ALBERT

Description: An estimate of average river particulate matter (RPM) composition was bàsed on analyses of more than 40 elements in the Amazon, Congo, Ganges, Magdalena, Mekong, Parana and Orinoco rivers, to which were added literature data for 13 other major world rivers, covering the whole spectrum of morphoclimatic features. Geographic variations of major elements in RPM are mostly linked to weathering types and to the balance between weathering rate and river transport. As a result of chemical erosion, Al, Fe and Ti are enriched in RPM with respect to the average parent rock, while Na, Ca, Mg and Sr are strongly depleted. These figures are directly related to the relative importance of dissolved and particulate transport in rivers; this has been computed for each of 40 elements. In order to study weathering on a global scale, the total observed elemental fluxes (dissolved + particulate) have been computed and compared to theoretical ones. The latter were derived from the elemental content in the average parent rock and the total quantity of weathered material, computed from the Al ratio in RPM and in parent rock. Observed and theoretical fluxes are balanced for the less mobilized elements (rare earths, Co, Cr, Cs, Fe, Mn, Rb, Si, Th, Ti, U and V) for which no enrichment relative to Al is noted in RPM, and for B, Ba, Ca, K, Mg, Na, Sr which are relatively depleted in RPM due to their high dissolved transport. Additional fluxes have been found for Br, Sb, Pb, Cu, Mo, Zn and are possible also for Ni and P. This is reflected by marked enrichments in RPM relative to Al for the poorly or moderately dissolved transports (Pb, Cu, Zn). Several hypotheses involving either the natural origin (volcanic dust, marine aerosols, geochemical fractionation) or the artificial origin (worldwide pollution) are discussed to explain these discrepancies, assuming river transport and weathering either to be in a steady state on a global scale or not. However, none of them can fully account for these additional fluxes. It is most likely that these excesses have multiple origins, anthropogenic or natural or both. The comparison between RPM and deep-sea clay compositions emphasizes the prime influence of river input on oceanic sedimentation of Si, Al, Fe, Ti, lanthanides, Sc, Rb, V, etc. A few elements such as Zn, Sb, occur in excess in RPM as compared to deep-sea clays; in order to balance this excess, a remobilization of these elements out of the sediment can be considered. Finally, the enrichment of Co, Cu, Mn and Ni in deep-sea clays compared to RPM is discussed and attributed to several sources and processes.

Description: This chapter discusses the carbon turnover, calcification, and growth in coral reefs. Carbon turnover within a total reef community is a function of two distinct, biochemically interacting cycles. The first is the metabolic cycle consisting of the photosynthetic fixation of CO2 and the release of CO2 by respiration and decomposition processes. Superimposed on this are the direct incorporation of organic compounds (dissolved or particulate; living or non-living) originating outside the reef systems (in the adjacent ocean waters), and the loss of organic compounds from the reef system into the out-flowing water. The second is the inorganic carbonate cycle involving the biological and non-biological precipitation and dissolution of carbonates. Superimposed on this is the loss of particulate carbonates in suspension in the out-flowing water. The main chemical component of a coral-reef system is calcium carbonate, which occurs either as high-Mg calcite, aragonite, or low-Mg calcite. The mean calcification values in various environments at One Tree Reef are presented in the chapter. These data may be converted to an implied vertical growth rate potential assuming that accrual is dominantly aragonite (density = 2.89 g cm–3) and that there is 50% porosity after normal compaction.

Description: Using the fault plane mechanisms of the shallow earthquakes occurring along the Hellenic arc and the extent of the intermediate seismic belt, we make a quantitative estimate of the relative motion occurring between the Hellenic arc and the adjacent sea floor. This estimate is then used to evaluate the deformation in the Aegean area and to reconstruct the pattern of motion over the Eastern Mediterranean region for the last 13 m.y. It is shown that this pattern is compatible with the neotectonic and seismicity studies in Aegea. We then discuss the dynamics of the area and propose that, since Serravallian-Tortonian time, Aegea has been spreading gravitationally in front of the southwestward advancing Turkey. The reasons for this gravitational spreading are discussed.

