ALBERT

Description: We demonstrate the real-time observation of phonon-polariton propagation in ferroelectric LiNbO 3 using a single-shot spectroscopic setup that employs an echelon mirror. The echelon mirror provides a spatially encoded time delay for the probe pulse; therefore, the ultrafast transient behavior of materials can be detected on a single-shot basis. Using optical Kerr gate apparatus, forward and backward propagating E -mode phonon-polaritons were simultaneously induced via an impulsive stimulated Raman scattering process, and subsequently, their dynamics were readily mapped in time-frequency space using heterodyne detection. The two phonon-polaritons appeared on opposite sides of the central probe wavelength and were symmetrically imaged against the ordinary and extraordinary probe lights. By taking into account coupling of the lowest E -mode phonon-polariton to a low-frequency relaxational mode, not only the phonon-polariton dispersion but also the wavevector dependence of the damping rate was unveiled and quantitatively evaluated.

Description: This is the report on trap states in enhancement-mode AlGaN/GaN/AlGaN double heterostructures high electron mobility transistors by fluorine plasma treatment with different GaN channel layer thicknesses. Compared with the thick GaN channel layer sample, the thin one has smaller 2DEG concentration, lower electron mobility, lower saturation current, and lower peak transconductance, but it has a higher threshold voltage of 1.2 V. Deep level transient spectroscopy measurements are used to obtain the accurate capture cross section of trap states. By frequency dependent capacitance and conductance measurements, the trap state density of (1.98–2.56) × 10 12  cm −2 eV −1 is located at E T in a range of (0.37–0.44) eV in the thin sample, while the trap state density of (2.3–2.92) × 10 12  cm −2 eV −1 is located at E T in a range of (0.33–0.38) eV in the thick one. It indicates that the trap states in the thin sample are deeper than those in the thick one.

Description: A deformed exponential family is a generalization of exponential families. Since the useful classes of power law tailed distributions are described by the deformed exponential families, they are important objects in the theory of complex systems. Though the deformed exponential families are defined by deformed exponential functions, these functions do not satisfy the law of exponents in general. The deformed algebras have been introduced based on the deformed exponential functions. In this paper, after summarizing such deformed algebraic structures, it is clarified how deformed algebras work on deformed exponential families. In fact, deformed algebras cause generalization of expectations. The three kinds of expectations for random variables are introduced in this paper, and it is discussed why these generalized expectations are natural from the viewpoint of information geometry. In addition, deformed algebras cause generalization of independences. Whereas it is difficult to check the well-definedness of deformed independence in general, the κ-independence is always well-defined on κ-exponential families. This is one of advantages of κ-exponential families in complex systems. Consequently, we can well generalize the maximum likelihood method for the κ-exponential family from the viewpoint of information geometry.

Description: We consider the problem of learning a Bayesian network structure given n examples and the prior probability based on maximizing the posterior probability. We propose an algorithm that runs in O(n log n) time and that addresses continuous variables and discrete variables without assuming any class of distribution. We prove that the decision is strongly consistent, i.e., correct with probability one as n ! 1. To date, consistency has only been obtained for discrete variables for this class of problem, and many authors have attempted to prove consistency when continuous variables are present. Furthermore, we prove that the “log n” term that appears in the penalty term of the description length can be replaced by 2(1+ε) log log n to obtain strong consistency, where ε > 0 is arbitrary, which implies that the Hannan–Quinn proposition holds.

Description: Background: In 2012, a pilot health policy of contractual service relations between general practitioners and patients was implemented in China. Due to the decline in body and cognitive function, as well as the lack of family care and narrow social support networks, the demand of health services among the elderly is much higher than that among the general population. This study aims to probe into the empty nesters’ willingness-to-pay for general practitioners using a contractual service policy, investigating empty nesters’ payment levels for the service, and analyze the main factors affecting the willingness of empty-nesters’ general practitioners using contractual service supply cost. Methods: This cross-sectional study adopted a multistage stratified sampling method to survey 865, city empty nesters (six communities in three districts of one city) aged 60–85 years. A condition value method was used to infer the distribution of the willingness-to-pay; Cox’s proportional hazards regression model was used to analyze the influencing factors of willingness-to-pay. Results: More than seventy percent (76.6%) of the empty nesters in this city were willing to pay general practitioners using contract service in Chongqing. The level of willingness-to-pay for the surveyed empty nesters was 34.1 yuan per year. The median value was 22.1 yuan per year, which was below the Chongqing urban and rural cooperative medical insurance individual funding level (60 yuan per year) in 2013. Cox’s proportional hazards regression model analysis showed that the higher the education level was, the worse the self-reported health status would be, accompanied by higher family per capita income, higher satisfaction of community health service, and higher willingness-to-pay empty nesters using a contract service. Women had a higher willingness-to-pay than men. Conclusions: The willingness-to-pay for general practitioners by contractual service is high among city empty nesters in Chongqing, thus, individual financing is feasible. However, people are willing to pay less than half of the current personal financing of cooperative medical insurance of urban and rural residents. Education level, family per capita income, and self-reported health status are the main factors affecting the cost sharing intention for general practitioners using contract service supply. According to the existing situation of different empty nesters, it is important to perfect the design of general practitioners using a contractual service policy system, according to differentiated personal financing levels.

