ALBERT

Description: Snow models are usually evaluated at sites providing high-quality meteorological data, so that the uncertainty in the meteorological input data can be neglected when assessing model performances. However, high-quality input data are rarely available in mountain areas and, in practical applications, the meteorological forcing used to drive snow models is typically derived from spatial interpolation of the available in situ data or from reanalyses, whose accuracy can be considerably lower. In order to fully characterize the performances of a snow model, the model sensitivity to errors in the input data should be quantified. In this study we test the ability of six snow models to reproduce snow water equivalent, snow density and snow depth when they are forced by meteorological input data with gradually lower accuracy. The SNOWPACK, GEOTOP, HTESSEL, UTOPIA, SMASH and S3M snow models are forced, first, with high-quality measurements performed at the experimental site of Torgnon, located at 2160 m a.s.l. in the Italian Alps (control run). Then, the models are forced by data at gradually lower temporal and/or spatial resolution, obtained by (i) sampling the original Torgnon 30 min time series at 3, 6, and 12 h, (ii) spatially interpolating neighbouring in situ station measurements and (iii) extracting information from GLDAS, ERA5 and ERA-Interim reanalyses at the grid point closest to the Torgnon site. Since the selected models are characterized by different degrees of complexity, from highly sophisticated multi-layer snow models to simple, empirical, single-layer snow schemes, we also discuss the results of these experiments in relation to the model complexity. The results show that, when forced by accurate 30 min resolution weather station data, the single-layer, intermediate-complexity snow models HTESSEL and UTOPIA provide similar skills to the more sophisticated multi-layer model SNOWPACK, and these three models show better agreement with observations and more robust performances over different seasons compared to the lower-complexity models SMASH and S3M. All models forced by 3-hourly data provide similar skills to the control run, while the use of 6- and 12-hourly temporal resolution forcings may lead to a reduction in model performances if the incoming shortwave radiation is not properly represented. The SMASH model generally shows low sensitivity to the temporal degradation of the input data. Spatially interpolated data from neighbouring stations and reanalyses are found to be adequate forcings, provided that temperature and precipitation variables are not affected by large biases over the considered period. However, a simple bias-adjustment technique applied to ERA-Interim temperatures allowed all models to achieve similar performances to the control run. Regardless of their complexity, all models show weaknesses in the representation of the snow density.

Description: The assimilation of satellite-derived soil moisture estimates (soil moisture–data assimilation, SM–DA) into hydrological models has the potential to reduce the uncertainty of streamflow simulations. The improved capacity to monitor the closeness to saturation of small catchments, such as those characterizing the Mediterranean region, can be exploited to enhance flash flood predictions. When compared to other microwave sensors that have been exploited for SM–DA in recent years (e.g. the Advanced SCATterometer – ASCAT), characterized by low spatial/high temporal resolution, the Sentinel 1 (S1) mission provides an excellent opportunity to monitor systematically soil moisture (SM) at high spatial resolution and moderate temporal resolution. The aim of this research was thus to evaluate the impact of S1-based SM–DA for enhancing flash flood predictions of a hydrological model (Continuum) that is currently exploited for civil protection applications in Italy. The analysis was carried out in a representative Mediterranean catchment prone to flash floods, located in north-western Italy, during the time period October 2014–February 2015. It provided some important findings: (i) revealing the potential provided by S1-based SM–DA for improving discharge predictions, especially for higher flows; (ii) suggesting a more appropriate pre-processing technique to be applied to S1 data before the assimilation; and (iii) highlighting that even though high spatial resolution does provide an important contribution in a SM–DA system, the temporal resolution has the most crucial role. S1-derived SM maps are still a relatively new product and, to our knowledge, this is the first work published in an international journal dealing with their assimilation within a hydrological model to improve continuous streamflow simulations and flash flood predictions. Even though the reported results were obtained by analysing a relatively short time period, and thus should be supported by further research activities, we believe this research is timely in order to enhance our understanding of the potential contribution of the S1 data within the SM–DA framework for flash flood risk mitigation.

