ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The conductance in diphenyl ether at 35°C. and 60 cycles of the picrate of a 4-vinylpyridine-styrene copolymer (10:90) has been measured. The equivalent conductance, based on the nitrogen content, is of the same order as that of picoline picrate, and varies with concentration in accordance with the law of ion association.
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    Journal of Polymer Science 2 (1947), S. 21-35 
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: A polyvinyl acetate polymer of medium viscosity was fractionated into sixteen fractions (first series) and three of the larger of these further separated into twenty subfractions (second series). The intrinsic viscosities and the osmotic pressure molecular weights were determined at 25°C. and the relation between them was found to be expressed by the equations: first series: [η] = (1.88 × 10-4) M0.69; second series: [η] = (1.76 × 10-4) M0.68. The data indicate that little, if any, increase in homogeneity is to be expected by further successive fractionations and that the equations applicable to the second fractionation series are representative of essentially homogeneous polyvinyl acetates in acetone. An equation applicable to fractionated and unfractionated vinyl acetate polymers is described that is useful in obtaining the intrinsic viscosity from a single viscosity measurement. Several unfractionated materials from different sources were also studied and the calculated ratios of the viscosity-average to the number-average molecular weight indicate that the degree of heterogeneity of chain-length distribution increases with increasing average molecular weight.
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The rate of emulsion copolymerization of butadiene and styrene, with soap as emulsifier and potassium persulfate as catalyst, is extremely small at 50°C. The presence of very small amounts of high-molecular mercaptans promotes the copolymerization reaction. The promoting effect is at a maximum for primary, secondary, and tertiary dodecyl mercaptans and decreases for mercaptans of either higher or lower molecular weight. The promoting effect is independent within wide limits of the amount of mercaptan added after the minimum quantity has been exceeded. Mercaptans which are poor promoters may be so because they fail to bring about chain initiation or because they aid in chain termination. The low-molecular mercaptans which are poor promoters prevent the high-molecular mercaptans from exerting their good promoting effect when a mixture of both types of mercaptans is used. The mechanism of the promoting effect of mercaptans upon the emulsion copolymerization of butadiene (75 parts) and styrene (25 parts) or upon the polymerization of butadiene alone is not yet clear.
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: An empirical equation is described which predicts the intrinsic viscosities of 75:25 butadiene-styrene emulsion copolymers from data on mercaptan consumption. The form of the equation is as follows: \documentclass{article}\pagestyle{empty}\begin{document}$$\left[ \eta \right] = \left[ {\frac{{aP}}{{R_0 R}} + \frac{b}{{R_0 }}\int_0^P {\frac{{dP}}{{dR}}dP} } \right]^c $$\end{document} where [η] is the intrinsic viscosity, P is the conversion, R is the fraction of mercaptan consumed, R0 is the mercaptan charged, and a, b, and c are constants equal to 0.22, 1.12, and 0.66, respectively. Evidence is given that the intrinsic viscosity of mutual-recipe polymers can be described satisfactorily in terms of mercaptan consumption.