Description: Vertically aligned nanocomposite (VAN) (La 0.7 Sr 0.3 MnO 3 ) 1−x :(CeO 2 ) x (LSMO:CeO 2 ) thin films have been grown on SrTiO 3 (001) substrates by pulsed laser deposition. Tunable magnetoresistance properties as well as microstructures are demonstrated in these VAN films by modulating the film composition (x = 0, 0.3, 0.4, 0.45, 0.5, and 0.55). The sample of x = 0.3 shows a large low-field magnetoresistance (LFMR) in a high temperature range, i.e., over 10% at the range of 280 K to 320 K under 1 T and with a peak value of ∼13.5% at 310 K. In addition, a vast enhancement of LFMR in a low temperature range of 20–150 K with peak of ≈34.3% at 45 K for 1 T could be achieved with x = 0.5. The enhanced LFMR properties can be attributed to both the phase boundary induced spin fluctuation and the magnetic tunneling effect through vertical ferromagnetic/insulator/ferromagnetic structures. The observed enhanced LFMR performance, especially at high temperatures, as well as its simple growth method, offers a great potential for LSMO:CeO 2 nanocomposites to be used in spintronic devices in a large temperature range.

Description: We present a new generalized scaling relationship accounting for relaxation processes of both the real and the imaginary parts of the complex dielectric permittivity data in a wide temperature range of dielectric media. It has been successfully used for experimental data related to various dynamics in liquid crystalline phases of: 4-bromobenzylidene-4′-pentyloxyanilin, 4-bromobenzylidene-4′-hexyloxyaniline, 4′-butyl-4-(2-methylbutoxy) azoxybenzene, and 4-ethyl-4′-octylazoxybenzene. Moreover, the scaling was checked for the theoretical data of Dissado-Hill cluster model. A comparison with earlier scaling, proposed by Nagel and Dendzik, is given.

Description: Focusing of surface phonon-polaritons propagating toward the tip of a cone and the edge of a wedge is theoretically analyzed and compared. Based on Maxwell's equations, explicit expressions for the dispersion relations in each structure are determined and solved numerically for a propagation parameter driving the surface phonon-polariton energy density. For conical and wedge structures of SiO 2 , it is found that: (1) the cone (wedge) supports the polariton focusing only for aperture angles in the interval 18 ° – 68 ° ( 21 ° – 51 ° ), and within the range of excitation frequencies from 32.1 THz (31.5 THz) to 33.9 THz (33.9 THz). In this frequency interval, the real part of the SiO 2 permittivity is negative and the presence of polaritons is significant. (2) The polariton focusing efficiency of both the cone and wedge reaches its maximum values at the critical frequency f cr = 33.6  THz and at different aperture angles of about α opt = 45 ° and α opt = 30 ° , respectively. (3) When the polaritons travel from 100 nm to 5 nm toward the tip of the cone with this optimum angle, their Poynting vector increases by a factor of 12, which is about four times larger than the corresponding one provided by the wedge and indicates that the cone is more efficient than the wedge for the focusing of surface phonon-polaritons.

Description: Surface plasmons can squeeze light into a deep-subwavelength space and generate abundant hot electrons in the nearby metallic regions, enabling a new paradigm of photoconversion by the way of hot electron collection. Unlike the visible spectral range concerned in previous literatures, we focus on the communication band and design the infrared hot-electron photodetectors with plasmonic metal-insulator-metal configuration by using full-wave finite-element method. Titanium dioxide-silver Schottky interface is employed to boost the low-energy infrared photodetection. The photodetection sensitivity is strongly improved by enhancing the plasmonic excitation from a rationally engineered metallic grating, which enables a strong unidirectional photocurrent. With a five-step electrical simulation, the optimized device exhibits an unbiased responsivity of ∼0.1 mA/W and an ultra-narrow response band (FWHM = 4.66 meV), which promises to be a candidate as the compact photodetector operating in communication band.

Description: A two-step method that combines homogeneous electron beam (EB) irradiation and thermal annealing has been developed to enhance the thermoelectric properties of nanocrystalline bismuth selenium telluride thin films. The thin films, prepared using a flash evaporation method, were treated with EB irradiation in a N 2 atmosphere at room temperature and an acceleration voltage of 0.17 MeV. Thermal annealing was performed under Ar/H 2 (5%) at 300 °C for 60 min. X-ray diffraction was used to determine that compositional phase separation between bismuth telluride and bismuth selenium telluride developed in the thin films exposed to higher EB doses and thermal annealing. We propose that the phase separation was induced by fluctuations in the distribution of selenium atoms after EB irradiation, followed by the migration of selenium atoms to more stable sites during thermal annealing. As a result, thin film crystallinity improved and mobility was significantly enhanced. This indicates that the phase separation resulting from the two-step method enhanced, rather than disturbed, the electron transport. Both the electrical conductivity and the Seebeck coefficient were improved following the two-step method. Consequently, the power factor of thin films that underwent the two-step method was enhanced to 20 times (from 0.96 to 21.0  μ W/(cm K 2 ) that of the thin films treated with EB irradiation alone.