ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 1365-2486
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Biology , Energy, Environment Protection, Nuclear Power Engineering , Geography
    Notes: The effects of elevated [CO2] on 25 variables describing soybean physiology, growth and yield are reviewed using meta-analytic techniques. This is the first meta-analysis to our knowledge performed on a single crop species and summarizes the effects of 111 studies. These primary studies include numerous soybean growth forms, various stress and experimental treatments, and a range of elevated [CO2] levels (from 450 to 1250 p.p.m.), with a mean of 689 p.p.m. across all studies. Stimulation of soybean leaf CO2 assimilation rate with growth at elevated [CO2] was 39%, despite a 40% decrease in stomatal conductance and a 11% decrease in Rubisco activity. Increased leaf CO2 uptake combined with an 18% stimulation in leaf area to provide a 59% increase in canopy photosynthetic rate. The increase in total dry weight was lower at 37%, and seed yield still lower at 24%. This shows that even in an agronomic species selected for maximum investment in seed, several plant level feedbacks prevent additional investment in reproduction, such that yield fails to reflect fully the increase in whole plant carbon uptake. Large soil containers (〉 9 L) have been considered adequate for assessing plant responses to elevated [CO2]. However, in open-top chamber experiments, soybeans grown in large pots showed a significant threefold smaller stimulation in yield than soybeans grown in the ground. This suggests that conclusions about plant yield based on pot studies, even when using very large containers, are a poor reflection of performance in the absence of any physical restriction on root growth. This review supports a number of current paradigms of plant responses to elevated [CO2]. Namely, stimulation of photosynthesis is greater in plants that fix N and have additional carbohydrate sinks in nodules. This supports the notion that photosynthetic capacity decreases when plants are N-limited, but not when plants have adequate N and sink strength. The root : shoot ratio did not change with growth at elevated [CO2], sustaining the charge that biomass allocation is unaffected by growth at elevated [CO2] when plant size and ontogeny are considered.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1365-2486
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Biology , Energy, Environment Protection, Nuclear Power Engineering , Geography
    Notes: How forests will respond to rising [CO2] in the long term is uncertain, most studies having involved juvenile trees in chambers prior to canopy closure. Poplar free-air CO2 enrichment (Viterbo, Italy) is one of the first experiments to grow a forest from planting through canopy closure to coppice, entirely under open-air conditions using free-air CO2 enrichment technology. Three Populus species: P. alba, P. nigra and P. x euramericana, were grown in three blocks, each containing one control and one treatment plot in which CO2 was elevated to the expected 2050 concentration of 550 ppm. The objective of this study was to estimate gross primary production (GPP) from recorded leaf photosynthetic properties, leaf area index (LAI) and meteorological conditions over the complete 3-year rotation cycle. From the meteorological conditions recorded at 30 min intervals and biweekly measurements of LAI, the microclimate of leaves within the plots was estimated with a radiation transfer and energy balance model. This information was in turn used as input into a canopy microclimate model to determine light and temperature of different leaf classes at 30 min intervals which in turn was used with the steady-state biochemical model of leaf photosynthesis to compute CO2 uptake by the different leaf classes. The parameters of these models were derived from measurements made at regular intervals throughout the coppice cycle. The photosynthetic rates for different leaf classes were summed to obtain canopy photosynthesis, i.e. GPP. The model was run for each species in each plot, so that differences in GPP between species and treatments could be tested statistically. Significant stimulation of GPP driven by elevated [CO2] occurred in all 3 years, and was greatest in the first year (223–251%), but markedly lower in the second (19–24%) and third years (5–19%). Increase in GPP in elevated relative to control plots was highest for P. nigra in 1999 and for P. x euramericana in 2000 and 2001, although in 1999 P. alba had a higher GPP than P. x euramericana. Our analysis attributed the decline in stimulation to canopy closure and not photosynthetic acclimation. Over the 3-year rotation cycle from planting to harvest, the cumulative GPP was 4500, 4960 and 4010 g C m−2 for P. alba, P. nigra and P. x euramericana, respectively, in current [CO2] and 5260, 5800 and 5000 g C m−2 in the elevated [CO2] treatments. The relative changes were consistent with independent measurements of net primary production, determined independently from biomass increments and turnover.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    [s.l.] : Macmillan Magazines Ltd.
    Nature 391 (1998), S. 455-460 
    ISSN: 1476-4687
    Source: Nature Archives 1869 - 2009
    Topics: Biology , Chemistry and Pharmacology , Medicine , Natural Sciences in General , Physics
    Notes: [Auszug] Volado is a new memory mutant of Drosophila. The locus encodes two isoforms of a new α-integrin, a molecule that dynamically mediates cell adhesion and signal transduction. The Volado gene is expressed preferentially in mushroom body cells, which are neurons known to mediate olfactory ...
