ALBERT

Notizen: The paper presents a straightforward method of calculating approximate orientation parameters (six degrees of freedom) of a known targeted object relative to a single calibrated camera. These can then initialise an optimised non-linear calculation of the same parameter values. The method uses the mathematics of a scaled parallel projection and is particularly suited to narrow angle images obtained using a telescope, telephoto or zoom lens. However, the method can also be used with cameras having wider fields of view provided the target group occupies a moderately small part of the image.

Notizen: This paper describes three mathematical modelling methods for high-resolution declassified CORONA KH-4B images. Since CORONA images are collected with a panoramic camera, several types of geometric distortions are involved. Two methods use the modified collinearity equations, and the third involves the terrain-dependent rational function model (RFM) which is considered to be a generic sensor model. Comparative analysis of the three mathematical modelling methods is undertaken. The results show that a ± 1·5 pixels level of horizontal and vertical accuracy can be obtained. A digital elevation model (DEM) of a test site is also created.

Notizen: Digital photogrammetry and softcopy workstations have added a new dimension to aerial triangulation, and some of the previously manual procedures are now available in automated form. Also, commercial software packages for automatic aerial triangulation came on to the market in the last decade. In this study, the results of automatic aerial triangulation using four triangulation software packages, Z/I Imaging's MATCH-AT (ISMAT) and ISAT, LH Systems’ MST and VirtuoZo AAT, are presented. For the comparison of the results of the tie point extraction and the bundle block adjustment for triangulation, a sub-block from the Uster block in Switzerland was selected and used. Differences between these software packages are discussed with respect to their functionality and performance in detail. The achieved standard deviation of image coordinates varies between 0·2 and 0·5 pixel for the systems tested. The more signalised control points and check points to be used, the better the σ0 estimate which could be expected. The average number of extracted tie points varied from system to system with respect to the matching method and the resolution of the images used in the programs. The digital aerial triangulation of the Uster sub-block was faster than analytical triangulation and the elapsed time for triangulation of one image using different systems varies between about 0·5 and 6 min. Nevertheless, results also show that automated aerial triangulation is still prone to error in all systems. Image matching produces many blunders, which can only be handled efficiently by using a sophisticated blunder detection procedure, as is available with robust estimation. This is not the case for all the systems tested, however. There still remains a lot to be done in terms of development (improvement of matching, for example, by integrating robust estimation for error detection at an early stage, implementation of on-line triangulation, better internal quality control procedures, more transparent and simple user interfaces and more useful information for the user with better software manuals). However, it was shown that automatic aerial triangulation provides higher redundancy and reliability of results and much more economical photogrammetric practice than ever before.

Notizen: 18th International Symposium of Cipa by D. M. Barber, p.50548th Photogrammetric Week by A. T. Smart, p.5065th Conference on Optical 3D Measurement Techniques by G. Hunter, p.509