Description: Data gathered by recent “Islas Orcadas” cruises reveal the seafloor spreading pattern for a region south of the Agulhas/Falkland fracture zone system. The presence of a magnetic anomaly bight about the Agulhas Plateau indicates that the Agulhas Plateau may have developed at the site of a tectonic plate triple junction during the Late Cretaceous. A westward jump in the seafloor spreading center during the Late Maestrichtian (anomaly 34−31) reduced the offset across the Falkland/Agulhas fracture zone system and resulted in the formation of two conjugate aseismic ridges here described as the Meteor and Islas Orcadas Rises. The magnetic lineation pattern in the Agulhas Basin suggests that a tectonic plate (Malvinas Plate) existed during Campanian to Maestrichtian times. Relative rates of motion are calculated for Antarctica, South America, and Africa for the Late Cretaceous.

Description: A bathymetric map of the deep-sea floor off southeastern Africa shows the Agulhas Plateau to be separated from the continental margin of southeastern Africa by a narrow (50 km) elongate depression, the Agulhas Passage, which acts as a deep-water connection between the Agulhas and Transkei basins. Three regionally developed sediment layers occur in the deep (〉 4500 m) Transkei Basin/Agulhas Passage area. With the aid of a simple ocean crust sinking/carbonate compensation level (CCL) model these layers are related to the sedimentation history of the area. The model suggests that acoustic basement (Horizon X) represents Lower Cretaceous limestones draped over oceanic basement, and that this is overlain by an acoustically transparent sequence of pelagic/terrigenous material (Horizon A) that was deposited during a lengthy period (95 m.y.) beneath the carbonate compensation level. Post-Late Miocene sedimentation (Horizons B and C) has probably taken place above the CCL. Local sedimentation has always been influenced by strong sea-floor currents, but since middle Palaeogene times these currents have operated on a regional scale and have generated numerous large ridge and billow-like bed forms.

Description: Goban Spur lies on the continental margin of northwest Europe, southwest of Ireland. It is a marginal plateau underlain by Hercynian granites and Palaeozoic sediments, which form large horsts, grabens and tilted fault blocks with a trend that is approximately parallel to the main Celtic/Armorican Shelf edge. The spur is thought to be a westward continuation of the buoyant Cornubian Ridge, and is bounded to the north and south by large fault lines which probably represent reactivation of Hercynian structural trends. The continental basement is further divided longitudinally into a low-lying outer zone (Intermediate Zone) and a high inner region (Goban Spur proper). The ocean/continent boundary is thought to lie at the outer edge of the Intermediate Zone, Sea-floor spreading anomalies immediately west of the Intermediate Zone suggest that the adjacent ocean crust was created prior to anomaly 33 (say at ca. 90 m.y. B.P.). The sedimentary sequence on Goban Spur can be subdivided into four layers which can be tentatively correlated with the stratigraphic succession on the Meriadzek Terrace (IPOD sites). Such a correlation suggests that the lowermost sediment layer (?Jurassic-Albian) represents a tectono-sedimentary rift infill, and that Layers 2–4 (Upper Cretaceous to Quaternary) were deposited during slow epeirogenic downwarping of the plateau and that the sedimentary processes involved both draping and strong current moulding. The relatively buoyant nature of Inner Goban Spur has inhibited the accumulation of a thick post-rifting sedimentary sequence (700–1000 m), and has shielded the Intermediate Zone from downslope mass movements of material. This has resulted in the accumulation of an anomalously thin post-rift stage outer margin sediment prism (ca. 1000 m) compared to most continent rises (up to 10 km).

Description: Microbial decomposition of organic matter in recent sediments of the Landsort Deep—an anoxic basin of the central Baltic Sea—resulted in the formation of a characteristic assemblage of authigenic mineral precipitates of carbonates, sulfides. phosphates and amorphous silica, The dominant crystalline phases are a mixed Mn-carbonate [(Mn0.85Ca0.10Mg0.05)CO3]. Mn-sulfide [MnS] and Fecarbonate [FeCO3]. Amorphous Fe-sulfide [FeS]. Mn-phosphate [Mn3(PO4)2] and a mixed Fe-Ca-phosphate [(Fe0.86Ca0.14)3(PO4)2] were identified by their chemical compositions only. The variability in composition of these solid phases and their mode of occurrence as a co-existing assemblage constrains the conditions and solution composition from which they precipitated. Estimates of activities for dissolved Fe. Mn. PO4, CO3 and S in equilibrium with such an assemblage are close to those found in recent anoxic interstitial water-sediment systems. It is important to have detailed knowledge of the composition and stability conditions of these solid precipitates in order to refine stoichiometric models of interstitial nutrient regeneration in anoxic sediments.