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    ISSN: 1662-9779
    Source: Scientific.Net: Materials Science & Technology / Trans Tech Publications Archiv 1984-2008
    Topics: Physics
    Notes: BaTiO3 (BT) nanoparticles were prepared by the hydrothermal technique using different starting materials and the microstructure examined by XRD, SEM, TEM and HRTEM. X-ray diffraction and electron diffraction patterns showed that the nanoparticles were the cubic BaTiO3 phase. The BT nanoparticles prepared from the starting materials of as-prepared titanium hydroxide and barium hydroxide have spherical grain morphology, an average size of 65 nm and a fairly narrow size distribution. A uniform diffraction contrast across each single grain is observed in the TEM images, and the clear lattice fringes (with d110 = 0.28 nm) observed in HRTEM images reveal that well-crystallized BT nanoparticles are synthesized by the hydrothermal method. The edges of the particles are very smooth, with no surface steps. BT nanoparticles with average grain size of 90 nm, synthesized using barium hydroxide and titanium dioxide as the starting materials, show surface facets. In this case a bimodal size distribution of large faceted and smaller particles is observed. Diffraction contrast variation across the particles caused by high strains within the particles is clearly observed. The high strains obviously stem from structural defects formed during hydrothermal synthesis, presumable in the form of lattice OH− ions and their compensation by cation vacancies. HRTEM images demonstrate that surface facets parallel to the (100) and (110) planes and small islands with 3 ~ 4 atomic layer thickness are frequently observed around the edge of the particles
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    s.l. ; Stafa-Zurich, Switzerland
    Solid state phenomena Vol. 131-133 (Oct. 2007), p. 393-398 
    ISSN: 1662-9779
    Source: Scientific.Net: Materials Science & Technology / Trans Tech Publications Archiv 1984-2008
    Topics: Physics
    Notes: The thermal donor formation at 425oC - 450oC in Ge doped Czochralski (GCZ) siliconhaving about 1016 cm-3 Ge content pretreated by rapid thermal annealing (RTA) and conventionalfurnace annealing (CFA) has been investigated using low-temperature infrared spectroscopy(LT-IR). The measurements prove that lightly Ge doping can enhance the formation of thermaldouble donors in the initial stage of the low temperature annealing after RTA process. Ge inducedadditional grown-in oxygen precipitates during silicon ingot growth and the abundantself-interstitials during RTA may be the reason for the enhancement. However, after extending theannealing time at the low temperatures, the thermal donor concentration in the GCZ silicon is lowerthan that in the conventional CZ silicon. In final, the mechanism is also discussed
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    s.l. ; Stafa-Zurich, Switzerland
    Key engineering materials Vol. 373-374 (Mar. 2008), p. 268-272 
    ISSN: 1013-9826
    Source: Scientific.Net: Materials Science & Technology / Trans Tech Publications Archiv 1984-2008
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: With excellent wear resistance and corrosion resistance of films, simple procedures, highproduction efficiency and being environmentally friendly, micro-arc oxidation has become a noveltechnique to produce ceramic coatings on the surfaces of light metals such as aluminum and its alloys.In order to decrease the electric power consumption during the process, we put forward a improvedtechnique of micro-arc oxidation, and introduce its technical properties and treatment effects on thesurfaces of aluminum. The experimental results show that the properties, such as phase structure,thickness, roughness and hardness of the ceramic coating prepared by improved micro-arc oxidationare similar to those prepared by traditional micro-arc oxidation. The micro-arc oxidation with higherdeposition efficiency will be an important research direction in the future
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    s.l. ; Stafa-Zurich, Switzerland
    Key engineering materials Vol. 217 (Oct. 2001), p. 77-82 
    ISSN: 1013-9826
    Source: Scientific.Net: Materials Science & Technology / Trans Tech Publications Archiv 1984-2008
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    s.l. ; Stafa-Zurich, Switzerland
    Key engineering materials Vol. 247 (Aug. 2003), p. 19-26 
    ISSN: 1013-9826
    Source: Scientific.Net: Materials Science & Technology / Trans Tech Publications Archiv 1984-2008
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    s.l. ; Stafa-Zurich, Switzerland
    Key engineering materials Vol. 368-372 (Feb. 2008), p. 871-874 
    ISSN: 1013-9826
    Source: Scientific.Net: Materials Science & Technology / Trans Tech Publications Archiv 1984-2008
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: This paper reports the texture development in Si3N4 by strong magnetic field alignment(SMFA), using slip casting of α-Si3N4 raw powder (SN-E10) and pressureless sintering. The texture ofβ-Si3N4 in the green and sintered bodies was characterized by X-ray diffraction analysis (XRD) andscanning electron microscopy (SEM). The a, b-axis and c-axis aligned β-Si3N4 has been obtained by thestatic and rotating magnetic field of 12 T, respectively. The β-seed addition and prolonged sintering bothenhance the texture, but the former is more efficient. This work suggests an efficient SMFA strategy ofproducing highly textured β-Si3N4, particularly the unidirectionally c-axis aligned β-Si3N4 by seeding theα-raw powder using the less-agglomerated β-phase particles
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    s.l. ; Stafa-Zurich, Switzerland
    Materials science forum Vol. 534-536 (Jan. 2007), p. 1009-1012 
    ISSN: 1662-9752
    Source: Scientific.Net: Materials Science & Technology / Trans Tech Publications Archiv 1984-2008
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Recently, textured microstructure has received particular interest in the processing ofadvanced Si3N4 ceramics because of significant improvement in the mechanical properties andthermal conductivity. This work will report a highly textured β-Si3N4 ceramic by aqueous slipcasting in a magnetic field and subsequent pressureless sintering, using commercial α-Si3N4 rawpowder and a mixture of Y2O3 and Al2O3 as sintering aids. To obtain the well-dispersed Si3N4-Y2O3-Al2O3 slurries, polyethylenimine (PEI) was chosen as a dispersant. Effects of the sinteringaids, PEI amount, pH and stirring time on the stability of the Si3N4 slurries were studied. It is shownthat PEI is an effective dispersant for stabilizing the Si3N4-Y2O3-Al2O3 slurries that does not show atime-dependent behavior at an optimum pH ≈ 10, compared to the case in the absence of PEI. Usingthe 30 vol% Si3N4-Y2O3-Al2O3 slurries stabilized with 1.5 dwb% PEI at pH 10, the highly texturedβ-Si3N4 with 97 % relative density could be obtained by slip casting in a magnetic field of 12 T andsubsequent sintering at 1800 oC for 1 h. The textured microstructure is featured by the alignment ofc-axis of β-Si3N4 crystals perpendicular to the magnetic field, and the Lotgering orientation factor, f,is determined to be 0.8
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...