ALBERT

Description: Airborne measurements of trace gas and aerosol species were obtained in the lower troposphere (less than 5 km) over the western Atlantic Ocean between 13 deg S and 40 deg N during the August/September 1990 NASA Chemical Instrument Test and Evaluation (CITE 3) experiment. The largest background O3 mixing ratios, averaging 35 and 70 ppbv within the mixed layer (ML) and free troposphere (FT; altitudes greater than 2.4 km), respectively, were found over the tropical South Atlantic. Several competing processes were observed to regulate O3 budgets in this region. Within the ML, rapid photochemical destruction produced a diurnal O3 variation of 8 ppbv and an O3/altitude gradient between the surface and 5 km of almost 10 ppbv (O3)/km. ML O3 concentrations were replenished by atmospheric downwelling which occurred at rates of up to and exceeding 1 cm/s. Ozone values within the subsiding FT air were enriched both by long-range transport of O3 produced photochemically within biomass combustion plumes and the downward propagation of dry, upper tropospheric air masses. Overall, the tropospheric O3 column below 3.3 km averaged 13.5 Dobson units (DU) over the South Atlantic region, which is 8-9 DU higher than observed during CITE 3 ferry flights over the northern tropical Atlantic Ocean or measured by ozonesondes over coastal Brazil during the wet season. An examination of simultaneous dew point and combustion tracer (e.g., CO) measurements suggests that the dry subsiding layers and biomass burning layers make approximately equal contributions to the observed O3 enhancement.

Description: Aircraft measurements of selected trace gas species, aerosols, and meteorological parameters were performed in the lower troposphere off the U.S. east coast during August and September 1989 as part of the NASA Global Tropospheric Experiment (GTE) Chemical Instrumentation Test and Evaluation (CITE 3) expedition. In this paper, we examine these data to assess the impact of continental outflow on western Atlantic O3 and small aerosol budgets. Results show that mixed layer (ML) O3 concentrations and small aerosol number densities (Np) were enhanced by factors of 3 and 6, respectively, within air masses of predominantly continental origin compared with clean maritime background air. These enhancements exhibited a marked altitude dependence, declining rapidly above the ML to the point where only slight to moderate differences in O3 and Np, respectively, were notable above 2.4 km. Within continentally influenced ML's, both O3 and Np were correlated with CO, exhibiting linear regression slopes averaging 0.4 ppbv (O3)/ppbv(CO) for O3 and 7.7 (particles/cc)/ppbv(CO) for Np and indicating a primarily anthropogenic origin for the observed enhancement of these species. Comparisons between profiles in continental and background maritime air masses suggest that photochemical production below 1.4-km altitude adds over 10% to western Atlantic tropospheric column O3 abundance in continental outflow regimes. For aerosols, eastward advection of low-level continental air contributes an average net flux of 2.8 metric tons of submicron (accumulation mode) particles per kilometer of shoreline per day to the western Atlantic troposphere.

Description: We report in situ stratospheric measurements of CH4, N2O, and O3 obtained aboard the NASA DC-8 during the January-March 1992 Airborne Arctic Stratospheric Expedition 2 field campaign. These data demonstrate a strong linear correlation between N2O and CH4 in the lower stratosphere thus indicating that both species are effective tracers of stratospheric air motion. Measurements of both species on constant geometric height surfaces indicate that significant subsidence of the arctic stratospheric air mass occurred at DC-8 altitudes over the course of the AASE-2 expedition. In addition, a widespread reduction in O3 mixing ratios (up to 20%) relative to these conserved tracers was also observed in the lower stratosphere in March as compared to January and February results.

Description: During all eight flights conducted over the equatorial and tropical South Atlantic in the course of the Chemical Instrumentation Test and Evaluation (CITE 3) experiment, we observed haze layers with elevated concentrations of aerosols, O3, CO, and other trace gases related to biomass burning emissions. They occurred at altitudes between 1000 and 5200 m and were usually only some 100-300 m thick. These layers extended horizontally over several 100 km and were marked by the presence of visible brownish haze. Air mass trajectories indicate that these layers originate in the biomass burning regions of Africa and South America and typically have aged at least 10 days since the time of emission. In the haze layers, O3 and CO concentrations up to 90 and 210 ppb were observed, respectively. The two species were highly correlated. The ratio concentrations in plume minus background concentrations of O3/CO is typically in the range 0.2-0.7, much higher than the ratios in the less aged plumes investigated previously in Amazonia. In most cases, aerosol (0.12-3 micrometer diameter) number concentrations were also elevated by up to 400/cu cm in the layers; aerosol enrichments were also strongly correlated with elevated CO levels. Clear correlations between CO and NO(x) enrichments were not apparent due to the age of the plumes, in which most NO(x) would have already reacted away within 1-2 days. Only in some of the plumes could clear correlations between NO(y) and CO be identified; the absence of a general correlation between NO(y) and CO may be due to instrumental limitations and to variable sinks for NO(y). The average enrichment of the ratio concentrations in plume minus background concentrations of NO(y)/CO was quite high, consistent with the efficient production of ozone observed in the plumes. The chemical characteristics of the haze layers, together with remote sensing information and trajectory calculations, suggest that fire emissions (in Africa and/or South America) are the primary source of the haze layer components.

Description: Several criteria that may be used to evaluate the merits of some of the existing techniques for the dynamic analysis of large structures which involve division into substructures or components are examined. These techniques make use of component displacement modes to synthetize global systems of generalized coordinates and, for that reason, they have come to be known as modal synthesis or component mode methods. Two techniques have been found to be particularly useful - i.e., the modal synthesis method with fixed attachment modes, and the modal synthesis method with free attachment modes. These two methods are treated in detail, and general flow charts are presented for guidance in computer programming.

Description: A theory is developed to predict eigenvalue and eigenvector uncertainty in large dynamic models. The uncertainty is based on physical property uncertainty and should not be confused with numerical roundoff, although the method can be extended to include the latter. The theory, when implemented on a computer, is used to analyze the uncertainties in frequencies and mode shapes based on uncertainties in mass, stiffness, modulus of elasticity, etc. The method incorporates a linear statistical model which is quite adequate for handling property uncertainties of 10% or more. The model is not limited to small systems but uses certain statistical assumptions as well as selective matrix manipulations to keep the size of all matrix operations to within the number of degrees of freedom of the system. Examples are given for two longitudinal vibration problems, and the results are supported by a Monte Carlo analysis.

Description: Several modal synthesis procedures for the dynamic analysis of largy composite structural systems are surveyed. The matrix formulation of the free-free modal synthesis procedures is presented. Also given are schematic flow charts of the analysis procedure used in three prominent methods. The advantages and disadvantages of several modal synthesis methods for different classes of structural problems are presented in order to enable the engineer to select the best procedure for his particular type of problem.

Description: The results of research in applying statistical methods to the problem of structural dynamic system identification are presented. The study is in three parts: a review of previous approaches by other researchers, a development of various linear estimators which might find application, and the design and development of a computer program which uses a Bayesian estimator. The method is tried on two models and is successful where the predicted stiffness matrix is a proper model, e.g., a bending beam is represented by a bending model. Difficulties are encountered when the model concept varies. There is also evidence that nonlinearity must be handled properly to speed the convergence.

Description: Computer program for predicting structural bending vibrational data

Description: Several methods are presented for developing proportional substructure damping matrices from modal test data. Examples demonstrate the significance of the nonuniqueness of the resulting proportional damping matrices. Several alternate modal synthesis procedures are presented for the systematic calculation of system modal damping from substructure damping information. The relative merits of these procedures are discussed, and one procedure is recommended.