ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • Articles  (5)
  • heat flux  (5)
  • 2020-2024
  • 1985-1989  (5)
  • Architecture, Civil Engineering, Surveying  (5)
  • 1
    Electronic Resource
    Electronic Resource
    Springer
    Fire technology 21 (1985), S. 122-133 
    ISSN: 1572-8099
    Keywords: Smoke generation ; fire retardants ; wood ; wood derived materials ; optical density ; cellulosic materials ; heat flux
    Source: Springer Online Journal Archives 1860-2000
    Topics: Architecture, Civil Engineering, Surveying
    Notes: Abstract The influence of three fire retardant agents: Polichron, Pyrolak W-10, and Pyrolak W-10 + Pyrolak W-1 on smoke density of pine wood, plywood, soft hardboard and tough hardboard was investigated. Surface samples of 25 cm2 (5 × 5 cm) were used and the heat flux was varied over the range of 1.0 to 4.0 W/cm2.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Springer
    Fire technology 22 (1986), S. 184-209 
    ISSN: 1572-8099
    Keywords: Fire suppression ; postflashover fires ; mathematical modeling ; water spray ; fire development ; char ; pyrolysis ; heat flux
    Source: Springer Online Journal Archives 1860-2000
    Topics: Architecture, Civil Engineering, Surveying
    Notes: Abstract The Swedish Fire Research Board and the U.S. Federal Emergency Management Agency are sponsoring a project to further the understanding of the basic mechanisms involved, as well as to support the development of standards for and to seek ways of improving the performance of portable fire suppression systems used by fire departments. This paper describes a physically based computer model developed to simulate one aspect of the problem: the manual suppression of postflashover fires. This includes: (1) an overview of the physical basis behind the model; (2) a comparison of model predictions with available experimental data, and (3) an analysis of fire suppression effectiveness using the model. The analysis concludes that, when direct access and extinguishment of the burning fuel is not possible, improved fire control occurs with water sprays having a Rosin-Rammler distribution of droplet sizes with volume-median-drop diameters in the 0.15 to 0.35 mm range. This agrees with available experimental data. It is also shown that fire fighting venting and standoff distance requirements may lead to more severe fires requiring more water for control; although venting and water spray induced air/gas flow also serve to channel hot steam and gases away from the fire fighter adding to his safety. The analysis also shows that allowing higher gas and surface temperatures at fire control through improved fire fighter protective clothing and equipment design reduces water flow rate requirements. Additional experimental work is recommended before all these conclusions are considered definitive.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Springer
    Fire technology 23 (1987), S. 49-59 
    ISSN: 1572-8099
    Keywords: Protective clothing ; thermal radiation ; thermal inertia ; heat flux ; burn exposure time ; time to pain
    Source: Springer Online Journal Archives 1860-2000
    Topics: Architecture, Civil Engineering, Surveying
    Notes: Abstract A method for measuring the thermal radiative protection of actual fire fighters' garments to an incident radiative heat flux of 8.4 kW/m2 is described. Typical results obtained with several conventional and prototype garments are presented. These results indicate the time to pain, and second degree burn as well as the pain alarm time. The thermal inertia of the garments is also measured based upon burn exposure time. Differences in physical properties such as garment thickness, total weight and number of layers are examined in order to establish the existence of any correlations.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    ISSN: 1572-8099
    Keywords: burn injury ; escape time ; fire fighters ; flashover ; heat flux ; room fires ; thermal protection ; protective clothing ; turnout coats
    Source: Springer Online Journal Archives 1860-2000
    Topics: Architecture, Civil Engineering, Surveying
    Notes: Abstract Heat flux conditions measured in seven room fires are discussed. The conditions varied from just below flashover in a sparsely furnished bedroom to flashover and severe postflashover fire in a typically furnished recreation room. These heat flux conditions are compared with the protection level provided by fire fighter turnout coats conforming to NFPA 1971,Protective Clothing for Structural Fire Fighting. This standard requires that the turnout coat or pants assembly must protect the wearer against second degree burns when a heat flux of 84 kW/m2 (2 cal/cm2.s) is applied to its outside surface for a minimum of 17.5 seconds [“thermal protective performance (TPP) of 35”]. The results imply that fire fighters have only ten seconds or less to escape under most flashover conditions. However, the turnout coats provide good protection in many other fire situations. Practical definitions for flashover are given, and possible means for making the TPP test more relevant for research and development work are discussed.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Springer
    Fire technology 25 (1989), S. 51-80 
    ISSN: 1572-8099
    Keywords: Pool fire ; velocity ; heat flux ; measurements
    Source: Springer Online Journal Archives 1860-2000
    Topics: Architecture, Civil Engineering, Surveying
    Notes: Abstract A number of measurements were made to help define the thermal and flow conditions in a 9 × 18 meter pool fire that was used to simulate a transportation accident. Temperatures were measured at twenty-eight locations throughout the continuous flame region. Velocities were measured at four vertical stations near the centerline of the pool. Heat fluxes were estimated from thermal measurements on and near vertical steel plates. As is often the case in fires of this size, the effects of mild, ambient winds on the measurements were pronounced. Attempts have been made to mitigate these effects by the application of conditional sampling. Temperatures and velocities are compared with other experimental results as well as results of modeling efforts.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...