Description: Since the 1980s, vegetated lands have experienced widespread greening at the global scale. Numerous studies have focused on spatial patterns and mechanisms of this phenomenon, especially in the Arctic and sub-Arctic regions. Greening trends in the European Alps have received less attention, although this region has experienced strong climate and land-use changes during recent decades. We studied the rates and spatial patterns of greening in an inner-alpine region of the Western Alps. We used MODIS-derived normalized difference vegetation index (NDVI) at 8-day temporal and 250 m spatial resolution, for the period 2000–2018, and removed areas with disturbances in order to consider the trends of undisturbed vegetation. The objectives of this study were to (i) quantify trends of greening in a representative area of the Western Alps; and (ii) examine mechanisms and causes of spatial patterns of greening across different plant types. We show that 63% of vegetated areas experienced significant trends during the 2000–2018 period, of which only 8% were negative. We identify (i) a climatic control on spring and autumn phenology with contrasting effects depending on plant type and elevation, and (ii) land-use change dynamics, such as shrub encroachment on abandoned pastures and colonization of new surfaces at high elevation. Below 1500 m, warming temperatures promote incremental greening in the transition from spring to summer, but not in fall, suggesting either photoperiod or water limitation. In the alpine and sub-alpine belts (〉1800 m asl), snow prevents vegetation development until late spring, despite favorable temperatures. Instead, at high elevation greening acts both in summer and autumn. However, photoperiod limitation likely prevents forested ecosystems from fully exploiting warmer autumn conditions. We furthermore illustrate two emblematic cases of prominent greening: recent colonization of previously glaciated/non vegetated areas, as well as shrub/tree encroachment due to the abandonment of agricultural practices. Our results demonstrate the interplay of climate and land-use change in controlling greening dynamics in the Western Alps.

Description: During the autumn of 2011 two catastrophic, very intense rainfall events affected two different parts of the Liguria Region of Italy causing various flash floods. The first occurred in October and the second at the beginning of November. Both the events were characterized by very high rainfall intensities (〉 100 mm h−1) that persisted on a small portion of territory causing local huge rainfall accumulations (〉 400 mm 6 h−1). Two main considerations were made in order to set up this work. The first consideration is that various studies demonstrated that the two events had a similar genesis and similar triggering elements. The second very evident and coarse concern is that two main elements are needed to have a flash flood: a very intense and localized rainfall event and a catchment (or a group of catchments) to be affected. Starting from these assumptions we did the exercise of mixing the two flash flood ingredients by putting the rainfall field of the first event on the main catchment struck by the second event, which has its mouth in the biggest city of the Liguria Region: Genoa. A complete framework was set up to quantitatively carry out a “what if” experiment with the aim of evaluating the possible damages associated with this event. A probabilistic rainfall downscaling model was used to generate possible rainfall scenarios maintaining the main characteristics of the observed rainfall fields while a hydrological model transformed these rainfall scenarios in streamflow scenarios. A subset of streamflow scenarios is then used as input to a 2-D hydraulic model to estimate the hazard maps, and finally a proper methodology is applied for damage estimation. This leads to the estimation of the potential economic losses and of the risk level for the people that stay in the affected area. The results are interesting, surprising and in a way worrying: a rare but not impossible event (it occurred about 50 km away from Genoa) would have caused huge damages estimated between 120 and EUR 230 million for the affected part of the city of Genoa, Italy, and more than 17 000 potentially affected people.

Description: State-of-the-art rainfall products obtained by satellites are often the only way of measuring rainfall in remote areas of the world. However, it is well known that they may fail in properly reproducing the amount of precipitation reaching the ground, which is of paramount importance for hydrological applications. To address this issue, an integration between satellite rainfall and soil moisture SM products is proposed here by using an algorithm, SM2RAIN, which estimates rainfall from SM observations. A nudging scheme is used for integrating SM-derived and state-of-the-art rainfall products. Two satellite rainfall products are considered: H05 provided by EUMESAT and the real-time (3B42-RT) TMPA product provided by NASA. The rainfall dataset obtained through SM2RAIN, SM2RASC, considers SM retrievals from the Advanced Scatterometer (ASCAT). The rainfall datasets are compared with quality-checked daily rainfall observations throughout the Italian territory in the period 2010–13. In the validation period 2012–13, the integrated products show improved performances in terms of correlation with an increase in median values, for 5-day rainfall accumulations, of 26% (18%) when SM2RASC is integrated with the H05 (3B42-RT) product. Also, the median root-mean-square error of the integrated products is reduced by 18% and 17% with respect to H05 and 3B42-RT, respectively. The integration of the products is found to improve the threat score for medium–high rainfall accumulations. Since SM2RASC, H05, and 3B42-RT datasets are provided in near–real time, their integration might provide more reliable rainfall products for operational applications, for example, for flood and landslide early warning systems.

