ALBERT

Description: Eutrophication combined with climate change has caused ephemeral filamentous macroalgae to increase and drifts of seaweed cover large areas of some Baltic Sea sites during summer. In ongoing projects, these mass occurrences of drifting filamentous macroalgae are being harvested to mitigate eutrophication, with preliminary results indicating considerable nutrient reduction potential. In the present study, an energy assessment was made of biogas production from the retrieved biomass for a Baltic Sea pilot case. Use of different indicators revealed a positive energy balance. The energy requirements corresponded to about 30%–40% of the energy content in the end products. The net energy gain was 530–800 MJ primary energy per ton wet weight of algae for small-scale and large-scale scenarios, where 6 000 and 13 000 tonnes dwt were harvested, respectively. However, the exergy efficiency differed from the energy efficiency, emphasising the importance of taking energy quality into consideration when evaluating energy systems. An uncertainty analysis indicated parametric uncertainty of about 25%–40%, which we consider to be acceptable given the generally high sensitivity of the indicators to changes in input data, allocation method, and system design. Overall, our evaluation indicated that biogas production may be a viable handling strategy for retrieved biomass, while harvesting other types of macroalgae than red filamentous species considered here may render a better energy balance due to higher methane yields.

Description: Bringer of storms and droughts, the El Niño∕Southern Oscillation results from the complex, sometimes chaotic interplay of ocean and atmosphere.

Description: The theory of the interpretation of seismic travel‐time curves for refracted rays in horizontal structures is treated after the manner of Herglotz‐Wiechert, under the customary assumption that the ray paths obey the laws of geometrical optics. Multiple valued travel‐time curves, discontinuous velocity functions, and the discontinuous travel‐time curves associated with a slower speed bed receive special consideration. It appears that interpretations satisfactory from the theoretical point of view may be obtained in these cases, although, experimentally, sufficiently complete data to meet the requirements of theory may often be difficult or impossible to obtain.

Description: This review article aims to provide an overview and insight into the most relevant aspects of wind energy development and current state-of-the-art. The industry is in a very mature stage, so it seems to be the right time to take stock of the relevant areas of wind energy use for power generation. For this review, the authors considered the essential aspects of the development of wind energy technology: research, modeling, and prediction of wind speed as an energy source, the technology development of the plants divided into the mechanical and electrical systems and the plant control, and finally the optimal plant operation including the maintenance strategies. The focus is on the development in Europe, with a partial focus on Germany. The authors are employees of the Fraunhofer Institutes, Institute for Energy Economics and Energy Systems Technology and Institute for Wind Energy Systems, who have contributed to the development of this technology for decades.

Description: A fully nonlinear solution for bi-chromatic progressive waves in water of finite depth in the framework of the homotopy analysis method (HAM) is derived. The bi-chromatic wave field is assumed to be obtained by the nonlinear interaction of two monochromatic wave trains that propagate independently in the same direction before encountering. The equations for the mass, momentum, and energy fluxes based on the accurate high-order homotopy series solutions are obtained using a discrete integration and a Fourier series-based fitting. The conservation equations for the mean rates of the mass, momentum, and energy fluxes before and after the interaction of the two nonlinear monochromatic wave trains are proposed to establish the relationship between the steady-state bi-chromatic wave field and the two nonlinear monochromatic wave trains. The parametric analysis on ε 1 and ε 2 , representing the nonlinearity of the bi-chromatic wave field, is performed to obtain a sufficiently small standard deviation S d , which is applied to describe the deviation from the conservation state ( S d = 0) in terms of the mean rates of the mass, momentum, and energy fluxes before and after the interaction. It is demonstrated that very small standard deviation from the conservation state can be achieved. After the interaction, the amplitude of the primary wave with a lower circular frequency is found to decrease; while the one with a higher circular frequency is found to increase. Moreover, the highest horizontal velocity of the water particles underneath the largest wave crest, which is obtained by the nonlinear interaction between the two monochromatic waves, is found to be significantly higher than the linear superposition value of the corresponding velocity of the two monochromatic waves. The present study is helpful to enrich and deepen the understanding with insight to steady-state wave-wave interactions.

