inter- and intragranular microcracks is locally host-controlled, creating lattice- and shape-preferred orientations. The grain-scale crack-seal features throughout the rock reflect rhythmic fluid pressure fluctuations; a balance is achieved between the fracture-induced permeability (and consequent flushing rates), and the rate of fluid build-up in a relatively sealed environment.Instability in the balancing factors can lead to localization and intensification of tensile failure (and hence, tension vein formation) in the grain aggregate. Growth of veins by crack-seal also reflects a steady state, but with more localized fluctuations of fluid flow on the aggregate scale. Still larger imbalances between flushing and fluid accumulation (i.e. pressure variations) induce breccia veining. The larger pressure gradients over greater distances, associated with dilation localization (from pervasive microfracturing to spaced breccia domains), allow fluid channelling with an increased potential for chemical fluid/rock disequilibrium. Therefore, large breccia vein systems tend to be sites of extensive fluid/rock interaction and replacement, as spectacularly illustrated by the syntectonic sulphide orebodies at Elura. The huge amounts of silicate, carbonate and sulphide accumulated during folding at Elura illustrate the large scale of source and sink couples possible in solute mass transfer.

Notes: The Internal Zone of the Betic Cordilleras consists of several superimposed major thrust sheets with different P-T-t evolutions. On the basis of an integrated field, microscopic and laboratory study, the tectono-metamorphic history of the Mulhacen Complex and Almanzora Unit has been reconstructed in detail. The Mulhacen Complex has been affected by at least five phases of penetrative deformation, which have been labelled Dx-1, Dx, Dx+1, Dx+2 and Dx+3. Dx-1, and Dx are related to continent-continent collision, which is indicated by high pressure-low temperature (HP/LT) and subsequent intermediate P/T metamorphic conditions. Dx+1 is related to crustal thinning and heterogeneous extension. During this event the Almanzora Unit was juxtaposed against the Mulhacen Complex. This phase was succeeded by the establishment of low pressure-high temperature (LP/HT) conditions and at least two phases of folding and overthrusting. The Almanzora Unit shows a comparable tectono-metamorphic evolution post Dx+1. However, the P/T conditions prior to Dx+1 indicate a higher crustal position with respect to the Mulhacen Complex during the collisional event.

Notes: Following the Middle Devonian Acadian deformation an extensive belt of high grade metamorphism was formed in New England. In south-western Maine, at the northern end of this belt, there occurs a transition along the strike from regional low-pressure/high-temperature metamorphism to contact metamorphism in low-grade rocks. Petrological studies indicate that this transition occurs along a surface plunging to the north-east at about 3.5°, with respect to the Middle-to-Late Devonian erosion surface. In addition, detailed petrological mapping has defined a history of temporally separate, localized metamorphic events associated with plutonism and occurring at increasingly deeper levels to the south-west. Geochronological studies constrain ambient temperatures in the transition zone at the time of metamorphism to be less than 300° C in the north-east and between 350° C and 500° C in the south-west. They also establish a pattern of diachronous cooling due to differential uplift and erosion, with cooling occurring later and most rapidly to the south-west. Geophysical evidence suggests that along with this spatial variation in metamorphic style the shapes of the plutons in Maine undergo a transition from laterally extensive sheet-like bodies in the high grade terrane to more equant-shaped bodies in the low-grade terrane. Using the results of these petrological, geochronological and geophysical studies, as well as those of stratigraphical and structural studies we construct a thermal model for the transition zone. The model suggests that the Acadian metamorphism in south-western Maine is a result of deep-level contact metamorphism near laterally extensive granitic sills dipping to the north-east with respect to the present erosion surface. The plutons themselves are interpreted to be a result of lower crustal melting in response to crustal thickening in the presence of normal or slightly augmented mantle heat flux.

Notes: Abstract Regionally distributed pelitic granulites in the Wilson Lake region contain the assemblage sapphirine + hypersthene + sillimanite + quartz. Geochronology and geobarometry suggest it developed in early Proterozoic rocks at temperatures approaching 900°C and pressures above 10 kbar. Vein-like metasomatized rocks around a suite of mafic to ultramafic intrusions, emplaced near the peak of metamorphism about 1700 Ma ago, contain sapphirine, but these assemblages developed at temperatures near 750°C and pressures of 4.5 kbar. Both types of assemblage occur as relics in amphibolite-grade (biotite–sillimanite) migmatites. P–T determinations indicate rapid isothermal uplift of 20 km accompanied by mafic intrusion and hydration. The metamorphic history and tectonic setting suggest exposure of deep continental crust by thrusting during continental collision, followed by essentially isothermal decompression.

