ALBERT

Description: Magnetotelluric (MT) data from 66 sites along a 45-km-long profile across the San Andreas Fault (SAF) were inverted to obtain the 2-D electrical resistivity structure of the crust near the San Andreas Fault Observatory at Depth (SAFOD). The most intriguing feature of the resistivity model is a steeply dipping upper crustal high-conductivity zone flanking the seismically defined SAF to the NE, that widens into the lower crust and appears to be connected to a broad conductivity anomaly in the upper mantle. Hypothesis tests of the inversion model suggest that upper and lower crustal and upper-mantle anomalies may be interconnected.We speculate that the high conductivities are caused by fluids and may represent a deep-rooted channel for crustal and/or mantle fluid ascent. Based on the chemical analysis of well waters, it was previously suggested that fluids can enter the brittle regime of the SAF system from the lower crust and mantle. At high pressures, these fluids can contribute to fault-weakening at seismogenic depths. These geochemical studies predicted the existence of a deep fluid source and a permeable pathway through the crust. Our resistivity model images a conductive pathway, which penetrates the entire crust, in agreement with the geochemical interpretation. However, the resistivity model also shows that the upper crustal branch of the high-conductivity zone is locatedNEof the seismically defined SAF, suggesting that the SAF does not itself act as a major fluid pathway. This interpretation is supported by both, the location of the upper crustal highconductivity zone and recent studies within the SAFOD main hole, which indicate that pore pressures within the core of the SAF zone are not anomalously high, that mantle-derived fluids are minor constituents to the fault-zone fluid composition and that both the volume of mantle fluids and the fluid pressure increase to the NE of the SAF.We further infer from the MT model that the resistive Salinian block basement to the SW of the SAFOD represents an isolated body, being 5–8 km wide and reaching to depths 〉7 km, in agreement with aeromagnetic data. This body is separated from a massive block of Salinian crust farther to the SW. The NE terminus of resistive Salinian crust has a spatial relationship with a near-vertical zone of increased seismic reflectivity ∼15 km SW of the SAF and likely represents a deep-reaching fault zone.

Description: We report on a receiver function study of the crust and upper mantle within DESERT, a multidisciplinary geophysical project to study the lithosphere across the Dead Sea Transform (DST). A temporary seismic network was operated on both sides of the DST between 2000 April and 2001 June. The depth of the Moho increases smoothly from about 30 to 34-38 km towards the east across the DST, with significant north-south variations east of the DST. These Moho depth estimates from receiver functions are consistent with results from steep- and wide-angle controlled-source techniques. Steep-angle reflections and receiver functions reveal an additional discontinuity in the lower crust, but only east of the DST. This leads to the conclusion that the internal crustal structure east and west of the DST is different. The P to S converted phases from both discontinuities at 410 and 660 km are delayed by 2 s with respect to the IASP91 global reference model. This would indicate that the transition zone is consistent with the global average, but the upper mantle above 410 km is 3-4 per cent slower than the standard earth model.

Description: This study focuses on the present-day deformation mechanisms of the south central Chile margin, at the transition zone between two megathrust earthquake segments defined from historical data: the Valdivia and Concepción sectors. New GPS data and finite-element models with complex geometries constrained by geophysical data are presented to gain insight into forearc kinematics and to address the role of upper plate faults on contemporary deformation. GPS vectors are heterogeneously distributed in two domains that follow these two earthquake segments. We find that models which simulate only interseismic locking on the plate interface fail to reproduce surface deformation in the entire study area. In the Concepción domain, models that include a crustal-scale fault in the upper plate better reproduce the GPS observations. In the Valdivia domain, GPS data show regional-scale vertical axis rotations, which could reflect postseismic deformation processes at the edge of the Mw 9.5 earthquake that ruptured in 1960 and/or activity of another crustal fault related to motion of a forearc sliver. Our study suggests that upper plate faults in addition to earthquake cycle transients may exert an important control on the surface velocity of subduction zone forearcs.

