ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Publication Date: 2017-04-04
    Description: The oxidation state of iron in hydrous ultrapotassic (phono-tephritic) melts coexisting with mixed H2O-CO2 fluids was experimentally studied at 1200 and 1250{degree sign}C and pressures from 50 to 500 MPa. The oxygen fugacity (fO2) varied from NNO-2.9 to NNO+2.6 in logfO2, relative to the Ni-NiO oxygen buffer (NNO), as imposed by external redox conditions in experimental vessels and internal variations in water activity from 0.05 to 1 inside the capsules. The iron redox state of the quenched melts was determined by colorimetric wet-chemical analysis. This analytical method was optimized to measure the Fe2+/ΣFe ratio of mg-sized samples within ±0.03 (2σ). The accuracy and precision was tested with international reference materials and with standards analyzed by other methods. The Fe2+/ΣFe ratio of the experimental glasses covered a range of 0.41 to 0.85. A small negative effect of dissolved water on Fe2+/ΣFe at given fO2 was found, consistent with the thermodynamic model of Moretti (2005). No effect of pressure and temperature on the redox state of iron was resolvable in the investigated P-T range. Compared to hydrous ferrobasaltic melts that were studied previously under similar conditions, systematically lower Fe2+/ΣFe ratios were found for the phono-tephritic melts, in particular at low oxygen fugacities. This effect is attributed to the much higher K2O contents of the phono-tephrite (7.5 compared to 0.3 wt%), but the difference in ΣFeO (7.8 wt% in the phono-tephrite and 12.9 wt% in the ferrobasalt) may have an influence as well. Comparison of the experimentally obtained relationship between logfO2 and Fe3+/Fe2+ for the studied hydrous ultrapotassic melts with commonly used empirical and thermodynamic models suggest that these models can be successfully applied to phono-tephritc melts, although such compositions were not implemented in the model calibrations. Furthermore, the new data can be used to improve the models with respect to the effects of compositional variables, such as H2O or K2O, on the redox state of iron in silicate melts.
    Description: Published
    Description: 1493-1504
    Description: 2.3. TTC - Laboratori di chimica e fisica delle rocce
    Description: JCR Journal
    Description: open
    Keywords: iron oxidation state, ferrous iron determination, oxygen fugacity, phono-tephrite, ultrapotassic hydrous silicate melt, Alban Hills, water activity ; 04. Solid Earth::04.04. Geology::04.04.05. Mineralogy and petrology
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Publication Date: 2019-11-04
    Description: The effect of pressure, temperature, and melt composition on CO2 and H2O solubilities in aluminosilicate melts, coexisting with CO2-H2O fluids, is discussed on the basis of previously published and new experimental data. The datasets have been chosen so that CO2 and H2O are the main fluid components and the conclusions are only valid for relatively oxidizing conditions. The most important parameters controlling the solubilities of H2O and CO2 are pressure and composition of melt and fluid. On the other hand, the effect of temperature on volatile solubilities is relatively small. At pressures up to 200 MPa, intermediate compositions such as dacite, in which both molecular CO2 and carbonate species can be dissolved, show higher volatile solubilities than rhyolite and basalt. At higher pressures (0.5 to 1 GPa), basaltic melts can incorporate higher amounts of carbon dioxide (by a factor of 2 to 3) than rhyolitic and dacitic melts. Henrian behavior is observed only for CO2 solubility in equilibrium with H2O-CO2 fluids at pressures 〈100 MPa, whereas at higher pressures CO2 solubility varies nonlinearly with CO2 fugacity. The positive deviation from linearity with almost constant CO2 solubility at low water activity indicates that dissolved water strongly enhances the solubility of CO2. Water always shows non-Henrian solubility behavior because of its complex dissolution mechanism (incorporation of OH-groups and H2O molecules in the melt). The model of Newman and Lowenstern (2002), in which ideal mixing between volatiles in both fluid and melt phases is assumed, reproduces adequately the experimental data for rhyolitic and basaltic compositions at pressures below 200 MPa but shows noticeable disagreement at higher pressures, especially for basalt. The empirical model of Liu et al. (2004) is applicable to rhyolitic melts in a wide range of pressure (0-500 MPa) and temperature (700- 1200°C) but cannot be used for other melt compositions. The thermodynamic approach of Papale (1999) allows to calculate the effect of melt composition on volatile solubilities but needs an update to account for more recent experimental data. A disadvantage of this model is that it is not available as a program code. The review indicates a crucial need of new experimental data for scarcely investigated field of pressures and fluid compositions and new models describing evident non-ideality of H-C-O fluid solubility in silicate melts at high pressures.
    Description: Published
    Description: JCR Journal
    Description: open
    Keywords: CO2 ; H2O ; solubility ; mixed fluid ; silicate melt ; experimental data ; 04. Solid Earth::04.08. Volcanology::04.08.01. Gases ; 04. Solid Earth::04.08. Volcanology::04.08.03. Magmas
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Format: 779665 bytes
    Format: application/pdf
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...