    Additional Material: 12 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    Journal of Polymer Science 2 (1947), S. 107-109 
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Additional Material: 1 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The calculation of the “theoretical” minimum modifier requirement, TMMR, for butadiene-styrene (75:25) copolymers of given intrinsic viscosities at various conversions is described. The TMMR of 75% conversion polymer of intrinsic viscosity 2.0 is R0 = 0.28, which is only about 60% of the value of R0 for commercial primary dodecyl mercaptan (C.M.) in large-size reactors. The efficiency, E, of a modifier for 75:25 butadiene-styrene copolymerization using soap as emulsifier and persulfate as catalyst has been defined by and calculated from the equation: \documentclass{article}\pagestyle{empty}\begin{document}$$E = \frac{{P\left( {0.2 + P} \right)}}{{R_0 \left( {M_v \times 10^{ - 5} } \right)}}$$\end{document} where Mv is the intrinsic viscosity molecular weight of the polymer at conversion, P, with an amount of mercaptan, R0, charged with the monomers. For all modifiers the efficiency is low at low conversions and gradually increases to a maximum with increasing conversion. For different modifiers this maximum may be as at low as 10% conversion or at higher than 80% conversion. After the maximum the efficiency decreases with further increase of conversion. The most efficient modifier for the production of polymers of intrinsic viscosity, [η], at conversion, P, will meet the following conditions, R = 1 at conversion, P, and dP/dR is constant. Inefficient modifiers may be made more efficient by changing the conditions or procedure of polymerization in such a way that the modifier more nearly complies with the above conditions.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    Journal of Polymer Science 2 (1947), S. 565-582 
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: From the results of initial acid-catalyzed hydrolysis of cellulose, and from certain data in the literature it is concluded that (1) native cellulose possesses an indefinitely high molecular weight; (2) as a consequence of common procedure adhered to by most investigators, native cellulose is unintentionally degraded to about DP 3000; (3) mild, initial acidic degradation, intentional or accidental, causes further decrease in the DP values down to the probable limiting value of 128 or 256, with complete loss of the tensile strength of the cellulose fiber; and (4) the few covalent bonds (about 0.3%) which become cleaved during these mild reactions are equally spaced, acid-sensitive, and entirely different from the regular 1,4-glycosidic bonds which are responsible for the random hydrolysis of cellulose in strongly acidic media. It is suggested that these acid-sensitive linkages represent hemiacetal or acetal bonds which originate from openchain glucose anhydride residues of “limit hydrocellulose” units and connect the latter along the a and b axes of the fiber. The length of the “limit hydrocellulose” is supposed to correspond to that of 27 = 128 glucose anhydride residues - that is, 660 Å., or twice these figures. Extension of this concept to starch leads to the postulate of a three-dimensional network of glucose anhydride units of indefinite number. The latter are held together by regular 1,4-α-glucopyranosidic bonds and, at short intervals, probably by acetal bonds of open-chain glucose anhydride residues. On mild, acid-catalyzed hy-drolysis these acid-sensitive linkages rupture rapidly and completely, giving rise to a material which consists of linear molecules only, containing 1,4-, 1,6-, and possibly 1,3-, glycosidic bonds between two adjacent glucose anhydride residues.
    Additional Material: 1 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    Journal of Polymer Science 2 (1947), S. 583-592 
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Various problems related to the determination with x-rays of the atomic configuration of organic fibers are discussed. Because of the approximate nature of the underlying theory, too far-reaching conclusions should be avoided, especially since, in the case of organic fibers, the situation is much less simple than in the case of sodium chloride powder or metallic wires, for example. Because of these facts, and because of the relative poorness of fiber patterns, the atomic coordinates as well as the space group of the structure can be found only within certain limits. Though the use of macroscopic models is very helpful in visualizing the spatial arrangement, no conclusions of a quantitative nature can be reached with their aid because the assumptions embodied in these models are too numerous and too inexact to justify speculations on details of the structure. In the case of cellulose fibers, it is shown that the problem cannot yet be solved completely; the outlook for a really unique solution is not hopeful. The structure proposed by Meyer and Misch is still the best approximation available. More recent propositions are shown to be less well founded; the atomic configuration introduced by Peirce, being at variance with chemical, crystallographic and x-ray evidence, is to be discarded.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    Journal of Polymer Science 2 (1947), S. 612-622 
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Intrinsic viscosity, calculated in accordance with the empirical relation established by Schulz and Huggins, deviates considerably from its true value in the case of increasing viscosities. The introduction of a simple corrective, second degree term η2sp/150, applicable to most of the polymers, permits the direct computation of intrinsic viscosity based upon polymer solutions of various concentrations. Specific viscosities may vary to a great extent and reach a value as high as 15; the use of high concentrations permits the reduction of experimental errors and the determination, to within an average of one per cent, of the intrinsic viscosity of the polymer sample, and thus of its molecular weight.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    ISSN: 0022-3832
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: A solvent prepared by mixing 70 parts by volume of ethanol, 30 parts of toluene, and 10 parts of water is found to be a suitable solvent for the extraction of organic nonrubber material from GR-S. The presence of the water has no effect on the rate of extraction of the nonrubber, while it reduces the extractibility of low molecular polymer to one-tenth of that found in the absence of water in the solvent. A procedure is described for the determination of small amounts of GR-S in the extracts. This procedure is based on the quantitative precipitation of the ICl addition product of the rubber from a chloroform solution by addition of ethanol. A routine procedure for the determination of the amount of rubber in GR-S is given.
    Additional Material: 5 Tab.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...