Notes: Abstract The effects of Tertiary Alpine metamorphism on pelitic Mesozoic cover rocks have been studied along a cross-section in the central Lepontine Alps in the Nufenen Pass area, Switzerland.Greenschist facies to amphibolite facies conditions are indicated by the formation of the index minerals chloritoid, garnet, staurolite and kyanite in pelitic rocks. Regional metamorphism reached maximum conditions during the interkinematic period between a main Alpine penetrative (D2) and a late Alpine (D3) crenulation type deformation phase or synchronous with the late Alpine deformation. Based on AFM phase relationships four different metamorphic zones can be distinguished: (1) chloritoid zone; (2) staurolite + chlorite zone; (3) staurolite + biotite zone; and, (4) kyanite zone.The isograds that separate these zones can be modelled by univariant reactions in the KFMASH system. The conditions of metamorphism calculated from geological ther-mobarometers for the maximum post-D2 por-phyroblast stage are from North to South: 500° C at 5-6 kbar and 600° C at 7-8 kbar.Detailed thermobarometry of garnet por-phyroblasts with complex textures suggests that maximum temperature was reached later than maximum pressure. Early garnet growth occurred along a prograde P-T-path, post-D2 rims grew with increasing temperature but decreasing pressure, and finally post-D3 garnet formed along a retrograde P-T-path.It may be concluded from the calculated pressure and temperature difference over a short distance (3 km) across the mapped area that the isogradic surfaces of the post-D2 metamorphism are steeply oriented. The data also suggest that isobaric and isothermal surfaces are parallel.Much of the observed metamorphic pattern can be explained as the result of a significant post-D2 differential uplift of the hot Pennine area relative to the Helvetic area along a tectonic contact zone. The closely spaced isograds (isotherms) in the North may then be interpreted as a thermal effect owing to the emplacement of the hot Pennine rocks against the Got-thard massif with its cover. Whereas, in the Pennine metasediments, post-D2 porphyroblast formation can be related to the decompression path which was steep enough for dehydration reactions to proceed. It is also remarkable that late kyanite porphyroblasts probably formed with decreasing pressure.The interpretation given here for the Nufenen Pass area may also apply to the Luk-manier Pass area where similar metamorphic patterns have been reported by Fox (1975). The formation of the ‘Northern Steep Belt’;, as denned by Milnes (1974b), and the associated late Alpine fold zones may, therefore, have significantly modified the metamorphic pattern of the Helvetic-Penninic contact zone.

Notes: Abstract Porphyroblast textures in a Karakorum phyllite reveal that porphyroblast growth was syn-tectonic with respect to a cleavage forming deformation. During and after porphyroblast growth it partitions the deformation such that zones of intensified cleavage are developed which wrap around the porphyroblast whilst the porphyroblast and its strain shadow undergo little deformation. Porphyroblast strain shadows comprise quartz, calcite and felspar with little mica, and are probably formed by solution transfer during deformation. Unless the deformation is so strongly partitioned that no deformation of the porphyroblasts and their immediate surrounds occurs, inequidimensional porphyroblasts will rotate. Porphyroblasts undergo some dissolution after they have finished growing.

Notes: Abstract New isotopic (Rb–Sr, U–Pb zircon and Sm–Nd) and petrological data are presented for part of an extensive Proterozoic mobile belt (locally known as the Rayner Complex) in East Antarctica. Much of the belt is the product of Mid-Proterozoic (∼ 1800–2000 Ma) juvenile crustal formation. Melting of this crust at about 1500 Ma ago produced the felsic magmas from which the dominant orthogneisses of this terrain were subsequently derived. Deformation and transitional granulite-amphibolite facies conditions (which peaked at 750 ± 50°C and 7–8 kbar (0.7–0.8 GPa) produced open to tight folding about E–W axes and syn-tectonic granitoids about 960 Ma ago. Subsequent felsic magmatism occurred at about 770 Ma and not, as has been widely advocated, at 500–550 Ma, which appears to have been a time of widespread upper greenschist facies (400–500°C) metamorphism, localized shearing and faulting.Sm-Nd model ages of 1.65–2.18 Ga disprove a previously favoured hypothesis that the Rayner Complex mostly represents reworked Archaean rocks from the neighbouring craton (Napier Complex). Models that involve rehydration of the Napier Complex are no longer required, since the Rayner Complex was its own source of water. Two episodes of Proterozoic crustal growth are identified, the later of which occurred between about 1200 Ma and 1000 Ma, and was relatively minor. Sedimentation took place only shortly before Late Proterozoic orogenesis.The multiphase history of the Rayner Complex has resulted in complex isotopic behaviour. Three temporally discrete episodes of Pb loss from zircon have been identified, the earliest two of which are responses to the c. 960 Ma and 540 Ma tectonothermal events. Fluid leaching was operative during the later event for there is a good correlation between degree of isotopic discordance and secondary mineral growth. Pb loss during the high-grade event was probably governed by the same process or by lattice annealing. Some zircon suites also document recent Pb loss. Most lower concordia intercepts have no direct geological meaning and are explicable as mixed ages produced by incomplete Pb loss during two or more secondary events. Whereas all zircon separates from the orthogneisses produce U–Pb isotopic alignments, zircons from the only analysed paragneiss produce scattered data, in part reflecting a range of provenance. The 960 Ma event was also associated with the growth of a characteristically low U zircon (∼ 300 μg/g) in rocks of inferred high Zr content.There is ubiquitous evidence for the resetting of Rb–Sr total-rock isochrons. Even samples separated by up to 10 km fail to produce igneous crystallization ages. Minor mineralogical changes produced by the 540 Ma upper greenschist-facies metamorphism were sufficient to almost completely reset some Rb–Sr isochrons and to produce open system conditions on outcrop scale, at least in one location.