Description: In this study we present the new tomographic code ANITA which provides 3-D anisotropic P and isotropic S velocity distribution based on P and S traveltimes from local seismicity. For the P anisotropic model, we determine four parameters for each parameterization cell. This represents an orthorhombic anisotropy with one predefined direction oriented vertically. Three of the parameters describe slowness variations along three horizontal orientations with azimuths of 0°, 60°, and 120°, and one is a perturbation along the vertical axis. The nonlinear iterative inversion procedure is similar to that used in the LOTOS code. We have implemented this algorithm for the updated data set of central Java, part of which was previously used for the isotropic inversion. It was obtained that the crustal and uppermost mantle velocity structure beneath central Java is strongly anisotropic with 7–10% of maximal difference between slow and fast velocity in different directions. In the forearc (area between southern coast and volcanoes), the structure of both isotropic and anisotropic structure is strongly heterogeneous. Variety of anisotropy orientations and highly contrasted velocity patterns can be explained by a complex block structure of the crust. Beneath volcanoes we observe faster velocities in vertical direction, which is probably an indicator for vertically oriented structures (channels, dykes). In the crust beneath the middle part of central Java, north to Merapi and Lawu volcanoes, we observe a large and very intense anomaly with a velocity decrease of up to 30% and 35% for P and S models, respectively. Inside this anomaly E-W orientation of fast velocity takes place, probably caused by regional extension stress regime. In a vertical section we observe faster horizontal velocities inside this anomaly that might be explained by layering of sediments and/or penetration of quasi-horizontal lenses with molten magma. In the mantle, trench parallel anisotropy is observed throughout the study area. Such anisotropy in the slab entrained corner flow may be due to presence of B-type olivine having predominant axis parallel to the shear direction, which appears in conditions of high water or/and melting content.

Description: From November 1999 through July 2000, a broadband seismic experiment was carried out at Popocatépetl Volcano to record seismic activity over a wide period range (0.04–100 s). We present an overview of the seismicity recorded during this experiment and discuss results of analyses of long-period (LP) and very-long-period (VLP) seismic signals recorded at stations nearest to the crater over a four-month interval December 1999–March 2000. Three families of LP signals (Types-I, II, and III) are identified based on distinctive waveform features observed periods shorter than 1 s, periods longer than 15 s, and within the period range 0.5–2.5 s. Type-I LP events have impulsive first arrivals and exhibit a characteristic harmonic wave train with dominant periods in the 1.4–1.9 s range during the first 10 s of signal. These events are also associated with a remarkable VLP wavelet with period near 30 s. Type-II LP events represent pairs of events occurring in rapid succession and whose signatures are superimposed. These are typically marked by slowly emergent first arrivals and by a characteristic VLP wave train with dominant period near 30 s, made of two successive wavelets whose shapes are quasi-identical to those of the VLP wavelets associated with Type-I events. Type-III LP events represent the most energetic signals observed during our experiment. These have an emergent first arrival and display a harmonic signature with dominant period near 1.1 s. They are dominated by periods in the 0.25–0.35 s band and contain no significant energy at periods longer than 15 s. Hypocentral locations of the three types of LP events obtained from phase picks point to shallow seismic sources clustered at depths shallower than 2 km below the crater floor. Observed variations in volcanic eruptive activity correlate with defined LP families. Most of the observed seismicity consists of Type-I events that occur in association with 1–3-min-long degassing bursts (“exhalations”). Eruptive activity increased in intensity in February, coinciding with an increasing occurrence of Type-II LP events. Type-III events were first observed at the end of February and during March, in coincidence with the formation of a new lava dome. Vulcanian eruptions occurred in April and May. These events typically exhibit broadband signatures extending over the full period range of the sensors and lasting 30–80 min.

Description: To study the applicability of the passive seismic interferometry technique to near-surface geological studies, seismic noise recordings from a small scale 2-D array of seismic stations were performed in the test site of Nauen (Germany). Rayleigh wave Green's functions were estimated for different frequencies. A tomographic inversion of the traveltimes estimated for each frequency from the Green's functions is then performed, allowing the laterally varying 3-D surface wave velocity structure below the array to be retrieved at engineering–geotechnical scales. Furthermore, a 2-D S-wave velocity cross-section is obtained by combining 1-D velocity structures derived from the inversion of the dispersion curves extracted at several points along a profile where other geophysical analyses were performed. It is shown that the cross-section from passive seismic interferometry provides a clear image of the local structural heterogeneities that are in excellent agreement with georadar and geoelectrical results. Such findings indicate that the interferometry analysis of seismic noise is potentially of great interest for deriving the shallow 3-D velocity structure in urban areas.