Description: Information on snow properties is of critical relevance for a wide range of scientific studies and operational applications, mainly for hydrological purposes. However, the ground-based monitoring of snow dynamics is a challenging task, especially over complex topography and under harsh environmental conditions. Remote sensing is a powerful resource providing snow observations at a large scale. This study addresses the potential of using Sentinel-2 high-resolution imagery to assess moderate-resolution snow products, namely H10—Snow detection (SN-OBS-1) and H12—Effective snow cover (SN-OBS-3) supplied by the Satellite Application Facility on Support to Operational Hydrology and Water Management (H-SAF) project of the European Organisation for the Exploitation of Meteorological Satellites (EUMETSAT). With the aim of investigating the reliability of reference data, the consistency of Sentinel-2 observations is evaluated against both in-situ snow measurements and webcam digital imagery. The study area encompasses three different regions, located in Finland, the Italian Alps and Turkey, to comprehensively analyze the selected satellite products over both mountainous and flat areas having different snow seasonality. The results over the winter seasons 2016/17 and 2017/18 show a satisfying agreement between Sentinel-2 data and ground-based observations, both in terms of snow extent and fractional snow cover. H-SAF products prove to be consistent with the high-resolution imagery, especially over flat areas. Indeed, while vegetation only slightly affects the detection of snow cover, the complex topography more strongly impacts product performances.

Description: The accuracy of hydrological predictions in snow-dominated regions deeply depends on the quality of the snowpack simulations, whose dynamics strongly affects the local hydrological regime, especially during the melting period. With the aim of reducing the modelling uncertainty, data assimilation techniques are increasingly being implemented for operational purposes. This study aims at investigating the performance of a multivariate Sequential Importance Resampling – Particle Filter scheme designed to jointly assimilate several ground-based snow observations. The system, which relies on a multilayer energy-balance snow model, has been tested at three Alpine sites: Col de Porte (France), Torgnon (Italy), and Weissfluhjoch (Switzerland). The implementation of a multivariate data assimilation scheme faces several challenging issues, which are here addressed and extensively discussed: (1) the effectiveness of the perturbation of the meteorological forcing data in preventing the sample impoverishment; (2) the impact of the parameters resampling on the filter updating of the snowpack state; (3) the system sensitivity to the frequency of the assimilated observations.

Description: The accuracy of hydrological predictions in snow-dominated regions deeply depends on the quality of the snowpack simulations, with dynamics that strongly affect the local hydrological regime, especially during the melting period. With the aim of reducing the modelling uncertainty, data assimilation techniques are increasingly being implemented for operational purposes. This study aims to investigate the performance of a multivariate sequential importance resampling – particle filter scheme, designed to jointly assimilate several ground-based snow observations. The system, which relies on a multilayer energy-balance snow model, has been tested at three Alpine sites: Col de Porte (France), Torgnon (Italy), and Weissfluhjoch (Switzerland). The implementation of a multivariate data assimilation scheme faces several challenging issues, which are here addressed and extensively discussed: (1) the effectiveness of the perturbation of the meteorological forcing data in preventing the sample impoverishment; (2) the impact of the parameter perturbation on the filter updating of the snowpack state; the system sensitivity to (3) the frequency of the assimilated observations, and (4) the ensemble size.The perturbation of the meteorological forcing data generally turns out to be insufficient for preventing the sample impoverishment of the particle sample, which is highly limited when jointly perturbating key model parameters. However, the parameter perturbation sharpens the system sensitivity to the frequency of the assimilated observations, which can be successfully relaxed by introducing indirectly estimated information on snow-mass-related variables. The ensemble size is found not to greatly impact the filter performance in this point-scale application.