Description: We have investigated the development of a handheld 4 × 1 piezoelectric finger (PEF) array breast tumor detector system towards in vivo patient testing, particularly, on how the duration of the DC applied voltage, the depression depth of the handheld unit, and breast density affect the PEF detection sensitivity on 40 patients. The tests were blinded and carried out in four phases: with DC voltage durations 5, 3, 2, to 0.8 s corresponding to scanning a quadrant, a half, a whole breast, and both breasts within 30 min, respectively. The results showed that PEF detection sensitivity was unaffected by shortening the applied voltage duration from 5 to 0.8 s nor was it affected by increasing the depression depth from 2 to 6 mm. Over the 40 patients, PEF detected 46 of the 48 lesions (46/48)—with the smallest lesion detected being 5 mm in size. Of 28 patients (some have more than one lesion) with mammography records, PEF detected 31/33 of all lesions (94%) and 14/15 of malignant lesions (93%), while mammography detected 30/33 of all lesions (91%) and 12/15 of malignant lesions (80%), indicating that PEF could detect malignant lesions not detectable by mammography without significantly increasing false positives. PEF’s detection sensitivity is also shown to be independent of breast density, suggesting that PEF could be a potential tool for detecting breast cancer in young women and women with dense breasts.

Description: A combination of transient and static techniques has been applied to bulk-heterojunction solar-cells to gain insight into the influence of charge-carrier dynamics and of energy level shifts in the vicinity of the cathode on the open-circuit voltage. Devices with a different thermal-annealing history but with similar active layer-morphology were compared. P3HT:PC 60 BM bulk heterojunction solar-cells with a standard ITO/PEDOT:PSS/active-layer/Al were investigated. We show that the open-circuit voltage increase that occurs when a sample is annealed before or after cathode deposition is due roughly one third to a shift between the energetics of the photoactive blend adjacent to the cathode and that in the bulk of the photoactive layer and roughly two thirds to a significant increase in the charge-carrier lifetime for this type of solar-cell.

Description: Structural properties of brushes which are composed of weak acidic and basic polyelectrolytes are studied in the framework of a particle-based approach that implicitly accounts for the solvent quality. Using a semi-grandcanonical partition function in the framework of the Single-Chain-in-Mean-Field (SCMF) algorithm, the weak polyelectrolyte is conceived as a supramolecular mixture of polymers in different dissociation states, which are explicitly treated in the partition function and sampled by the SCMF procedure. One obtains a local expression for the equilibrium acid-base reaction responsible for the regulation of the charged groups that is also incorporated to the SCMF sampling. Coupled to a simultaneous treatment of the electrostatics, the approach is shown to capture the main features of weak polyelectrolyte brushes as a function of the bulk pH in the solution, the salt concentration, and the grafting density. Results are compared to experimental and theoretical works from the literature using coarse-grained representations of poly(acrylic acid) (PAA) and poly(2-vinyl pyridine) (P2VP) polymer-based brushes. As the Born self-energy of ions can be straightforwardly included in the numerical approach, we also study its effect on the local charge regulation mechanism of the brush. We find that its effect becomes significant when the brush is dense and exposed to high salt concentrations. The numerical methodology is then applied (1) to the study of the kinetics of collapse/swelling of a P2VP brush and (2) to the ability of an applied voltage to induce collapse/swelling of a PAA brush in a pH range close to the p K a value of the polymer.

Description: The dynamics of water within ionic polymer networks formed by sulfonated poly(phenylene) (SPP), as revealed by quasi-elastic neutron scattering (QENS), is presented. These polymers are distinguished from other ionic macromolecules by their rigidity and therefore in their network structure. QENS measurements as a function of temperature as the fraction of ionic groups and humidity were varied have shown that the polymer molecules are immobile while absorbed water molecules remain dynamic. The water molecules occupy multiple sites, either bound or loosely constrained, and bounce between the two. With increasing temperature and hydration levels, the system becomes more dynamic. Water molecules remain mobile even at subzero temperatures, illustrating the applicability of the SPP membrane for selective transport over a broad temperature range.

Description: SmCoO 3 is a perovskite material that has gained attention as a potential substitute for La 1−x Sr x MnO 3−d as a solid oxide fuel cell cathode. However, a number of properties have remained unknown due to the complexity of the material. For example, we know from experimental evidence that this perovskite exists in two different crystal structures, cubic and orthorhombic, and that the cobalt ion changes its spin state at high temperatures, leading to a semiconductor-to-metal transition. However, little is known about the precise magnetic structure that causes the metallic behavior or the spin state of the Co centers at high temperature. Here, we therefore present a systematic DFT+U study of the magnetic properties of SmCoO 3 in order to determine what magnetic ordering is the one exhibited by the metallic phase at different temperatures. Similarly, mechanical properties are difficult to measure experimentally, which is why there is a lack of data for the two different phases of SmCoO 3 . Taking advantage of our DFT calculations, we have determined the mechanical properties from our calculated elastic constants, finding that both polymorphs exhibit similar ductility and brittleness, but that the cubic structure is harder than the orthorhombic phase.