Description: On 8 January 2006, an intermediate-depth earthquake occurred at the western part of the Hellenic trench close to the island of Kythera (southern Greece). This is the first intermediate-depth earthquake in the broader Aegean area that has produced such an extensive set of useful recordings, as it was recorded by the main permanent seismological networks and numerous acceleration sensors operating in Greece, as well as by EGELADOS, a large-scale temporary amphibian broadband seismological network deployed in the southern Aegean area. An effort to combine all the available data (broadband velocity and acceleration sensor) was made to study the properties of ground-motion attenuation of this earthquake. The combination of both types of data revealed interesting properties of the earthquake wave field, which would remain hidden if only one type of data was used. Moreover, the data have been used for a validation of existing peak ground-motion empirical prediction relations and the preliminary study of the very inhomogeneous attenuation pattern of the southern Aegean intermediate-depth events at both near- and far-source distances

Description: We used data from both permanent and temporary seismic networks on Iceland and Greenland to investigate the crustal thickness by partly reinterpreting earlier data (P receiver functions) and adding S receiver functions to better constrain the results. We obtained good conversions from the Moho and also crustal multiples in both Iceland and Greenland. The central ice covered part of Greenland has an average crustal thickness of 40 km, typical for a craton. At the edges of Greenland the crustal thickness decreases to 30–40 km. On the east coast of Greenland, where the track of the Iceland plume is thought to have affected the lithosphere, the crustal thickness is only 24–26 km. In contrast to previous studies, we find that the crustal thickness in the east and the northwest coastal regions of Iceland is more than 40 km, similar to beneath the active volcanic region. In the southwest region of Iceland and along the mid-ocean ridge, the crustal thickness is only 25 km or less. Also in contrast to earlier receiver function interpretations, which deduced a broad crust-mantle transition zone for Iceland, we find indications for a normal, sharper Moho beneath a number of sites

Description: As part of the DEad Sea Integrated REsearch project (DESIRE) a 235 km long seismic wide-angle reflection/refraction (WRR) profile was completed in spring 2006 across the Dead Sea Transform (DST) in the region of the southern Dead Sea basin (DSB). The DST with a total of about 107 km multi-stage left-lateral shear since about 18 Ma ago, accommodates the movement between the Arabian and African plates. It connects the spreading centre in the Red Sea with the Taurus collision zone in Turkey over a length of about 1 100 km. With a sedimentary infill of about 10 km in places, the southern DSB is the largest pull-apart basin along the DST and one of the largest pull-apart basins on Earth. The WRR measurements comprised 11 shots recorded by 200 three-component and 400 one-component instruments spaced 300 m to 1.2 km apart along the whole length of the E–W trending profile. Models of the P-wave velocity structure derived from the WRR data show that the sedimentary infill associated with the formation of the southern DSB is about 8.5 km thick beneath the profile. With around an additional 2 km of older sediments, the depth to the seismic basement beneath the southern DSB is about 11 km below sea level beneath the profile. Seismic refraction data from an earlier experiment suggest that the seismic basement continues to deepen to a maximum depth of about 14 km, about 10 km south of the DESIRE profile. In contrast, the interfaces below about 20 km depth, including the top of the lower crust and the Moho, probably show less than 3 km variation in depth beneath the profile as it crosses the southern DSB. Thus the Dead Sea pull-apart basin may be essentially an upper crustal feature with upper crustal extension associated with the left-lateral motion along the DST. The boundary between the upper and lower crust at about 20 km depth might act as a decoupling zone. Below this boundary the two plates move past each other in what is essentially a shearing motion. Thermo-mechanical modelling of the DSB supports such a scenario. As the DESIRE seismic profile crosses the DST about 100 km north of where the DESERT seismic profile crosses the DST, it has been possible to construct a crustal cross-section of the region before the 107 km left-lateral shear on the DST occurred.