ISSN:
1573-4803
Source:
Springer Online Journal Archives 1860-2000
Topics:
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
Notes:
Abstract Controlled flaws were introduced into poly(methyl methacrylate) samples in the presence of liquid acetone using a Vickers indenter over a range of indentation loads from 100 to 1400 N. Due to the large plastic zone underneath the indenter, the radial crack formed by indentation consisted of two halves, known as Palmqvist cracks, instead of a single semicircular crack. The strengths of the samples were measured in air either immediately following indentation or after a stress-relief anneal. The strength of the as-indented samples was about 6% less than that of the annealed samples; however, the dependence of strength on indentation load was similar for both sets of samples. These results were interpreted in terms of an indentation fracture mechanics model. The analysis is consistent with poly(methyl methacrylate) having a rising fracture toughness with increasing crack size.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/BF01111890
Permalink